19 Determine the voltage across the resistor R2. (assume LED forward voltage is 2.1 volts) * A R2 1K 5V D1 R1 D2 1K |/

Q: 12.47 An air-filled cavity has dimensions 20 mm × 8 mm × 10 mm. If the walls are silver-plated, find…

A:

Q: 82 j4 2 ll o a 5/0° A 0.2V,

A:

Q: Find the total current and the overall dissipated power Total current:Blank 1 Power:Blank 2

A:

Q: 1. Determine the Z-Transform of the following signals. а.x(п) — 8(п — 3) — 28(п — 1) + 38(п) b.x(п)…

A: as per our guidelines we are supposed to answer?️ only one question. Kindly repost other questions…

Q: Q.32: The two-wattmeter method gives P1=1200W and P2=-400W for 3-Ph motor running on 240V line.…

A: The solution is given below

Q: brt

A: Please refer the attached images for the complete answer..

Q: Consider the following configuration: x. (t) | v.[r] H¿(@) y. (t) x[n] y[z] = x* [r] CID Squarer DỊC…

A: Given the block diagram as shown below: Given : xc(t)=cosπt3T T1=T22=T We need to determine yc(t)…

Q: In the circuit shown, determine the current flowing through the resistor R1. R2 1K R1 5V D2 1K

A:

Q: Example3/ An open wire T-L with G=0.29x 10-6U/Km ,L=3.52 mH/Km, C=8.7 nF/Km ,R=6.74 KQ/Km at F=1 KHZ…

A:

Q: 1. The rated current of 15 hp, 220V sepurately excited DC motor is- a) 50.87A 2 If the load torque T…

A:

Q: 2- Construct a full-Adder logic circuit by using NAND gates only. 3- Construct a full- Subtractor…

A: The solution of the following questions are

Q: Problem 3. Consider the transfer function G(s) =7+w %3D Does there exist a bounded input such that…

A:

Q: 8. A solid spherical insulator has radius R-2.5 cm, and carries a total positive charge N 10 C…

A:

Q: An open wire T-L with G=0.29x 10-6U/Km ,L=3.52 mH/Km, C=8.7 nF/Km ,R=6.74 KN/Km at F=1 KHZ , find…

A:

Q: Example4/ A telephone cable with R=52.5 KO/Km, C=62 nF/Km , G=0 and L=1.1 mH/Km, find ,x ,B ,Vp and…

A: The solution is given below

Q: а) Given two inputs, x(t) and y(t) signals as illustrated in Figure 1 and Figure 2, respectively.…

A: Given

Q: An amplifier having a noise figure of 66 dBu and a signal-to-noise power ratio of 55 dBm as input…

A: The solution is given below

Q: 4.22 A 50 KVA; 600/240-volt; 25 cycle transformer has a core loss of 200 watts of which 30% is eddy…

A: Given data, Rating of transformer 50 KVA, 600/240 V Core loss = 200 W. Full load copper loss = 650…

Q: Q A candipous -tine Periodic signl X)is reat Valued and has a funde mentral Period ToS The Hanaca…

A: By using Fourier Series analysis

Q: Increasing the efficiency of power transmission through the antenna can be controlled by making the…

A: The solution is given below

Q: What is the dynamic resistance of a diode if its ID = 2.48 mA? No need for a solution. Just write…

A: The solution is given below

Q: In the circuit shown, determine the current flowing through the resistor R1. R2 2K D1 D2 D3 R1 9V 2K

A: Lets diodes are of silicon so drop will be 0.7V

Q: Determine the current flowing through resistor R2. (assume Zener voltage is 3 volts)

A:

Q: 17 Determine the current flowing through the LED if its forward voltage is 2.1 volts. * D1 R1 5V 1K

A: The solution is given below

Q: ACE2316 + 11623238 = x. Find x

A: The solution is given below .

Q: d. Find X(w) for x[n] = 10 + cos(÷n – }) e. Find æ[n] for X (w) = 878(w) + 1078(w – 4) + 1078(w+ 4)

A:

Q: Find Vo 600 1 600 TmF

A:

Q: I need some help. I am designing a bandpass filter with fl=3400 Hz and fh= 7500 Hz. Based on that I…

A: In this question,   We need to determine the center frequency, bandwith, Q, and RLC parameters for…

Q: 3. Using mesh Analysis. Find the value of I, I, and I, 2-j3 4-3

A: The solution is given below

Q: (b) The currents flowing into the following delta-connected network are: la = 0, I = -j10 A, l = j10…

A:

Q: Electric field is given as E = 6y²z ax + 12xyzay + xy2az - |3D An incremental path is represented by…

A: In this question electric field is given with incremental path....We have to find work done...

Q: C2 V2 0.1pF 6V R1 V1 1MQ D1 14Vrms 60HZ 1N4001G Vout 0°

A:

Q: b)ls the following signal periodic, if periodic find its fundamental period - (;):c x(b) = 4Cos"(특t)…

A: We need to find out time period for given signal .

Q: | Suppose that the transfer function Gp(S) of a first order control systes with time ay is: Gp(S)…

A:

Q: Discuss Fully the various methods available for transforming 3-phase voltages to higher or lower…

A: Different methods available for transforming 3-phase voltages to higher or lower 3-phase voltages at…

Q: With neat diagram, State the principle of RTD sensor…

A: We need to find out resistance at given temperature and we need to find out the tempreture for given…

Q: Example1/ An open wire T-L with R=10 KN/Km ,L=3.7 mH/km , C=8.3x 10-°F/Km and G=0.4x 10-6U/Km , find…

A:

Q: Consider a PV system with a battery bank installed in a location in North Europe during a summer…

A:

Q: Q2. Express the following Boolean functions in both sum of minterms and product of maxterms forms:

A:

Q: In the circuit represented in the figure, the total current I is known. Determine the intensity of…

A: In this question,   We need to determine the the intensity of the current in branch BC.  If total…

Q: # 10. For the next two questions, consider the common emitter amplifier below with beta=100 and…

A:

Q: BCD Addition: 7598+ 489=

A:

Q: Apply the Fourier series on the train impulse signal Include the following parameters in your…

A:

Q: Electrical Engineering Find the transfer function H(f) of the following circuit and sketch the Bode…

A: The transfer function is defined as the ratio of output to input at zero initial condition. Convert…

Q: 8. Subtract the following 16-bit binary numbers. a. 11001011 00101000; - 10011110 01011011; b.…

A: The solution is given below

Q: Figure Q3(a) shows a system that produces output m(t) from the input x(t) given in Figure 1. 2 x(t)…

A:

Q: Which multiplexing is used for transmitting information through the осean. FDM STDM WDM TDM Which…

A: We need to answer which multiplexing is used for transmitting information through the ocean and also…

Q: PROVE THE TRUTH TABLE OF INVERTER USING IC-7404

A: I am using thinker CAD to solve this problem Here is the components list

Q: 9. Two single-phase ideal voltage sources are connected by a line of impedance of 0.7 + j2.4 Q as…

A:

Q: Question 4 The 555 timer is connected in the following circuit. What is the output state at Pin 3 if…

A: The solution is given below

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.