(1)%

Q: A silicon p'-n junction having Np = 5 x 101 cm", n; = 10:0 cm", e, = 11.7 has a critical electrical ...

A: For calculating breakdown voltage we have to use formula. All the necessary values are given in the ...

Q: 2Ω 10 V

A:

Q: The setup for controlling a radio telescope dish is shown in Figure Q2. The desired angular position...

A:

Q: The unit kPa means a) 1000KN/mm b) 1000N/mm c) 100 2.

A: According to question:

Q: 4.34 Some radio systems suffer from multipath distortion, which is caused by the existence of more t...

A: (a) Transfer function of channel- Given, output of channel is xt=a1 st-t01+a2 st-t02 By taking Fouri...

Q: hen electric current passes through the circuit part in the figure, the power consumed in the resist...

A: Given data : R1=5ΩR2=7ΩP1=20W

Q: 16N 10 V 5 V

A: We need to find out thevenin equivalent voltage for given circuit.

Q: Design a Butterworth digital IIR lowpass filter using bilinear transformation by talking T=0.2 secon...

A: Given: The specifications for the digital filter is given as: 0.8≤Hejω≤1, for 0≤ω≤0.4πHejω≤0.3, for ...

Q: ZL impedance for maximum average power transfer in the circuit shown in Figure 2 and find the value ...

A:

Q: Q5/A/ Calculate the maximum and minimum current in this conditions,(1- have maximum transmission, 2-...

A: Given :Characteristic impedance=50 ΩApplied power=50 Wi) Have maximum transmission :For, maximum tra...

Q: 3. ) Given an discrete-time system transfer function using Z-Transform 2.5z H(z) = z² - 2z + 0.75 wh...

A:

Q: Note: All question solutions should be based on Ohm's Law and/or Kirchhoff's laws. A: Determine vo a...

A: Given :   In the given question they have mentioned an electrical circuit and they want to know the ...

Q: 4.34 Some radio systems suffer from multipath distortion, which is caused by the existence of more t...

A: (a) Transfer function of channel- Given output of channel- xt=a1 st-to1+a2 st-to2 By taking Fourier ...

Q: d. For each of the systems shown below, decide whether the statements YZ and [Y+Z]-YZ are true or fa...

A:

Q: a) A 600KVA, single phase transformer when working at unity power efficiency 92% at full load and al...

A:

Q: We wish to connect a 6 kVA, 120/240 V transformer as an autotransformer to a 120 V source to supply ...

A: Transformer is static device which work on Faraday's Law of electromagnetic induction. The secondary...

Q: Explain Faraday's second law of electromagnetic induction in layman's terms. Briefly discuss & provi...

A:

Q: For the network of figure below, if the mid- band voltage gain is (-2.47), answer the following: a. ...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts fo...

Q: 95A. Draw the ASK signal waveform of the following: (Assume carrier amplitude A, and frequency f.) U...

A: (i)

Q: Answer and analyze the circuit by using  KVL and KCL  : Observe the numbering 1. Circuit that is pl...

A: Given that

Q: note: the subject is: inverse z-transform

A: According to question:  

Q: When electric current passes through the circuit part in the figure, the power consumed in the resis...

A: Given: R1=5 ΩP1=20 WR=7 ΩV=100 ml=0.1 LT1=22°CT2=25°C

Q: a)discuss the equivalent circuit and slip in a single-phase motor.

A: We are authorized to answer one question at a time ,since you have not mentioned which question you ...

Q: c) Enumerate advantages suspension tower has as compared to other transmission line supports.

A: In an electric power transmission line, a suspension tower is where the conductors are simply suspen...

Q: For the network of figure below, if the mid- band voltage gain is (-2.47), answer the following: a. ...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts fo...

Q: Fast Answer please A balanced ∆ connected load with impedance 63 + j216 Ω⁄∅ 50∠0 ° Ω⁄∅ It is co...

A: Given impedance of ∆-connected load Z∆ =63+j216Ω/phase Its equivalent star connected load is Z∆-Y = ...

Q: For the network of figure below, if the mid- band voltage gain is (-2.47), answer the following: a. ...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts fo...

