18V- 9Ω www. 8Ω Μ 12Ω 18Ω 11Ω www 5Ω ΖΩΙ ΜΕ ΠΩ 3Ω Μ ΠΩ ΕΣΤΩ 5Ω

Q: Q5) Find the Thevenin equivalent circuit for the network in Fig. 5. Then, under the maximum power…

A:

Q: Determine the power delivered by the current source in the figure below: www 502 www 402 4A 20

A: Solution !!

Q: The magnetic field set up in the iron core of a transformer comes from the (A) active B) reactive…

A: Transformers are supplied with ac voltage on the primary side Transformers doesn't work with dc…

Q: Find V

A: It is given that:

Q: The field current of a 90 kW, 230 V shunt generator is 5 A when delivering power at rated terminal…

A:

Q: An 4-pole, 230 V d.c. shunt generator delivers 50 Amperes to the load. The armature has 128 slots…

A: In this question we need to find a armature flux per pole for the given DC shunt generator.

Q: 3 only

A:

Q: Design the phase shift oscillator to oscillate at f=22.5kHz. the minimum resistance to be used is…

A:

Q: For class AB amplifier the R.M.S. input voltage is IIV and the supply voltage is ±20V and the load…

A: Given that                                  Vin(rms) =11 V                                   Vcc…

Q: Q4) An LTI system is characterized by the differential equation below: d² z y(t)+5 = y(t)+6y(t) =…

A: NOTE: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts…

Q: For the image shown, the 18 ohm resistor has a current through it of M 852 qr 1852 56 V ?

A: In this question,  We need to determine the current in the 18 ohm resistance  We are solving this…

Q: 5V O 0000 (667 What is the value of Rt? Unit: Ohm 1,500 3,000 Rp 133 R₁ R₁ GND 2Rp + Rn Rp +2Rn V₂ t

A:

Q: A 3-phase, 50 Hz transmission line with a total series impedance of 34 + j140 and shunt admittance…

A: Given:  f=50 Hz, Total series impedance=34+j140 Ω, shunt admittance=j900×10-6 Ω-1, l=210 km,…

Q: A 125-volt separately excited generator delivers 200 A at rated load and running at 1200 rpm.…

A: In this question,  We need to determine the power developed by the generator ?.  We know power P= VI…

Q: Which of the following are possible input of the system? (choose three) reference setpoint physical…

A:

Q: A full wave rectified voltage filter as Steady-state expression for Volt) E X (FX) is shown in below…

A:

Q: Q2: For a (3-0) medium transmission line model (T cct) as shown in next figure, find the admittance,…

A: Given data are: The constants of the transmission line: A=D=0.861∠1° B=156.57∠78.35°…

Q: 3 v(1) (+ VL(S) G(s) V(s)' 2 H oooo 292 ww 252 for the network shown elle m 2 H VL(1)

A:

Q: Question 4 Evaluate the following Inverse Laplace transforms. 1 -¹ (²+3x+2) L-1

A: We need to find out the inverse Laplace transform of the given function

Q: RT 6. Find the total resistance of the following circuit R₁60 R₂90 R, 60 R720 R, on 6

A: Given circuit:

Q: B- Find the minimum sampling rate required to multiplexing two signal waveforms if the time spacing…

A: Given Time specing between adjacent sample in the time multiplexed signal TS = 0.0625 msec

Q: Consider the circuit shown in the figure. For sustained oscillations, find the value of attenuation…

A:

Q: Calculate the missing values in the table. Round all values to the nearest whole number when…

A: We need to find out number of turns and voltage for given transformer . We know transformer ratio ,…

Q: A 4ghz uniform plane wave has an amplitude of evo = 1.6kv/m at origin (0,0,0,t=0) and is propagating…

A:

Q: For given BJT, B=200. The applied input frequency is 20 Mhz and net internal capacitance is 100 pF.…

A:

Q: Q1/ Find the minimum sampling rate required to multiplexing two signal waveforms if the time spacing…

A: Given,The time spacing between adjacent samples is,T=0.0625 sec

Q: A 4 bit module 16 ripple counter uses JK flip-flop. If the propagation delay of each flip flop is…

A: RIPPLE COUNTER: The propagating delays of each of the flip flops are summed to determine the total…

Q: 1. 2 3. 20 1502 4, 8 80 50 60 10 50 40 60 ,200 30 Is SV 16 -25 itu 4 27 20 ·16 25 30 60 M7 100 M 0…

A:

Q: 4 22:48 O 4G 4G n Vol 1 LTE 2 100 X Solve your answers in 4 decimal places. Kindly send in PDF form.…

A:

Q: 88. An AM transmitter is rated 100 W at 100% modulation. How much power is required for the carrier?

