2- A rectangular gate AB in Fig is I m long and 1.Sm wide into the paper. hinged at A, and resting on a umoothbottiom at B. The Glycerin of s-0.89 acting on the left of gate, What the dapth of water a will asting on gate?WaterGlyceria60

Answered: Image /qna-images/answer/24410ff9-ea51-479f-b90d-b87dac295116.jpg

2- A rectangular gate AB in Fig is Im long and 1Sm wide into the paper. hinged at A. and resting ona mooth bottom at B. The Glycerin of s-0.59 acting on the left of gate, What the dapi of water a will asting on gate? Vater Glyceria 60°

2- A rectangular gate AB in Fig is Im long and 1Sm wide into the paper. hinged at A. and resting ona mooth bottom at B. The Glycerin of s-0.59 acting on the left of gate, What the dapi of water a will asting on gate? Vater Glyceria 60°

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter3: Transient Heat Conduction

Section: Chapter Questions

Problem 3.37P

See similar textbooks

Related questions

Q: A cylinder shown in fig. has diameter (25mm) height (300mm) and relative density (R.D=7.85). The…

Q: Gate AB in Fig. is a quarter circle 10 ft wide into thepaper and hinged at B . Find the force F…

A: Given data: Width of the gate = 10 ft Weight of the gate =3000 lbf Weight density of water, γ = 64.2…

Q: A glass tube of intemal diameter 3 mm is immersed in mercury. The angle of contact of mercury with…

A: Given that, d=3 mm=3×10-3 mσ=0.48 N/m

Q: A cylindrical container of 0.18 m and length 0.5 m has water s container, in kN.

A: ANSWER=100.1kN

Q: Gate AB in Fig. is a homogeneous mass of 180 kg,1.2 m wide into the paper, hinged at A , and…

Q: 8 ft ---. hup 4:5 fx cig. a fX

Q: A) Gate AB in Fig. (4) is 6 m wide and weights 2 tons. It is hinged at B and rests against a smooth…

Q: 47 Two chambers with the same luid at their base are separated by a piston whose weight is 25 N, a…

A: Note:- As per our guidelines we are supposed to answer only one question. Kindly repost other…

Q: Question 1a) A 4m wide flat plate is submerged such that its top horizontal edge is at the surface…

A: Problem 1 (a) The data given is, Density of water, ? = 1000 kg/m3 Height of bottom surface from…

Q: A glass tube of internal diameter 3 mm is immersed in mercury. The angle of contact of mercury with…

Q: In a container, the lower part of it contains water, while the upper part contains oil, as shown in…

Q: The bottom of a steel "boat" is a 7 m ✕ 8 m ✕ 5 cm piece of steel (ρsteel = 7900 kg/m3). The sides…

A: Givendimensions of steel =7m×8m×0.05mρsteel=7900kg/m3

Q: A layer of gasoline floats on a 88 cm's of water in a tank. The pressure reading at the bottom of…

A: Let us take height of Gasoline as hg. Consider below figure: From the data given in question: hw =…

Q: A open tank containing water (see figure) has a circular door AB with radius of 5 ft, inclin at an…

Q: An open tank has a vertical partition and on one side contains gasoline with a density of 840 kg/m3…

Q: The gate shown in the figure is used to contain the water in a reservoir. The gate is hinged at B…

Q: Problem 3-111 A block weighing 125 pef is 1 ft square and 9 inches deep floats on a stratified…

A: This problem is related to fluid mechanics. Fluid mechanics is a subject of mechanical engineering…

Q: 3. A 50-ton, 6-m diameter hemispherical dome on a level surface is filled with water as shown in…

Q: FThe gate shown in fig.1 is in equilbrium.Compute W, negelecting the mass of the gate? 2m Hinge 45…

A: Given information: Width of gate = 2m Height of gate = 1m angle of inclination of gate = 45o

Q: A trapezoidal plate shown in the figure is submerged in water is 3.3 m below the surface. The bases…

A: Givenh=3.3mb1=3mb2=8md=10mγ=9.75 kN/m3

Q: A glass tube of internal diameter 3mm is immersed in mercury. The angle of contact of mercury with…

Q: Triangular gate having a horizontal base of 1 30 m and an altitude of 2 m is inclined 45 o from the…

Q: 0.22wm CYLDER Lm CYLINDER ANCHOR

Q: The width of the rectangular gate of AB (Figure 5), Ball joint 4 m which is hinged from the point of…

A: m=1228 kN

Q: tank holds water (density of 995.7 kg/m3) with a triangular gate located at the bottom right. The…

Q: wchat A square plate of side 3 m with apex facing vertically up wards having circular hole of 2 m…

A: We have to find, Total pressure force, P and Centre of pressure, h¯ Given: Diameter of hole, d=2 m…

Q: A tank holds water (density of 995.7 kg/m3) with a triangular gate located at the bottom right. The…

A: Given data, Density of water, ρ=995.7 kg/m3 Base of triangle, b=0.7 m height of triangle, h=1.4 m…

Q: micircular gate with a radius R 5 ft is hinged along B and held by a horizontal force applied at A.…

A: Given:R= 5 ftH=40 ftF=200032 lbf

Q: A square plate is submerged in water as shown below. Set up an integral to find thehydrostatic force…

A: Write the expression of pressure. P=δdHere,δ=specific weightd=depth From the given diagram, the…

Q: Hydrostatic Pressure and Force (a) A rectangular daan 20 n high and 10 in wide, Assning p= 1000 kg/m…

