14. Shown in the accompanying Figure C are the measured offsets from a traverse line AB to an irregular boundary and the spacing between the offsets. Determine the area bounded by the traverse line, the irregular boundary and the end offsets using a.) Trapezoidal rule b.) Simpson's One-third rule and c.) Compute the difference between Trapezoidal Rule and Simpson's One-Third Rule 5.60 h₁ 6.40 h₂ 7.90 h₂ 6.20 7.50 9.50 12.30 2₂ hs no h₂ •6m 6m 6m⋅ Figure C 10.80 ng 2.70

14. Shown in the accompanying Figure C are the measured offsets from a traverse line AB to an irregular boundary and the spacing between the offsets. Determine the area bounded by the traverse line, the irregular boundary and the end offsets using a.) Trapezoidal rule b.) Simpson's One-third rule and c.) Compute the difference between Trapezoidal Rule and Simpson's One-Third Rule 5.60 h₁ 6.40 h₂ 7.90 h₂ 6.20 7.50 9.50 12.30 2₂ hs no h₂ •6m 6m 6m⋅ Figure C 10.80 ng 2.70

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

By the trapezoidal rule, find the area between a traverse line and a curved boundary, rectangular offsets being taken at intervals of 5 meters, and the values of the offsets being h1 = 3.2, h2 = 3.4, h3 = 12.8, h4 = 11.2, and h5 = 4.4.
In the quadrilateral ABCD the sides were measured as follows: AB, 8.34 m; BC 7.77 m; CD, 8.99 m; and DA 14.83 m. If the angle between sides AB and BC is 117.85 degrees, determine the area of the quadrilateral. PLEASE NEED ANSWER IN 10 MINS. SORRY BUT IT HAS NO DIAGRAM PRESENTED.
Your team want to measure line AB but there is an obstruction on line. You set up two lines AC and CB 2350.700 m and 1285.350 m, respectively. Point C was set at a perpendicular distance of 270 m from point D. Point D is on line AB. Using slope correction formula for less than 20% slopes, determine the length of line AD. the length line BD the length of line AB.
The three angles of a triangle were measured as follows:Angle Observed ValueA 47o07’34”B 69o51’06”C 63o01’02”Compute the MPV for each angle
: The following offsets were taken from a chain line to a hedge at a regular interval of 20 m from d1-d4 and at a regular interval of 300 m from d4-d8.Distance(m) d1 d2 d3 d4 d5 d6 d7 d8 Offsets (m) 3.76 4.32 5.44 4.88 3.84 3.36 3.00 2.52Determine the area in sq. meter included between the chain line, the hedge and the end offsets By Simpson’s rule. By Trapezoidal rule By Overage Ordinate rule
The interior angles of a triangle were measured as follows Compute the most probable value of angle A. a. 41deg 85’ b. 41deg 41’ c. 40deg 46’ 9” d. 39deg 41.2’
At regular interval of 5 meters along line AB, the measured offset distances from the line AB to the edge of the stream are: 6.5, 7.3, 12.1, 12.7, 14.5, 16.0, 18.6, 18.5, 16.4, 15.9, 14.7, 13.5, 12.75, 12.5, 9.7 and 2.0. What is the area between line AB and the stream? a. Area using Trapezoidal Ruleb. Area using Simpson’s 1/3 Rule
If the surveyor is at Point A, and recorded the location of Line AB to be 200 degrees 35 minutes in WCB. The surveyor then recorded the location of Line AC to be 280 degrees 15 minutes in WCB. The length of AB is 530.68 meters and Length of AC is 275.45 meters. What is the angle of Line AC expressed in RB?
n Rising and Dipping distance which equation is correct? a. 2.20 X √ Elevation b. 4.10 X √ Elevation c. 3.08 X √ Elevation d. 2.08 X √ Elevation
Answer the subquestions: A. A slope measurement of 545.38 m is made between points A and B. The elevation of A is 424.25 m and that of B is 459.06 m. Determine the horizontal distance between two points. B. A traverse line was measured in three sections: 295.85 m at slope 8°45’, 149.58 m at 4°29’, and 373.48 m at slope 4°23’. Determine the horizontal length of the line. Note: Draw the figure and show the complete solution. Provide a recheck of the answers.
Calculate the side widths and cross-section area of embankment having width =20m and side slope( 1/2 )formation level 20m.ground level=15m and ground slope ( 1/12) from C.L to side
Calculate the side widths and cross-section area of embankment having width =20m and side slope( 1/2 )formation level =20m . ground level=15m and ground slope ( 1/12) from C.L to side