12. An aquarium 8 m long, 4 m wide, and 4 m deep is full of water. Water density = 1000 kg/m3 Find the following: A) The hydrostatic pressure on the bottom of the aquarium. B) The hydrostatic force on the bottom of the aquarium. C) The hydrostatic force on one end of the aquarium.

12. An aquarium 8 m long, 4 m wide, and 4 m deep is full of water. Water density = 1000 kg/m3 Find the following: A) The hydrostatic pressure on the bottom of the aquarium. B) The hydrostatic force on the bottom of the aquarium. C) The hydrostatic force on one end of the aquarium.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter35: Comfort And Psychrometrics

Section: Chapter Questions

Problem 13RQ: A house has 3500ft2 of floor space and a 9-ft ceiling. What is the cubic volume of the house?

See similar textbooks

Related questions

Q: A piston-cylinder device contains 50 kg of water at 150 kPa and 25°C. The cross sectional area of th...

Q: Calculate the enthalpy, volume and entropy of 2 kg of steam at a pressure of 1.9 MPa having the dryn...

A: We must determine the enthalpy, volume, and entropy of 2kg of steam at 1.9 MPa pressure and a drynes...

Q: a. Where will the ball be 1.2 seconds after it is kicked? b. What will be the greatest height reache...

A: Given- Initial velocity- 35m/s Angle- 25deg

Q: Review the evaluation of the Navy lowperformer program discussed in the chapter.Redesign the program...

A: The Navy's low-performer research was defective because there were too few participants, and th...

Q: 1 Draw shear and moment diagram. Det. max. V and max. M 2. Draw loading and moment diagram given the...

Q: Hello, I have some diagrams I have filled out for practice that I would like to use to study for an ...

A: In diagram 1 alll your answers are correct.

Q: 4. Consider a batch process of the conveyor oven illustrated in Figure 1. List all input and output ...

A: The PLC gets data from associated sensors or info gadgets, processes the information, and triggers y...

Q: A one-dimensional plane wall is exposed to convective and radiative conditions at x = 0. The ambient...

Q: *6-12. Determine the force in each member of the truss and state if the members are in tension or co...

Q: A fluid at 20°C has a viscosity of 0.007 Poise. What shear stress in Pa is required to deform this f...

A: Given: strain rate = 294000/min Viscosity = 0.007 poise

Q: sticity and the modulus of resilience. o (ksi) € (in. /in.)

Q: 5. Dak Prescott has a mass of 107 kg and is 25 years old. Calculate the total moment of inertia for ...

Q: the side of a pickup bed and facilitates the handling of heavy loads. When the boom elevation angle ...

Q: Task I. Draw the shearing force and bending moment diagrams for the beams shown in Figs. (1-3). Task...

Q: diameter, and the distance from the center of the rudder stock to centerline of rams is 800 mm. Calc...

Q: Problem 22 Situation: A water tower has a storage tank whose shape can be considered equivalent to a...

A: The kinematic thickness is characterized as the outright consistency of a fluid separated by its thi...

Q: Calculate the enthalpy, volume and entropy of 2 kg of steam at a pressure of 1.9 MPa having the dryn...

Q: an engine burns a liter of fuel each 12 minytes, the fuel has specific gravity os 0.8 and heating va...

Q: Determine the dynamic viscosity (Pa-sec) and kinematic viscosi ty (m2/s) of vater with a specific we...

Q: 48. Water is flowing in a smooth pipe of diameter D. A section of this pipe hav- ing a length of L i...

A: Given: length of the pipe=L and diameter of the pipe=D. And turbulent flow is there.

Q: 3) f(t)= (t+1) sin (t+2)= + sinltt2) + sint +2) ssin(2)+ 1. Cose) s sin(2) +1- COnd Lif+)} = (4) d d...

Q: check the equilibrium conditions For the following system F 400 lb fied ? Tina ation:- 30 = 300 lb -...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: Read the question carefully and give me right solution with clear calculations. A cantilever beam o...

Q: Q1/A pressune drop of 7o0 Kpa is measurd over 3com of horizantal, lorm diameter wrought iron pipe th...

Q: Find the centroid for the shaded ?.area shown in fig

Q: A two cascade refrigeration system uses ammonia as the refrigerant. the mass flow rate in the high p...

Q: A 254 mm x 357 mm twin cyclinder, 4 stroke engine operates with an indicated heat efficiency pressur...

A: Answer: The friction power is 3.52 kW.

Q: Assume 20 lbm of an ideal gas with R=50 ft-lb/lb-R and k=1.18 are heated from 75 to 200F. What is th...

Q: Two boilers one with superheater and anothar without superheater are delivering equal quantities of ...

A: We know that two boilers, one with a superheater and the other without, are delivering the same amou...

Q: From the given beam, determine the moment at point B. The unit for Force is in Newton(N) and Length ...

A: For different beam supports reaction loads 1. Roller : Vertical Force 2. Hinge : Vertical Force, Hor...

Q: A hollow cylinder and a solid cylinder have the same diameter. Determine which has the greater momen...

