13.- For the differential manometer shown in Fig. 3 calcu- late the pressure difference between points A and B. The specific gravity of the oil is 0.85. 10 in 32 in Oil Water 9 in

Q: 2. [Mixing] Chlorine gas containing 2.4% Oz is flowing through an earthenware pipe. The gas flow is ...

A: Given that : Feed gas (F) composition is: Chlorine gas, Cl2=2.4% =0.024 Oxygen gas, O2= 97.6% = 0.97...

Q: An Ocean Thermal Energy Conversion (OTEC) power plant built in Hawaii in 1987 was designed to operat...

A: A few assumptions are to be made. The operation undergoes at a steady-state condition. The fluid is ...

Q: 2.10-2. Frictional Pressure Drop in Flow of drop in pascal for olive oil at 293 K flowing through a ...

A: T=293K L=76.2m Di= 0.0525m V= 1.22m/s frictional pressure drop=∆P=? Density of olive oil (293K)=0.91...

Q: Determine the composition of the center point of the "square" in the ternary phase diagram.

A:  

Q: Natural gas containing 73% CH4, 20% C2H6 and 7% C3H8 is burnt with 150% excess air. Find the complet...

A:

Q: You are asked to mix two aqueous sulfuric acid (H2SO4) solutions. The first solution contains 20.0 w...

A: Given, The first solution contains 20.0 wt% H2SO4 with a specific gravity = 1.139 The second solutio...

Q: A mixture of propane and butane gas is burned in excess air, supplied substantially dry, to produce ...

A: To study analysis of gas there ae various analysis. The analysis are differentiate on basis of wat b...

Q: 8. How can you separate the following? (i) Salt from water TA (ii) Chalk powder from water (iii) Tea...

A:

Q: Calculate the gas density at reservoir conditions with a following given of        1430 psia and 97 ...

A: The apparent molecular weight of air and gas are important aspects to obtain the density of gas at r...

Q: One kilogram of air is heated reversibly at constant pressure from an initial state of 300 K and 1 b...

A: Given, no. of moles of air, n=1 mole T=300 K, P=1 bar PVT=83.14 bar.cm3mol.K CP=29 Jmol.K final volu...

Q: THERMODYNAMIC TABLES AG Values AH: Values Substance kJ/mole Substance kJ/mole co (g) -137 -110 co(s)...

A:

Q: For 20% excess air supply, calculate the actual amount of air required for the combustion of C8H18, ...

A: Combustion is the process of burning a fuel at a very high temperature. It is an exothermic process....

Q: [Mixing] Chlorine gas containing 2.4% O2 is flowing through an earthenware pipe. The gas flow is mea...

A: Given Compositions of oxygen in all streams

Q: Consider the reaction: 2 CO(g) + 1/2 O2(g)→2 CO:(g) Given are the data at 298 K. CO O2 CO2 AH°, kJ m...

A: Hi and thanks for the question. The given chemical reaction is not balanced, So I am providing the b...

Q: Btu Convert 26.4 to hr ft °F m K

A:

Q: The fuel in the form of biogas (65%-mol CH4 and 35%-mol CO2) is burned in a furnace. Determine the L...

A: Given that, The mole% of CH4 in the biogas = 65% The mole% of CO2 in the biogas = 35% The standard f...

Q: Consider a double-fluid manometer attached to an air pipe shown in Figure below. If the specific gra...

A: The double filled manometer is attached to the air stream at one side and open to atmosphere on anot...

Q: DHFUSION of Gases Compment name Propane. Butane Area % 7.726 92.274 R/tin sec Propaine Butane. 1.367...

A: PERCENTAGE area under the peak of each component is given to us ,we have asked calculating the ratio...

Q: 1. One mole of an ideal gas with cp = (5/2)R and cv = (3/2)R expands from P1 = 6 bar and T1 = 800 K,...

A: Given: moles of ideal gas,  n=1 mol heat capacity at constant pressure, Cp=52R=2.5×8.3145=20.786 J/m...

Q: The question has been raised whether an open-loop unstable process can be stabilized with a proporti...

A: As per diagram, to have a stable response, all the poles should be negative or have negative part fo...

Q: A solution of sugar in water is to be concentrated from 5 wt % sugar to 20 % sugar. The solution is ...

A: Given: Sugar solution concentrated from 5 wt % to 20 wt %.  Solution is at 45°C, air at 45°C with de...

Q: Calculate the Specific Volume at 1751 psia and 106F, the apparent molecular weight is 23.233. Round ...

A: Given P=1751Psia T=106F Apparent molecular weight=23.233 Find Specific Volume(v)  

Q: A 23.0 g sample of iron, which has a specific heat capacity of 0.449 J'g C ', is dropped into an ins...

A:

Q: 1. Please consider steam at 500 kPa and 300 C. Please determine a. a and g in k.J/kg. b. R in cc/gm.

A: Steam at 500 KPa comes in superheated region. Steam pressure, P=500 KPa Steam temperature, T=300°C  

Q: Define the followings petroleum parameters i. Adsorption ii. Cycloparaffins Aromatic compounds. Para...

