Choose the correct answer. *Please answer it ASAP if you can 19. The value of absolute permeability is:a. 1.2566 x 10-6 Hcmb.1.2566 x 10-4 HcmHC.1.2566 x 10-7cmHd. 1.2566 x 10-³cm20. The induced voltage will oppose the flux producing it.a. Trueb. False

19) The absolute permeability of the free space is given by u.

19. The value of absolute permeability is: a. 1.2566 x 10-6 H cm b. 1.2566 x 10-4- cm C. 1.2566 x 10-7 H cm d. 1.2566 x 10-³ H 20. The induced voltage will oppose the flux producing it. a. True b. False

19. The value of absolute permeability is: a. 1.2566 x 10-6 H cm b. 1.2566 x 10-4- cm C. 1.2566 x 10-7 H cm d. 1.2566 x 10-³ H 20. The induced voltage will oppose the flux producing it. a. True b. False

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.1MCQ: The Ohms law for the magnetic circuit states that the net magnetomotive force (mmf) equals the...

See similar textbooks

Related questions

Q: Correct any five of the following sentences using suitable scientific phrases. 1. At star connection…

Q: The dc motor has maximum current at start because: OThe back emf is maximum. OThe back emf is zero.

A: Back EMF is the armature of the dc motor influence the driving torque and the armature conductor…

Q: In radiation triggering when the intensity of light Obecomes more than Obecomes less than Obecomes…

A: This question is based upon the triggering methodology of Thyristors , the are various methods to…

Q: 24. A ceramic capacitor has an effective plate area of 4 cm² separated by 0.1 mm of ceramic of…

Q: Determine the Fourier transform for the signal x(t) given in Figure Q1(a). An arbitrary system has…

Q: After plotting the Boolean function A(w,x,y,z)=∑ m (0,2,3,5,7,8,9,10,12,13,15) using Karnaugh map…

A: Boolean expression is given as. A(w,x,y,z)=∑ m (0,2,3,5,7,8,9,10,12,13,15) We need to simplify the…

Q: were made on the resistive network: b) The following DC measurements Measurement 1 V₁-100V…

A: Maximum power transfer theorem says that generate the maximum amount of power a finite internal…

Q: To conserve energy due to the present energy crisis, the Meralco tried tride to readjust their…

Q: The voltages developed across the 3 and 2 resistors shown in the Fig.2 are 6V and 2V respectively,…

Q: 115 1. A transformer has a turns ratio of 4:1. What is the peak secondary voltage if V RMS is…

Q: today's technology being used to its full potential in the field of effective communication?

A: In today's world technology is playing a very crucial role in every sphere right from medical,…

Q: 16.2 Circuit Element Models Find u (1) in the circuit shown in Fig. 16.9. Note that, since the volt-…

Q: A dc separate excited generator operate at speed = 1500 R.P.M at a certain excitation gives a…

Q: The collector current in the transistor is controlled by O Collector voltage OCollector resistance O…

A: We need to select correct option for given statement

Q: In a 110 V compound generator, the resistance of armature, shunt and series field winding are 0.06…

A: Given data : Rating of each lamp 55 W at 110 V Supply voltage Vdc=110V Resistance of armature, shunt…

Q: 10 n es(1) Q4) Answer question related to circuit given Given Vs(t) = 15 cos(100t) V a) Write vs (t)…

A: As you have mentioned that you need answer from D-F, so I am solving d,e and f part for you.…

Q: power factor and 220 volts.

Q: Find u (1) in the circuit shown in Fig. 16.9. Note that, since the volt- age input is multiplied by…

Q: Find i for t > 0 if i(0) = 2A and v(0) = 6V. 50 1000 mH www 26 cos 3t V 향 (+1) 카 + >

A: The given circuit diagram is shown below:

Q: What are the characteristics of an ideal operational amplifier?

Q: An AC system with the frequency of 60hz is composed of 2 relays with 20 ohms resistance and 0.16…

Q: Q3: Assume that you have to spread two signals A and B, using CDMA with the DSSS. The data of…

Q: C) Why is the common collector amplifier called an emitter follower? Why is it often used as a…

A: (C) Common collector amplifiers are those transistor amplifier in which the input and output…

Q: Shunt generator will build up its voltage when: Olts field resistance higher than critical value.…

Q: Q/ Determine and sketch the even and odd parts of the signal below, label your sketch carefully 1.5…

Q: For the following toroid, the flux is 440μWb, r1= 8 cm and r2=12 cm. The flux density is

Q: Q1e) Find the equivalent inductance, Leq, at terminals a-b of the circuit given. Show all work. ao…

A: Series combination of inductance: Leq=L1+L2 Parallel combination of inductance: 1Leq=1L1+1L2+1L3

Q: 9. What is the maximum power if the impedance draws a current of i= 10cos(wt-30o ) from a voltage…

A: Power is rate of change of energy. Its SI unit is watt. Given:R.M.S Values:V=220VI=10∠-30°A