Q: WHAT IS THE RESULTING PRESSURE IN PSIA WHEN ONE POUND OF AIR IS AT 15 PSIA AND 200°F IS HEATED AT CO...

Q: Steam enters a 1.6-cm-diameter pipe at 80 bar and 600°C with a velocity of 150 m/s. Determine the ma...

Q: If the value of alpha is 30 degrees calculate the moment of F about the center O of the bolt. F = 12...

Q: 4. The angular velocity of a rotating disk with a radius of 4 m decreases from 6 rads per second to ...

Q: Problem 3.20 Hollow shaft with D = 50 mm and d = 46 mm of L = 1m and G 83 GPa (steel). If the shaft ...

Q: carefully and answer with complete solution and units.Use the steam tables provided and use 4 decima...

Q: Q13. As shown in the image below, ball A and ball B are approaching each other, and they have a mass...

Q: A uniform ladder 18 ft long and weighing 120 lbs rests against a smooth wall. The angle between the ...

Q: Hello, I have some diagrams I have filled out for practice that I would like to use to study for an ...

Q: - 540 mm 180 mm- 180 mm 60 mm → - B 30 kN

Q: weight concentrated at the end of a cord forms a conical pendulum for which the period is 1.250 sec....

Q: 2) A heat pump with the amount of heat of liquid refrigerant (mix) when it will enter the expansion ...

A: Answer: The coefficient of performance of the heat pump is 0.575.

Q: A Circular jet deluers water at a rate of 6ol/s with a velocity of 24 mls, the jet impinges tangenti...

A: Given data, Volume flow rate of water jet, Q = 0.06 m3/s Velocity of jet at the inlet, V1 = 24 m/s V...

Q: Collar A starts from rest at t= 0 and moves upward with a constant acceleration of 3.6 in/s?. Collar...

Q: Compression is isothermal. Determine the work in kW

A: Determine the work in kW

Q: A reciprocating compressor draws in 500 cubic feet per minute of air whose density is 0.079 lb/cu ft...

A: Answer: (a) The work done on the air is 2384.40 Btu/min. (b) The work done on the air is 56.24 hp. ...

Q: The 0.5 m x 1.2 m wall of an industrial furnace is constructed from L = 0.15-m-thick fireclay brick ...

Q: In the clevis determine the minimum bolt diameter and the minimum thickness of ea yoke that will sup...

Q: Using the Method of Joints, For the lightweight truss which is loaded as shown 10 kN 5 kN -6m 6 m A ...

Concept explainers

Forms of Energy

Energy is described as the capability to accomplish a task, like the ability to push a block by applying force on it. It is a quantitative property that is used to accomplish work on an object.

Question

12. An aquarium 8 m long, 4 m wide, and 4 m deep is full of water. Water density = 1000
kg/m3
Find the following:
A) The hydrostatic pressure on the bottom of the aquarium.
B) The hydrostatic force on the bottom of the aquarium.
C) The hydrostatic force on one end of the aquarium.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A house has an area of 195 m^2. What is its area in: dm^2
A ship with vertical sides near the water line, weighs 40 MN and draws 6.7 m in salt water (specific gravity = 1.026). Discharge of 2 MN of water ballast decreases the draft to 6.4 m. What would be the draft d of the ship in fresh water?
1. A reservoir of glycerin has a mass of 1,200 kg and a volume of 0.952 cu.m. Find its (a) weight (b) unit weight (c) mass density (d) specific gravity.
An atmospheric pressure of 101.325 kPa will be supported by how much height of the water? a. 10.32 m b. 15.42 m c. 13.23 m d. 15.45 m
The ice at a certain hockey rink is made by freezing water that is 1.5 inch deep. How many gallons of water does it take? Approximate the rink as a 100 ft. by 85 ft. rectangle. hint: 1 gal = 231 cubic inches and 1 ft = 12 inches
A rectangular barge (with a flat bottom) and its cargo weigh 90,000 N. The barge measures 10 m long x 3 m wide x 1 m high. How much of the barge (height of its side) can be seen above the water line when it is floating?
If a pool is irregularly shaped and a person being assessed has a weight mg= 800 N but weighs Fn= 40N while submerged. Assuming a residual volume Vres= 1.4 L= 0.0014 m^3. a. What is their average density b. What percentage of their body volume would be above water, while floating? c. What is their bodys volume d. How much more buoyant force would they experience with their lungs holding a full six liters? What percentage of thheir body volume would be above water now?
A house has 3500ft2 of floor space and a 9-ft ceiling. What is the cubic volume of the house?
A fluid has a mass of 1500 kg and a volume of 1.85 cubic meter. a.) What is the specific gravity of the fluid ? b.) What is the unit weight of the fluid?
A body of dimension 2.0m x 1.0m x 3.0m weighs 3924 N in water. Find its specific gravity.
The average flow for the Mississippi River is approximately 1,500 cfs. It is assumed that one-fourth of this flow would be available to develop power at a dam shown below. a). what would be the annual energy in kilowatt-hours that would be produced with an overall average of 88% efficiency? b), What would the pressure P in psi?
The pressure 10 ft below the free surface of a liquid is 6.51 inHg. What is the specific gravity of the liquid?