2) In the above circuit, the gap diode is connected to the output voltage and the trigger angle (α) is 75°and given that Vm = 100 V, find the following. d) FF, HF

Q: For the diode circuit shown, determine the transfer function ve(1)/vi(t) for I 100μΑ. %3D ImA Vo(t)…

A: The circuit can be solved with the help of both DC and AC analysis of diodes. The small-signal…

Q: For the given circuit for a 40 V (p-p) sinusoidal input vi, what is the value of vi at which the…

A: This circuit is positive clipping. Find the input voltage when circuit is beginning to clipping.…

Q: Calculate the dc and ac resistances for the diode of Fig. 15 at a forward current of 10 mA and…

A:

Q: Given: The input to a voltage regulator circuit varies from 10.4 to 11.2 V. The load voltage is to…

A:

Q: 33. A series circuit is composed of a 9 V battery, a diode, and a 1000-ohm resistor for a forward…

A:

Q: sinusoidal input vi, what is the value of vi at hich the clipping begins? V=5V. NOTE: use * ideal…

A: Given that Vpeak-peak =40v                                      Vpeak= 20v Also given that V=5v…

Q: (a) Draw the waveform at the output if R=100KN, Io = luA from the diode. %3D

A: According to company guidelines, only the first question will be solved for multiple questions. If…

Q: Tilt of the output waveform for the circuit is 1%. Given that input is a square wave ± 10 V, f = 2…

A: Given: Tilt of the output waveform is 1%. Input is a square wave of maximum and minimum amplitude…

Q: The load voltage and diode power of the * following circuit are RTH 2 kQ 2-D APPROXIMATION RL VTH 12…

A: In this question,  A circuit is given Find the load voltage and power in the diode?  We know using…

Q: In a bridge-type full-wave rectifier with capacitor filter produces an output voltage with a peak…

A: The capacitor output DC voltage of the full-wave bridge rectifier is known. The ripple factor is…

Q: 27. A series circuit is composed of a 9 V battery, a diode, and a 1000-ohm resistor for a forward…

A:

Q: 1- Design a clipper circuit that can pass only the positive values (V22V) of a sinusoidal input…

A:

Q: For the given circuit for a 40 V (p-p) sinusoidal input vi, what is the value of vi at which the…

A: Due to guidelines we can solve one question at a time .

Q: What is the output voltage across a load resistor if it is paralleled with a forward biased silicon…

A: Diode will forward bias . So output voltage for load will cut in voltage .

Q: 3. In a bridge-type full-wave rectifier with capacitor filter produces an output voltage with a peak…

A: Given: Peak voltage, Vp=48 V Load, RL=500 Ω Ripple factor, γ=8% To find: Value of capacitor

Q: A germanium diode is connected to a load resistance of 1.5 kQ and is supplied with 12-V such that…

A:

Q: For the following input v; and V= 10V. a) Draw V. on the same vertical axis of input voltage Vị. b)…

A: Ge diode ;cut in voltage =0.3when VD>0.3 → diode is ONVD<0.3 → diode is OFF

Q: 2. In the emitter follower discussed in the lectures, the output (emitter) voltage is 0.7V below the…

A: Given: Vi=2 V β=100 VCE(sat)=0 V VBE(ON)=0.7 V To find: a) VB and Vo b) Verify assumed stateof BJT…

Q: For the diode circuit shown, determine the transfer function ve(1)/v(t) for I = 100µA. HE Vom DI C2…

A:

Q: he output voltage Va of the following circuit during the positive half cycle considering ideal diode…

A: During the positive half cycle as the 20volt potential is applied then Capacitor gets charges…

Q: For the diode circuit shown, determine the transfer function ve(t)/v(t) for I 100HA. %3D ImA Vo(t)…

A:

Q: 2. In the emitter follower discussed in the lectures, the output (emitter) voltage is 0.7V below the…

A: The given circuit diagram  is shown below: The given graph is shown below:

Q: A diode noise generator is required to produced 10Uv of noise in receiver with an input impedance of…

A:

Q: Given Vi=20V peak-to-peak, draw the output wav eform for the said clamper circuit below: Vi Vo 5V…

A: The clamper circuit is shown below:  The above clamper circuit is a positively biased clamper…

Q: 2.3 The reverse recovery time of a diode is trr both (a) the storage charge QRR and (b) the peak…