A: Given: An AM transmitter is rated at, Total power, PT=100 W. Modulation index, μ=100%=1.

Q: A buck-boost converter has an input voltage of 12 V and the duty ratio is adjusted to 0.5. What is…

A: Given: A buck-boost converter has, Input voltage, Vin=12 V. Duty ratio, D=0.5.

Q: A: A single core cable covered by the lead, if the radius of the conductor is r and the insulator…

A: In this question we discuss about maximum and minimum electric stress on cable.

Q: Determine VI and V₂ using nodal analysis V₁ 5012 V2 5A1 400 3029A

A: We need to find out node voltage for given circuit by using of nodal analysis .

Q: 3 v(1) (+ G(s) = 2 H oooo VL(S) = , for the network shown V(s)' 292 ww 2Ω. elle m 2 H VL(1)

A:

Q: Q2 1 20 If the current at the terminals of the element shown above is defined as: i = 0, i =…

A: In this question we need to find the expression of charge accumulating and charger at 1ms

Q: Two identical antennas are placed in the 0 = x/2 plane as shown in the figure. The elements have…

A: Solution !!

Q: Q2: A three-phase Transmission line with 1,956 cm diameter conductor, the corona takes place if the…

A:

Q: P 3.4-4. Determine the current i in the circuit shown in Figure Figure P 3.4-4 6 A 16 Q2 www www 89.…

A:

Q: For given BJT, B=200. The applied input frequency is 20 Mhz and net internal capacitance is 100 pF.…

A: According to the question, the data given for the BJT is as  β = 200 Also, the value of input…

Q: Find the amplitude and frequency of the following waves: 2.1. 15 sin 377t 2.2. 104 sin 754t

A: Given : 2.1 15 sin 377t

Q: Calculate the equivalent admittance Y, for the network in Fig. the current I if Vs = 60/45° V.…

A:

Q: The variable AC voltage available from the power module is a (A) single-phase (B) 2-phase balance…

A: Variable ac voltage is the output of a variac transformer. To meet the load requirements various…

Q: λ A lossless transmission line having 50 characteristic impedance and length is 4 short-circuited at…

A: Given- Characteristics impedance= 50 ohm Length of lossless transmission line = λ4 Source voltage =…

Q: 1. Use Wye to Delta Transformation to solve for I. 50Ω Μ 5Ω 55V www 30Ω I Μ Μ 4Ω 20Ω Μ 200

A:

Q: 2. Consider the signal r(t) = 5sinc(t). (a) Make a sketch showing the energy spectral density of…

A: We need to find out energy spectral density and we need to find out the energy of the given signal .…

Q: 1. Find the value of lo using Mesh and Nodal Analysis. Το 6V (1+) 6 ΚΩ 6 ΚΩ www 4 ΚΩ (+1) +) 24V

A: Given circuit:

Q: A R-L-C circuit has a resistance of 6 ohms. inductive reactance of 8 ohms and capacitive reactance…

A: Given an R-L-C circuit has, Resistance, R=6 Ω. Inductive reactance, XL=8 Ω. Inductive capacitance,…

Q: (Non-anonymous question, Determine x(t) from the transfer function function. X(s) F(s) s²+5s+10 for…

A:

Q: 1. What is an electric field line? What are equipotential surfaces? Are they necessarily physical…

A: 1).  Electric field line: An electric field line is an imaginary line or curve drawn through a…

Q: Determine the modulation index mf, of an FM signal which is being broadcast in the 88-108 MHz band.…

A: Carrier swing = 125 kHz Broadcasting frequency = 88 - 108 MHz

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.