Q: b) A 3-m-high, 5-m-wide rectangular gate in Figure 2 is hinged at the top edge at A and is…

Q: A vertical wall separates two different fluids in an open tank. The right side of the tank contains…

Q: 1- A 60 cm square gate has its top edge 12 m below the water surface. It is on a 45 angle and its…

Q: Gate ABC in Fig. is 1 m square and is hinged at B .It will open automatically when the water level…

A: The gate will open when the hydrostatic force F on the gate above B. That is when…

Q: Q1-The gate shown in fig.1 is in cquilbrium.Cempute W, negelecting the mass of the gate? 2m Hinge…

Q: blä 5 In fig find the force on the gate ?h=D1.5 m, the gate is square = 2 m Water Çentroid Center of…

A: Given:h=1.5 mw=2 m

Q: A cylindrical tank contains 1.0m of mercury (SG-13.6) and 3.0m of water. To look into the tank. a…

A: Given dataHeight of mercury in the cylindrical tank hm= 1mHeight of water in the cylindrical tank hw…

Q: A trapezoidal plate shown in the figure is submerged in water is 3.1 m below the surface. The bases…

Q: #6 A vertical submerged gate 0.5 m wide and 2.5 m high is hinged at B held closed by water as shown.…

Q: 1- A 60 cm square gate has its top edge 12 m below the water surface. It is on a 45 angle and its…

A: Dear student as per the policy i can solve only one question so here i solved first question for you…

Q: . If the length of the column of mercury was (6 cm) in the triple point of water, how tall would it…

Q: Consider a U-tube mercury manometer oriented vertically. One end is completely sealed with a total…

A: Given Data: The density of mercury is ρHg=1.36×104 kg/m3 The value of atmospheric pressure at…

Q: When a 5-lbf weight is placed on the end of the uniformfl oating wooden beam in Fig. P, the beam…

A: The total wood volume =(4/12)29=1ft3 h=9tanθ The vertical forces…

Q: m3 CUBICAL TANK IS FULL OF TWO DIFFERENT FLUIDS OF EQUAL PARTS ECT WAS THROWN AND WAS PARTIALLY…

A: given: specific gravity of liquid first =0.82 specific gravity of liquid second=0.9 height h=3m

Q: A triangular plate shown in the figure is submerged in oil, specific gravity = 0.85, 4.52 m below…

Q: A square plate of side 3 m with apex facing vertically up wards having circular hole of 2 m diameter…

Q: Find the vertical force acting on the semi-cylindrical dome shown in figure, when gage A reads 58.3…

A: Given data PA=58.3kPa l=1.83m d=0.61m

Concept explainers

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.

Question

2- A rectangular gate AB in Fig is I m long and 1.Sm wide into the paper. hinged at A, and resting on a umooth
bottiom at B. The Glycerin of s-0.89 acting on the left of gate, What the dapth of water a will asting on gate?
Water
Glyceria
60

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1.72 An ice chest (see sketch) is to constructed from styrofoam . If the wall of the chest is 5-cm thick, calculate its -value in . Problem 1.72
A hollow steel sphere has outer radius Ro = 0.5 m. What is the inner radius that would make the sphere neutrally stable? Does it matter if the inside of the sphere is flled with air or not (i.e., a vacuum)?
A piece of cork having a specific weight of 2.36 kN/m 3is shaped as shown in Fig. 5.32 . (a) To what depth will itsink in turpentine (sg = 0.87) if placed in the orientation shown? (b) Is it stable in this position?
Read the question carefully and give me right solution according to the question. Note : Figure not given. The top portion of an equilateral triangle is a light material (foam) with specific weight of 1.57 kN/m3. Compute for the height (in meters) of the bottom material if its specific weight is 20 kN/m3 and 20 cm of the foam is above the salt water (sg=1.03)?
A glass tube of internal diameter 3 mm is immersed in mercury. The angle of contact of mercury with glass can be taken as 130°. What will be the level of Hg in the tube relative to the free surface of the liquid outside the tube? Take surface tension of liquid = 0.48 N/m.
Please be xlear and detailed with your answer. Write an explanation in every formula and solution you used. Problem: A Triangular gate having a horizontal base of 1 30 m and an altitude of 2 m is inclined 45 o from the vertical with vertex pointing upward The base of the gate is 2 70 m below the surface of oil s 0 80 What normal force must be applied at the vertex of the gate to open it? Show figure
A glass tube of internal diameter 3mm is immersed in mercury. The angle of contact of mercury with glass can be taken as 130°. What will be the level of Hg in the tube relative to the free surface of the liquid outside the tube? Take surface tension of liquid = 0.48 N/m.
Gate AB in Fig. is a quarter circle 10 ft wide into thepaper and hinged at B . Find the force F just suffi cient tokeep the gate from opening. The gate is uniform andweighs 3000 lbf.
A three-eighths circle is the curved gate as shown in fig. 3, 3 m wide into paper, hinged ta D, and resting against a smooth wall at C. determine the result force acting on the gate. *
A man weighing 64 kg causes a flat area 30 cm thick to be just fully submerged in sea water (SG 1.03) . Neglecting weight , the area must be?
Solved already on c.h.egg
The bottom of a steel "boat" is a 7 m ✕ 8 m ✕ 5 cm piece of steel (ρsteel = 7900 kg/m3). The sides are made of 0.480 cm thick steel. What minimum height must the sides have for this boat to float in perfectly calm water? (Answer in cm, thanks)