A: QRR v/s rate of fall of the diode and IRR V/S rate of fall of the diode is plotted determined

Q: Vi Diode is ideal draw the output waveform. +10 0.1 µF 56 k2 V. V,= 10 V Find time constant T and…

A: Diode is used in wave shaping device. Total swing in output of clamper circuit is same as total…

Q: 4.36 Use the iterative-analysis procedure to determine the diode current and voltage in the circuit…

A:

Q: A silicon pn junction diode has an emission coefficient of n =2. The diode current is 1 mA when VD…

A: Given that n=2 ID=1 mA VD=0.7V (a)  Formula for reverse saturation current is given by…

Q: 1. To forward-bias a diode, a. an external voltage is applied that is positive at the anode and…

A: In forward bias condition diode is represented in below figures.

Q: The input voltage Vi of the following circuits is a triangular signal with an amplitude of 18Vpp,…

A:

Q: 2) In the above circuit, the gap diode is connected to the output voltage and the trigger angle (α)…

A: Solution b)- Given data-  Maximum voltage Vm=100 voltTrigger angle α=75° Calculating…

Q: Q3) The boost converter has parameter Vs. = 20 V, R = 12.5 N, L=10 µ H, C =40 µ F, and the switching…

A: There are AC and DC supplies available. Different loads have different requirement of voltages.…

Q: Determine the noise current for a vacuum tube diode with a forward bias of 1 mA over a 100 kHz…

A: It is given that: Idc=1mA∆f=100kHz

Q: Home Work: J- Design a clipper circuit that can pass only the positive values (V22V) of a sinusoidal…

A: Due to guidelines we can solve one question at a time.

Q: For the given circuit for a 40 V (p-p) sinusoidal input vi, what is the value of vi at which the…

A: Given a clipper circuit with peak to peak voltage =40 volts V=5 volt and Diodes are ideal.

Q: For a diode with Vy 0.7 v , rf = 10 Q , as ID increase , then Vy O increase decrease O unchanged O…

A: Vy is built in potential which doesn't depends on applied current

Q: A 4-layer diode turns on when the anode-to-cathode voltage exceeds 0.7 V O The gate voltage the…

A: Here is the explanation

Q: For the given circuit for a 40 V (p-p) sinusoidal input vi, what is the value of vi at which the…

A: Diode to conduct Voltage at p dide of diode should be  Vi-5<0

Q: 3. In a bridge-type full-wave rectifier with capacitor filter produces an output voltage with a peak…

A: It is given that: Vcmax=48 Vγ≤8 %≤0.08RL=500 Ω

Q: Source V1 is the input voltage of the circuit shown below, and the output voltage is taken at the…

A: Observe the given circuit diagram and mention the nodes as shown in the figure given below. From…

Q: Q2) The buck-boost converter has parameter Vs = 12V, R = 10 N, L=10 µ H, C =20 µ F, and the…

A: Given Vs=12 V R=10 ohm L=10 uH C=20 uF fs=100 KHz for diode Ton =0.3 Toff

Q: Find the Q point value of the diode current and the voltage gain Av in the following circuit: 700Ω…

A: Diode  It is an unidirectional electrical device, which allows current to flow only in one specific…

Q: (b) Find the inductor current, I(t), when t > 0 in the following circuit. The switch is initially…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: 9. A series circuit is composed of a 9 V battery, a diode, and a 1000-ohm resistor for a forward…

A: We know Gallium arsenide diode Forward voltage is approximately equal to 1.2 V .

Q: Diode produces reverse current in the range of micro amps Select one: True False

A: Diode produces reverse current in the range of micro amps are:

Q: For the given circuit for a 40 V (p-p) sinusoidal input vi, what is the value of vi at which the…

A: For Diode to conduct voltage at its p side should be less than 0 Voltage at p side is Vp= vin-V

Q: For the diode circuit shown, determine the transfer function ve(t)/v(t) for I = 100µA. ImA Vo(t) DI…

A: This can be solved first by DC analysis and then AC analysis with the resistance in the small-signal…

Q: The peak electric field in a reverse-biased silicon pn junction is Emax= 3x 10^5 V/cm. The doping…

A: the peak electric field in a reverse biased silicon PN junction is E max = 3*10^5 V/cm. the doping…

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.