Q: In the circuit shown G, and the power p. calculate the current i, the conductance 30 v (+ 5 k2

A:

Q: 10)When the gain 'k' of a system is increased, the steady-state error of the system: increases. rema...

A: Given that  When the gain 'k' of a system is increased, the steady-state error of the system.

Q: 24. SHL is equal to SAL. a. True b. False

A: The SHL (shift left) instruction performs a logical left shift on the destination operand, filling t...

Q: Resistors are said to be connected in series when two circuit elements connect at a single branch Se...

A: Choose the correct options What is series connection ? Check the given statment is true or false?

Q: The null bandwidth for the system with an impulse response h(t)3rect ((t-0.02)/0.01) Select one: O a...

A: The null bandwidth for the system with an impulse response h(t)=rect ((t-0.02)/0.01)

Q: ) Differentiate between the power sector regulation and deregulation, and give examples

A:  Differentiate between the power sector regulation and deregulation are as, Regulation: The act of i...

Q: .Determine the rms value of the voltage waveform in Figure 10. v (t) 2 2 t (s) Figure 10

A: We need to calculate RMS value for triangular waveform .

Q: Q2) For the dc and ac load lines of transformer-coupled class A transistor characteristic shown in F...

A: BJT and MOSFET are the class of transistors used in analog electronics. They are widely used nowaday...

Q: 2 mA and VCEO 10 V, determine R, and Re for the %3D Given that Ico %3D network of Fig. 4.60.

A: To solve above problem, one should know about DC analysis of BJT. DC analysis of transistor is done ...

Q: Discuss the method and process in digital communication that said  Analog information sources can be...

A: According to the question we have to discuss the method and process in digital communication that sa...

Q: Ohm's law describes the relation of energy and power dissipated by an element. Select one: True Fals...

A: Ohm's law  states that the voltage across a conductor is directly proportional to the current flowin...

Q: Q5) discuss two only : a) the frequency of an alternator. b)what is the disadvantages of split phase...

A: Solution: According to the question, we have to discuss any of the two parts hence we are here discu...

Q: Q5/A/ Calculate the maximum and minimum current in this conditions.(1- have maximum transmission, 2-...

A:

Q: The diode laser is produced by (15 radiative recombination of electrons * ?injected true O False

A: Given :   In the question they want to know whether in the laser diode we have  radioactive or non r...

Q: A 3-phase, star-connected ,220V,6-poles,induction motor has the following constants: (R1=0.32),(R23D...

A: Given, 3-phase, star connectedPoles=6VL=220VR1=0.3ΩR2=0.15ΩX1=0.5ΩX2=0.2ΩXm=13ΩS=0.02Total losses=10...

Q: Calculate the phasor currents I and Iz in the circuit -j42 12/0° V js a3 E J62 (1, 122

A:

Q: The circuits branch is defined as: Select one: a. a single path in a network, comnposed of one sourc...

A: In this question we need to choose a correct option.

Q: Q1. Differentiate: - • Synchronous and Asynchronous sequential circuits • D-Flip Flop and T-Flip

A: Given that Differentiate:  • Synchronous and Asynchronous sequential circuit • D-Flip Flop and T-Fli...

Q: Kirchhoff's voltage law (KVL) states that the sum of all voltages in a circuit equals zero. Select o...

A: KVL states that algebric sum of voltages around any closed loop is zero

Q: 11.AND CX,FFF1H will perform: a. Clears bits 1, 2, and 3 b. Set bits 1, 2, and 3 c. Invert bits 1, 2...

A: The question wants to know what does the operation: AND CX, FFF1H will perform. Here , we see that t...

Q: Q2) A single phase( 220v),50HZ, 1410 r.p.m, 4-pole induction motor has the following parameters :- {...

A: In the circuit, Single phase 220V, 50Hz, 1410rpm Has all parameters are given. Find the current of t...

Q: to V, - Z2 Z3 6- j82 4 +j3 2 Ω 4 + j0 2 AI 100 Z0°

A: Given circuit shown

Q: A silicon p'-n junction having Np = 5 x 106 cm", n; = 1010 cm", e, = 11.7 has a critical electrical ...

A: It is given that, The concentration of electrons in the donor energy state ND: ND=5×1016cm-3ND=5×101...

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.