120 Tunee #2 Encontrar la potencia t 1K 2K Ń LK 3K 3K < 1K 4K en TIT la carga Ke 5K R₁ TIT

Q: Given the active filter shown below, answer the following questions: (a) Find the transfer function…

A:

Q: The closed-loop speed control of a direct current motor is shown in the block diagram below. Step…

A: The forward path transfer function of a unity negative feedback sysetm isWe need to design a PI…

Q: determine the load impedance.

A:

Q: G(s) = s + 100 s3 +25s² + 150s + 15

A:

Q: Question 8 The finite-duration sequence x [n] shown below is the input to a linear time-invariant…

A: Given:Linear Time-Invariant SystemThe impulse response of the system = h[n]Input to the system…

Q: 4- Superposition theorem is not applicable for a- Voltage calculations 5- حسابات القدره c-Power…

A: given here 2 questions and asked to find the correct answers.

Q: 20v Tunes #2 Encontrar la pitencia en la carga R 1 t 1K 2K LK 3K 3K< 1K 4K 3 5K R₁ TIT

A:

Q: 2- Downward ((11-10-01-00)) when input is “0” using SR Flip flops when input is “1” A 2-bit counter…

A: (a) Ans:-The characteristic table of J-K flip flop will beJKQn+100No change01010111Toggle

Q: Consider the LTI system described by the following differential equations, ²+15-5y = 2x, dt which of…

A:

Q: Z transform please asap?

A: It is given that:

Q: Answer all parts of the question. 1. For the given RLC circuit, answer the following questions.…

A: In this questionWe need to determine the transfer function, pole zero diagram, type of the output…

Q: Find R if R1-21 ohms, R2= 17 ohms, A=1 amperes and V= 15 V. R1 A R R2

A: Circuit diagram is given as,

Q: For the circuit shown below, if the voltage across Re is to be 200mV with a transconductance gm =…

A: In this transistor circuit we need to calculate the value of RE in ohm .Given , Transconductance…

Q: A half-wave rectifier is used to supply 50V d.c. to a resistive load of 800 9. The diode has a…

A: It is given that:

Q: phase

A: Load 1:-1.8 kW and capacitive 1.2 kVAR.Load 2:-8kw ,0.5 back power factor(0.5 lagging)Load 3:-3 kVA…

Q: In the circuit below, how many super nodes there are: 3 ΚΩ 4 ΚΩ 2 ΚΩ 10v (+ 4 ΚΩ 3 ΚΩ 0.5V + 6 ΚΩ +…

A: Given one circuit with nodes. Need to find number of super nodes in a given circuit.

Q: Time left 1:25 In a three-phase balanced delta-delta system, the source has an abc-phase sequence.…

A: Given Data:Delta connected loadDelta connected sourceLoad impedance Phase current To determine:Phase…

Q: A diode is model by iD = IseºD/VT, where VT is 25 mV and Is is 10 fA (i.e. 10 × 10-¹5A). 1.…

A:

Q: Determine the frequency of the modulating signal which is producing an FM signal having a bandwidth…

A: here we have to find the frequency of the modulating signal

Q: 10. (Problem 2.127): Find the power absorbed by the 12-k resistor on right side of the network in…

A:

Q: Determine R, such that |Vol = 100|Vs] at the resonant frequency. Vs R 0.1 μF V₂ 1 mH

A: The circuit diagram,and,

Q: ..theorem is quite useful when the current in one branch of a network is to be determined or when…

A: Answer: a. TheveninExplanation:a. It is a valid option. The Thevenin theorem is used to find the…

Q: In a balanced three-phase system, the source has an abc-phase sequence. There are two parallel…

A:

Q: To Find Currents:

A: It is given that:

Q: (100 V DC shunt motor has a starting line current value of of Ist= 55 A, drawn from the voltage…

A:

Q: ZENT ja 752 j3 j It -ja 52 1052 j5

A: Given Circuit:To determine:The Input impedance

Q: In Designing a lag compensator for the shown system, the only thing left is to determine the gain…

A:

Q: Q2. What is the internal voltage gain of a single CE stage when ß= 220, rx = 36102, Rc = 1 km,…

A:

Q: 0. Determine the mode of operation of an NMOS transistor when its terminal voltages are VG = 1V, Vs…

A: Given , VG= 1V ,              VS = 0V ,              VD= 2 V ,               VT = 2 V From the VGS…

Q: Q1. The diode in the circuit shown is ideal. 2V 10 sin(t) + B Vo + 4.22 What is the shape of the…

A: Diode will conduct when anode voltage is greater than cathode voltage and stops conducting when…

Q: The power factor of a D.C. circuit is always Select one: a. There in no power factor for DC b. 1 O…

A: DC circuit

Q: a. Calculate total resistance b. Calculate the total current IT c. Find the voltage VR5, with others…

A:

Q: Find the current across the resistor 8 22 while the switch S is open for a long time. A) (A) B)(A)…

A:

Q: C(s) Find the transfer function R(s) below using block diagram reduction. R(s) + H3(s) H₁(s) G₁(s)…

A:

Q: Can you safeguard your PC against damage caused by a spike in the power supply? If so, please share…

A: We need to discuss safeguard of PC against damage caused by a spike in the power supply.

Q: Consider the system shown below. For what values of a is the system linear and time-invariant? (a)…

A: For the system to be Time invariant, following condition should be satisfied,There should be no time…

Q: For the circuit shown in the figure below, assuming that VA1 = ∞ and VA2 < ∞, the gain expression is…

A:

Q: 04 Draw the alternate representation of the following circuit. 20 Ω υχ 10 Ω I 20 Ω όλη κατά 10 Ω 41,

A: A circuit consisting of dependent current source.

Q: Determine the input impedance and an equivalent circuit model for the following network at 50 kHz.…

A:

Q: Consider a system whose Open Loop Function poles are shown in the S-plane plot below. Suppose you…

A: There are two ways to check out whether the points lie on the root locus or not. Angle…

Q: If f(t) (shown below) has Fourier transform F(w), then what is the Fourier transform of F(t) when w…

A:

Q: 1. The block diagram of the control system is shown as figure. R(s) G₁ H₁ G₂ $ Hy Gy C(s) (1)…

A:

Q: 3. A 7970 V:120 V, 60 Hz potential transformer has the following parameters as seen from the…

A: The above question is based on a transformer equivalent circuit.

Q: Given the period T = 1.50 hrs, find the frequency in rad/sec

A:

Q: Figure Q2 shows the response of the output y of a dynamical system when there is change in input u.…

A: The time required for a changing quantity in a circuit, as voltage or current, to rise or fall is…

Q: 5) The following system is: R(S) a) Type one-second order c) Type two-second order 100+2x+5)…

A:

Q: (100 V DC serial motor has a starting current value of 50 A. Total armature resistance (Ra) value is…

A: The above question is based on DC series motor.

Q: Solve this using superposition theorem

A: to find the response through the resistance 6 ohms using super position theorem

Q: Power and thermal dissipation constraints are now widely acknowledged as crucial microprocessor and…

A: Power and thermal dissipation constraints are now widely acknowledged as crucial microprocessor and…

Q: In the circuit given in the figure, Rk = 8.70Kohm, R1= 5277.50Kohm, R2=5722.50Kohm, R3 =4.31Kohm,…

A: