1A ΣΩΤ 202 ΙΩ 24 b ΙΩ

Q: 2. The voltage sensitivity of the full bridge differential circuit is ( the single arm bridge. A. 2…

A: The question is about sensitivity of full bridge.

Q: From the response below, determine the values of Mp, Tp and T§. Amplitude 1.8 1.6 1.4 1.2 0.8 0.6…

A:

Q: Use nodal analysis to calculate the node voltages in phasor form, and va(t) in steady state for the…

A:

Q: 2. Which type of multiplexing can not be used for Analog signalling? a) FDM b) TDM c) WDM d) None 3.…

A: The given problem is from communication system.  The detailed solution is given in the next step

Q: The upper critical frequency of a particular op-amp is 100 Hz. What is its open-loop 3 dB bandwidth?

A: Given data, Upper critical frequency fu=100 Hz.

Q: An air filled parallel-plate capacitor is connected to a 12 Volts battery, the battery is…

A:

Q: Find the equivalent inductance looking into the terminals of the circuit. Take L = 8 H. 10 H m 9H m…

A: Lseries= L1+L2+......1Lparallel=1L1+1L2+1L3+1L3+......

Q: Consider the RC circuit in the figure. Take R = 10. + V₁ 10 R 20 nF + V₂ Calculate the phase shift…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: Problem 10.055.a - Thevenin equivalent of a phasor circuit Find the Thevenin and Norton equivalent…

A: We need to find out the thevenin equivalent and norton equivalent circuit for given circuit.

Q: Problem 10.003 - Nodal analysis in circuits with voltage sources Calculate the output voltage vo(t)…

A:

Q: 11. Calculate the low frequency cutoff values due to the 3 external capacitances. Show your work and…

A: Given:

Q: A 440V, 4-pole, lap-wound DC series motor has 510 conductors in its armature. It has a combined…

A: Types of DC Machine Seperetely excited DC Machine Self excited DC Machine  Shunt DC Machine…

Q: An op amp integrator has R = 60 k and C= 0.04 μ F. If the input voltage is v¡= 10 sin 50t mV, obtain…

A:

Q: 1. Analyze the working and compare the signal conditioning circuit used in fluid level and relative…

A: An electrical circuit known as signal conditioning modifies a signal in order to get it ready for…

Q: -1 0 Problem 5: x= 2 0 1 0 i. == ii. Find the stability of the system Find the transfer function y=…

A: State space representation of a system is given it is asked to find the stability of the system and…

Q: 2. Explain working principle of 3-bit digital to analog converter.

A: Digital system is used for computer, control, communication, Instrumentation.  Analog signal is…

Q: Find the poles and zeros of the transfer function H(z) = 1 + 2Z−¹+2Z-² +Z-3

A: We need to find out the poles and zero for given transfer function .

Q: Find the closed-loop, optimal control law u*(t) in terms of the states x* (t) as u* (t) = -KLQRX*…

A: Given: Performance index:  J=∫0∞x12t+x22t+u12t+u22tdt. System equations:  x˙1t=x2t+u1t,x˙2t=u2t.…

Q: Reduce the system shown in Figure 1 to a single block represented by the transfer function. R(s)- G₁…

A:

Q: An air filled parallel-plate capacitor is connected to a 12 Volts battery, the battery is…

A: Given- 1st case: An air filled parallel plate capacitor is connected to Battery, V = 12 volts The…

Q: Required information Problem 04.050 - DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS Consider the…

A: Current Source A current source, as the name implies, is a circuit element that maintains a constant…

Q: Calculate values of asked physical quantities of the circuit: I need resistance when voltage is 36V…

A: The voltage in the circuit is 36 Volts The current flowing through the circuit is 3.4 A The…

Q: Required information Problem 05.001 - DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS The equivalent…

A: The given problem is from operational amplifier. The detailed solution is given in the next step

Q: Required: 1. Draw a k-map table based on the logic/truth table above. 2. Group the implicants (those…

A: The given truth table has 4 possible combinations and we can find the Boolean expression using…

Q: For R1=202, R2=430, R3-185, R4-480, R5=455, R6-170, V1-8 V & I1=2 A in the shown circuit, using the…

A:

Q: The current in a device has an equation of i(t) = 2t, fort > 0. What is the total charge that passes…

A:

Q: For Inductors connected in series, L₁= 10 mH, L2= 20 mH, L3= 40 mH. What is the total inductance?