Q: After plotting the Boolean function A(w,x,y,z) = A(w,x,y.x)=∑ m (0,1,3,4,5,6,7,8,9,10,11,13,14,15)…

Q: Determine the current IX in the Fig.7:

A: It is given that:

Q: 1. One millivolt is one millionth of a volt. a) True (b) False

A: 1.1 One millivolt is one millionth of a volt. Select one : a. Trueb. False millivolt and…

Q: For the following magnetic circuit, the flux density is 1 T and magnetic field intensity is 700…

Q: What is the impedance equivalent of Series LC 22. What is the impedance equivalent of a series…

Q: 27. Given the field H = 20p² a m Find the total current passing through the circular surface p ≤ 1,0…

A: We need to find out current for given field

Q: port port circuit is short-circuited, it found that I₁ = 0.1612 and V₂ = 812. b. Y12-20 mv. c.…

A: We are authorized to answer only 3 subparts at time since you have not mentioned which question you…

Q: Differential compound generator has bett voltage regulation than that when it is shu connected. O…

A: In this question we will write voltage regulation of dc shunt generator and differential compound…

Q: series motors has a very high starting torque because its armature resistance is small O True O…

A: Given A true or false question based on series DC motor. Please find the answer below

Q: For the network of Fig. 5.172: Determine AVNL?

A: The required parameters can be calculated by using the DC analysis and AC analysis of the amplifier…

Q: . How much is the per kWh

A: The rate of charge per kwh is ratio of the amount paid to the total energy consumed. The total…

Q: Three resistors R1, R2 and R3 are connected in series. According to the following relations, if RT =…

Q: 4. When port 1 of a two-port circuit is short-circuited, it found that I₁ = 0.1612 and V₂ = 81₂. a.…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 23. Calculate the capacitance of a capacitor that is charged to 84W-s by 10.3A-s source. C= F

Q: 1. Assuming that the value of the resistor Rx is 1 0, calculate the value of the following…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: A single phase half-bridge voltage source inverter (VSI) has a resistive load of 2.4Ω and input dc…

A: Single phase half bridge is a voltage source inverter. The input power of the inverter is a DC…

Q: Compute the convolution y(n) = x(n) * h(n), Where x(n) = {1,1,0,1,1} and h(n) = {1,-2,-3,4), Using…

A: Using tabulation method we need to derive convolution of the given sequences. y(n) = x(n) * h(n)…

Q: What are the loads that are allowed and are not allowed to connect to a general socket based on its…

A: Given: General socket question

Q: (HoW) Find the transfer function of dc motor, armature controlled ha la 4 4 ㅋ latt) est+) (TM.))…

A: Using different standard equations of dc motor find the relations between various parameters . Then…

Q: For the following circuit, number of nodes is R₂=402 www E₂=6V R₂=30 W R₁=102 E₁ = 2 V R₁ = 20 E3= 1…

Q: Me + 40 Ω 25 nF 80 με 60 Ω

Q: 9. The generator power is always the maximum load power. c. equal b. less than d. greater than or…

Question

100%

Choose the correct answer.

*Please answer it ASAP if you can

19. The value of absolute permeability is:
a. 1.2566 x 10-6 H
cm
b.
1.2566 x 10-4 H
cm
H
C.
1.2566 x 10-7
cm
H
d. 1.2566 x 10-³
cm
20. The induced voltage will oppose the flux producing it.
a. True
b. False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
Consider the three single-phase two-winding transformers shown in Figure 3.37. The high-voltage windings are connected in Y. (a) For the low-voltage side, connect the windings in , place the polarity marks, and label the terminals a, b, and c in accordance with the American standard. (b) Relabel the terminals a, b, and c such that VAN is 90 out of phase with Va for positive sequence.
In induction heater, heat is produced in magnetic materials when they are exposed to an direct-current ﬁeld. Select one: True False
solve for the total flux using divergence. Please write in detailed solution.
Find the inductance per unit length of a very long solenoid with a unit length of N windings. The permeability of the core is μ.
Find the flux
1. In addition to resistive components, state or name one other electromagnetic component found in the equivalent circuit of a transmission line. 2. State or name one equivalent or simplified model of transmission lines 3. In general, the fluxes whether electric or magnetic are maximum when the area vector and the active field are ______ degrees with each other. 4. Complete the Parallelism: "Charges are to Electric, while __________ are to Magnetic"
The magnitude of the induced emf in a coil due to the effect of a variable magnetic field on its length is numerically equal to the product of length of the coil and the rate of change of the linkage flux on it. true / false
The flux linkages per ampere is given by: a) Resistance b) Inductance C) Capacitance d) Sag
Please use kirchhoff's law in determining currents and please regard to the answer thankyou!
5-5.When one coil of a magnetically coupled pair has a current 5.0 A the resulting fluxes ?11and ?12 are 0.2mWb and 0.4mWb, respectively. If the turns are N1= 500 and N2=1500, find L1, L2, M, and the coefficient of coupling k
Magnetic saturation is that condition of a magnetic material when all of the magnetic domains are oriented in the direction of the applied mmf True False