120 R40 5 30 + 30 40 30 030 40 18 60 50 -120 15 51 20 R60 70 100 040 20 50 100 30 70 30

Q: Determine the flexural capacity of the given section of beam below. b=260 d=380 d'=80 fc'=27 fy=415…

A:

Q: Draw neat sketches of the following and label them. A. Barometer B. Differential U-tube manometer C.…

A:

Q: Find The deflection at point, A totsN Find AcH₂OE, AFH C 1 for the Frame 30 MN shown below by unit…

A: Horizontal deflection and vertical deflection at A is zero due to hinge support.

Q: Q1/For the 5.0m cantilever beam shown below, calculate the immediate deflection due to dead load. In…

A:

Q: A small projectile is fired vertically downward into a fluid medium with an initial velocity of 60…

A: step 1-

Q: A simple torsion-bar spring is shown. The shear stress in the steel [G = 11,500 ksi] shaft is not to…

A:

Q: The hydraulic gradient for quicksand condition is equal to 1.27 with a void ratio of 0.46. The moist…

A:

Q: A consolidated-undrained test on a normally consolidate clay yield the following results: Confining…

A: To Determine Consolidated drained friction angle Φ'

Q: A machine costs of P 8,000 and an estimated life of 10 years with a salvage value of P 500. What is…

A: Given: Original cost  Estimated life  Salvage value  To find: Book value after 8 years

Q: SITUATION. On a frictionless, horizontal air track, a glider oscillates at the end of an ideal…

A: Answer We can write down the given data from the acceleration graph Maximum acceleration amax = 12…

Q: Calculate the void ratio of a soil sample having porosity of 0.32 and a moisture content of 25%.

A: given- porosity n=0.32moisture content w=25%=0.25

Q: A square column foundation with base of 1.50 m is shown in the figure. It carries an axial load of…

A:

Q: A column 300 x 300 mm supports a dead load of 948 kN and a live load of 744 kN. The allowable soil…

A: Given data:- Size of column is 300 mm × 300 mm Dead load on column = 948 kN Live load on column =…

Q: Determine the magnitude (lb) of the reaction at B when a = 21°, a = 11.4 in, b = 14.96 in, y = 16.62…

A:

Q: e turbine is r e wheel and d

A:

Q: Two forces, F, and F act on the pipe assembly at point 4 as shown in the figure below. (a) Write an…

A: step 1-

Q: w kN/m A L/3 ↓ L/3 ↓ L/3 A 9m long simply supported beam shown above, is subjected to a 4 kN/m…

A:

Q: A moist soil sample having a volume of 1.09 m³ has a total mass of 2,361 kg. Specific gravity of…

A:

Q: A consolidated-undrained test on a normally consolidate clay yield the following results: Confining…

A:

Q: Calculate the number of bars required in one direction.

A:

Q: Determine the maximum moment at C, in kN-m. O 67.5 kN.m O 70 KN-m O 75 kN.m O 82.5 kN.m

A:

Q: 10. A 100 m long earthwork volume for a proposed highway has a constant cross section of cut and…

A:

Q: SITUATION. A 4-m long beam is fixed at the left end and is supported by a spring at the right end.…

A:

Q: s total load of 25 -12x1016/0°C

A:

Q: Q2/ For the 60m simply supported beam having fc-30MPa and fy-420MP, calculate the immediate…

A:

Q: Question 13 of 15 0/5 E The 27-N force P is applied perpendicular to the portion BC of the bent…

A: Free-body diagrams represent the relative magnitude and direction of all forces acting upon an…

Q: Problem Set #2 - FRICTION 6 cm MN Newton P=0.3 3 cm Required: 1. The minimum value of s if you…

A:

Q: indicate the final answer in 3 decimal places.

A:

Q: √²₁ 2x+2y dy dx

A:

Q: For the beam shown, the magnitude of the distributed load is wo= 10.6 kN/m and the beam lengths are…

A:

Q: A beam 300 mm wide x 450 m deep is simply supported on a span of 6.8 m. Given: Superimposed…

A:

Q: Two tanks are connected with the three pipes of length 2 m, 3 m, and 4 m and diameters 20 cm, 30…

A: Asked: To determine the equivalent diameter for the given pipes.   Given: Pipe 1: Length (L1) = 2 m…

Q: The water flows fully through the rectangular channel of lateral dimensions 4 m x 3 m. What is the…

A: given reactangular channel dimension=4 m×3 mslope S=0.0006Chezy's constant C=90

Q: A 4 hr. unit hydrograph of a basin can be approximated as a triangle with a base period of 48 h and…

A: Given data- 4 hr unit hydrograph-base period B=48 hPeak ordinate Qpeak=200 m3/sTo Find-The area of…

Q: A normally consolidated clay layer 3.48 m. thick has a void ratio of 1.08. Liquid limit is equal to…

A:

Q: X A A=100 0.8 (A<=16) (A<=64) Find the value for ka when( A<=16) and (A<=64) using the linear…

A: The given data is shown below:

Q: MA = 70 kN·m, w = 20 kN/m, MB = 44 kN·m.  Label all significant points on each diagram and identify…

A:

Q: The hydraulic gradient for quicksand condition is equal to 1.27 with a void ratio of 0.40. The moist…

A:

Q: 10. Determine the cross-section of a rectangular beam loaded as shown in the figure if the allowable…

A: Given data in question  UDL Point load Span member length  Rectangular cross section To find out…

Q: A vertical retaining wall 8.8 meters high retains a horizontal backfill having the following…

A: Given: Height of wall  Void ratio Specific gravity  Water content  Angle of friction  Location of…

Q: In the water flow over the spillway, the velocity is uniform at sections 1 and 2 and the pressure…

A:

Q: Determine radius of mohr circle 9 MPa 4 MPa 6 MPa

A:

Q: The calculations in differential leveling works are limited only to determining the heights of the…

A: Given data in question  Differential levelling work To find out  Statement above is True or False.

Q: A water tank has the form of a frustum of a cone with diameters of 2 m at the bottom, 3 m at the top…

A:

Q: Q3 Block A movies on a roller along inclined surface and Connected to Block B by a link. Determine…

A:

Q: A moist soil sample having a volume of 1.01 m³ has a total mass of 2,342 kg. Specific gravity of…

A:

Q: tory system so that blood detours, through the vein, around an occluded coronary artery segment. Why…

A: Endoscopic vein harvesting is commonly used to extract the saphenous vein. A heart-lung machine is…

Q: Determine the magnitude (lb) of the reaction at B when a = 21°, a 11.4 in, b = 14.96 in, y = 16.62…

A:

Q: A 1.20 m-diameter(internal) horizontal steel penstock conveys water at the rate of 3.6 m3/s. The…

A: Given, D = 1.2 m Q = 3.6 m3/s K = 2.2 GPa or 2.2 x 109 Pa E = 200 GPa or 2 x 1011 Pa

Q: Use the graphical method to construct the shear-force and bending-moment diagrams for the beam…

A: L = 9m