16. Sketch the root locus for a unity-feedback system where Then find the following: [Section: 8.5] G (s) = K (8-2) (8-3) s(s+2) (8+3) a. The breakaway and break-in points b. The crossing of the jo-axis c. The range of K for closed-loop stability d. The value of K that will result in a stable system with complex conjugate poles and damping factor of 0.5

16. Sketch the root locus for a unity-feedback system where Then find the following: [Section: 8.5] G (s) = K (8-2) (8-3) s(s+2) (8+3) a. The breakaway and break-in points b. The crossing of the jo-axis c. The range of K for closed-loop stability d. The value of K that will result in a stable system with complex conjugate poles and damping factor of 0.5

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.3P

See similar textbooks

Similar questions

A For a monolithic negative feedback system defined by the open path function, find the gain range (to operate the system at steady state
A unity-feedback system has forward transfer function (see attached). a) Sketch the root locus for this system as K varies from 0 to ∞; b) Use the Routh-Hurwitz test to determine the range of K for the system to be stable; show this value of K on the root locus plot.
BelowIn the unit feedback system given the shape, G(s),is given as. When a unit ramp is applied to the input of the system, 2% of the steady-state error and unit to the inputWhen the step is applied, it is desired that the percentage exceedance rate is 9.25% and the settling time is 0.58 s.1-In this case, which of the following is the approximate value of the constant a? 2-In this case, which of the following is the approximate value of the constant b? 3-Looking at the unit step response of the systemWhat is .peak time?
BelowIn the unit feedback system given the shape, G(s),is given as. When a unit ramp is applied to the input of the system, 2% of the steady-state error and unit to the inputWhen the step is applied, it is desired that the percentage exceedance rate is 9.25% and the settling time is 0.58 s.1-In this case, which of the following is the approximate value of the constant a?
Consider the unity-feedback control system with the following feedforward transfer function: G(s) = K / s(s2+4s+5) (1) Plot the root locus. (2) Determine closed-loop poles that have the damping ratio of 0.5. Find the gain value K at this point. (3) For what value of K is the overshoot less than 10% and the maximum rise time less than 1.5s.
Question 02: A system has a gain k in series with an open-loop transfer function given by G(s): a) Check, by means of the Routh-Hurwitz method, the range of values of k that makes the system stable. b) Also using the Routh-Hurwitz method, show what value of gain k makes the system response undamped. Calculate the value of the dominant poles for this case.
For a unity-feedback system with G(s) = K / s(s + 20)(s + 40) operating with a 20% overshoot, design a compensator to decrease the settling time by a factor of 2 without affecting the percent overshoot:i. Find the uncompensated system's dominant poles, gain, and settling time. ii. Find the compensated system's dominant poles and settling time. iii. Find the compensator's pole position and required gain. (Assume the compensator’s zero is at -20).
An uncompensated unity feedback system with certain deficiencies has no zeroes and poles at -1, -2 and -5. Answer the following questions based on the above description of the system Determine using an apt technique, the gain of the system at damping ratio 0.45
Find an expression for the closed-loop gain G = v0/vS. Then, assume that R1 = 1kΩ, R2 = 4kΩ, C = 1uF.
An op amp has a dc gain of 100 dB and a unity-gain frequency of 10 MHz. (a) What is the bandwidth of the op amp? (b) If the op amp is used to build a noninverting ampliﬁer with a closed loop gain of 60 dB, what is the bandwidth of the feedback ampliﬁer? (c) Write an expression for the transfer function of the op amp. (d) Write an expression for the transfer function of the noninverting ampliﬁer.
Consider the feedback system given the open loop transfer function below G(s)H(s) = K / ( S (s+3) (s+2)) a) Using the Routh-Hurwitz criterion, for which value of K, the poles of the closed-loop system take the pure imaginary value.b) What will be the maximum value of K for the system to be stable?c) Calculate the value of K, where the real value of the complex root of the system is Re{s}=-1. Tip 1: Closed loop transfer function T(s) = G(s) / ( 1+ G(s)H(s)) .Routh HurwitzIn order to perform the criterion analysis, the denominator of the closed-loop function will be examined. Tip 2: The real value of the system complex root Re{s}=-1 is expressed by the following formula f^2(s) = p(s-1) p(s) is the payoff of the closed-loop function.
The control system manages, commands, directs, or regulates the behavior of other devices or systems using control loops. State the advantages of implementing negative feedback in a closed-loop system. Then Write the corresponding differential equation for the transfer function given, Specify the assumption made for the solution.