A: it is given that: L1=10 mHL2=20 mHL3=40 mH

Q: A sine wave has a maximum value of 10 V. Its value at 450 is 450 VO 14.14 VO 7,07 VO 4.5 VO

A:

Q: Show the connection of a three-stage amplifier with gains of +10, -18, and -27. Use a 270-kΩ…

A: We need to design the circuit for given gain .

Q: Find the inverse value of F(s) = 2s+3 s(s+1)(s+2)

A: Given: F(s)=2s+3s(s+1)(s+2), To find: Inverse Laplace transform.

Q: A transmission line is being built to bring power to a remote community, which is 40 miles from the…

A:

Q: ship for an inductor find the inductor current i(t) for 0 < t < 2 s. Ass

A:

Q: (6) A 250 MVA, 25 kV, 3 phase synchronous generator has a synchronous reactance X, of 1.6 pu. It is…

A: Given: A 250 MVA, 25 kV, 3 phase synchronous generator has a synchronous reactance Xs of 1.6 pu. And…

Q: Calculate the output voltage vo for the op amp circuit given below, where /= 1 mA and R= 11 k.…

A: Note: Types of op-amp Inverting Op-amp Non-inverting Op-amp  The Ideal operational amplifier is an…

Q: Find, from the definition, I{eatu(t)}. е Sketch the spectrum. -

A: Fourier transform is used to convert time domain signal in to frequency domain.  Fourier series is…

Q: A 250 V dc motor has an armature resistance of 0.5 0. It is drawing an armature current of 25 A,…

A: Types of DC Motor Seperetely excited DC Motor Self excited DC Motor  DC Shunt Motor DC series…

Q: Required information The oscillation circuit shown below uses an ideal op amp, where R₁ = 130 k and…

A: Note: Types of Op amp Oscillators Hartley Oscillator Collpits Oscillator Wein bridge oscillator  RC…

Q: For resistance and inductance circuit connected in series, has the following values: Vsupply = 120…

A:

Q: The network in the figure is part of the schematic describing an industrial electronic sensing…

A:

Q: to the primary of a step-down transformer through a transmission line of impedance 1300 ohm. The…

A:

Q: F A,B,C,D) = ∑ (1, 2, 3, 8, 9, 10, 11,14)× d (7, 15) Use Karnaugh map and Quinn McKlausky Method.…

A:

Q: 3. Please consider the following circuit. a) Find lo using current division b) Determine Vo using…

A: The given problem is from circuits. The detailed solution is given in the next step

Q: Minimize the logic function  Y(A,B,C,D) =  ∑(0,1,2,3,5,7,8,9,11,14) . Use Karnaugh map. Draw logic…

A:

Q: A three-phase, three wire, CBA system with a line voltage of 120 Volt, has three impedances of 30…

A: Note: In R Load, the current voltage will be in phase In Inductive load, current lag voltage  In…

Q: use the ideal model to analyze the given circuit and determine the Q-Point 3k 2K M IMA lov VI D₁ K…

A:

Q: Explain the modifciation to be made to the schering bridge for the following situations: i) Hihg…

A: We have to explain the modifciation to be made to the schering bridge for the following situations:…

Q: Problem 10.040 - Superposition when sources have different frequencies Find the output current io in…

A:

Q: Given the impulse response of a DT-LTI system h(n) = -3(0.8)"u(n) a.) Find the magnitude and phase…

A:

Q: If the below circuit has R = 150 £2, fo = 44,000 Hz, and ß = 5,000 Hz. R A) Find the value of the…

A: Note: As per Bartleby guidelines we are supposed to provide solution for first three sub-questions,…

Q: 9. In a circuit with a 12 volt supply and 40 resistance, the power consumed is watts.

A: Given data, Supply voltage V = 12 V. Resistance R=4 Ω.