A: ASKED ; Define following petroleum parameters 1) Adsorption 2) Paraffins 3) Cyclo- Paraffins 4) Arom...

Q: Which type of sample is appropriate for packages of peanut brittle stored in a warehouse with contro...

A: Introduction To answer the three questions, let us recall the key terms involved in the options give...

Q: A solute (referred as “A”) must be removed from a stream of inert gas in an absorption column. The g...

A: Given data: Molar flow rate of gas stream = 200 mol/h Composition of gas stream is, Solute (A) = 0.2...

Q: 2.9-4. Shell Momentum Balance for Flow Down an Inclined Plane. Consider the case of a Newtonian flui...

A:

Q: The feed to a separation process contains 50 wt% benzene, 30 wt% toluene, and 20 wt% xylene. The fee...

A: In process flow chart, to check the variables to be under specified or overly specified is given by ...

Q: A wet free-milling gold ore sample weighing 150 kg was delivered to an assayer to determine the grad...

A:

Q: Consider te reaction scheme Shown below AkB K C the reactions arefiist Order. A and k ase 20 and 80k...

A:

Q: A 16-m x 8.5-m section of wall of an industrial furnace burning natural gas is not insulated. outer ...

A:

Q: In the process illustrated in the figure, operating in steady state, the R → Products reaction occur...

A: Given that, QR,i is the molar flow of compound R in stream i. QR,5QR,3 = 0.8QR,5 = 0.8QR,3          ...

Q: A type A -> R reaction with reaction rate represented by -rA = 2CA^2 (mol / L.min) is carried out in...

A: Given v1=150Lmin v2=250 Lmin V1=300 L CA0=2 moll XA=0.75 CA2=2x(1-0.75) CA2=0.5 moll  

Q: Determine the Low Heating Value (LHV) and High Heating Value (HHV) of carbon monoxide gas in units o...

A: Given that, The standard formation enthalpy of H2O(g) ∆HH2Ogo = -241.8 kJmol The standard formation ...

Q: What is the optimum combination of ideal reactors for the reaction A →B if it is autocatalytic with ...

A: Autocatalytic reaction is the reaction which rates is depends upon the product concentration which p...

Q: 1 m of air at a pressure of 1 atm is mixed with 0.1 m³ of carbon dioxide at 1.5 atm and the mixture ...

A:

Q: 1. Assuming the validity of Raoult's law, do the following calculations for benzene(1)/toluene(2) sy...

A: The distribution of chemical components of vapor phase and liquid phase is given by vapor - liquid e...

Q: Calculate Z and V for ethane at 50°C (323.15 K) and 15 bar by the following equations: (a) The trunc...

A: e) Given that, Temperature T = 323.15 K Pressure P = 15 bar It is required to calculate the Z and V ...

Q: When light with a wavelength of 58.5 nm strikes the surface of tin metal, electrons are ejected with...

A: Given data : wavelength of light =λ= 58.5 nm = 5.85 x 10-8 m kinetic energy of electrons =EK=  2.69 ...

Q: A solution is obtained by mixing 300 g of 25% solution and 400 g of 40% solution by mass. Calculate ...

A: Given m1=300g,m2=400gx1=0.25,x2=0.4 Total mass of resulting mixture=m1+m2=300+400=700g m1x1+m2x2=(m1...

Q: Which two streams relate to equilibrium conditions for equilibrium staged operations? Stage A 2 Stag...

A: Distillation is a separation operation in which the high volatile component is separated from the le...

Q: A gas contains 75.0 wt% methane, 10.0% ethane, 5.0% ethylene and the balance water. What is the mol%...

A: Reactions involved for the complete combustion- Methane-CH4 + 2O2 →CO2 + 2H2OEthane-C2H6 + 72O2 →2CO...

Q: Derive an expression for the overall heat transfer coefficient for the following case of a flat furn...

A: To solve the above problem , we need assumptions, Assumptions  1) Isothermal system i.e. temperature...

Q: Below is a flowsheet for a crystallization process. A hot solution of water and a substance A enters...

A: Draw the diagram for the filter system with variables as follows:

Q: The figure below shows the phase diagram for two partially miscible liquids, which can be taken to b...

A:

Q: Using only the periodic table arrange the following elements in order of increasing ionization energ...

A: Given that  We have to arrange given  element according to increasing ionization energy .  

Q: A 1.50 g sample of pure sucrose is burned in a bomb calorimeter that has a heat capacity of 8.930 kJ...

A: A bomb calorimeter is a constant volume type of calorimeter. It is used to measure the heat of combu...

Q: pipe, g/cm', and the melt has a dynamic viscosity of 3.12 g

A: 1. diameter= 10cm = 10*10-2m 2. Density = 7.8 g/cm3= 7800 kg/m3 3. dynamic viscosity= 3.12g/ms= 3.12...

Q: A gaseous fuel has the following composition of volume: H2 = 24%; CH4 = 30%; C2H6 = 11%; C2H4 = 4.5%...

A: Dry basis is the calculation where the water presence is not considered. Air fuel ratio tells us whe...