2 Ω 4 cos 20t V +21 4.7 Ω 100 mH Μ 2 Ω + Vx | 890 mF 1Ω

Q: a) Determine whether the transfer function is strictly proper or semi-proper. b) Calculate the poles…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.If you have…

Q: 6 Compute the convolution y(n) = x(n) * h (n) of the following signals and check the correctness of…

A: Given:To determine:

Q: Given the circuit below: Iin (w) († jwL ooo Tout (w) R₁ www R₂ 1 - jwC (a) Solve for the frequency…

A: Given Data:An AC three parallel branch circuit with,Input current Output current To Find:Transfer…

Q: Question A.4 A conductor of effective length 0.5 m is moved at an angle of 60 degrees to the…

A: Length of conductor l = 0.5 m.Angle of conductor with magnetic field Magnetic field Velocity v = 1.8…

Q: Q1 (ii) A light emitting diode (LED) with a forward voltage drop of 1.8 V, a resistor and a 6 V…

A:

Q: Ex: In Cylindrical Coordinates Let Pv=o P<\mm pv=2 sin (2000xP) n</m³ 1mm <p <1-5. Find for D…

A: A hollow cylinder which a charge density as a function of distance.

Q: X CLK T A B B' A' J K D C C' -'1' y Current State Input Flip-flop Excitation Inputs A в с X T J K…

A: Given sequential circuit isWe need to create state transition table along with flip-flop inputs and…

Q: A 6-pole wave connected armature has 200 conductors and runs at 1000 rpm. The EMF generated is 500…

A: Poles, .Wave wound, .Armature conductors, .Speed, .EMF generated, .

Q: 1: Calculate the power factor of a balanced 3-0 inductive load, if the readings of two wattmeters…

A:

Q: 10. In the circuit shown below, the opamp is ideal. V a. Find (s). E b. What conditions must exist…

A: According to the circuit diagram you provided, it seems to be an active bandstop filter employing an…

Q: A 170 kV 3-phase electric load draws 679 A that has a power factor of 90% lagging. What is the MVA…

A:

Q: 2- An FIR filter is described by the difference equation y(n) = x(n) + x(n-10) i) Compute magnitude…

A: Given dataThe difference equation is, ;We have to determine its magnitude and phase response.The…

Q: Problem 2:Find the inverse z-transform of Xz = when ROC is (ii) (iii) |Z| 3 -2<|z|<3 z+2z-3 using…

A:

Q: 5. Find the close-loop transfer function, T(s) = C(s)/R(s) for the system shown using block diagram…

A: given that a block diagram of the system is

Q: (B) A waveform d(t)=40sin(450t+35°) +40, is to be sampled periodically and reproduced from these…

A: For the given signal the maximum allowable time interval between sample values needs to be…

Q: What’s the difference between these two equations? As for single tone, would m(t) simplify to…

A: Amplitude modulation formula derivation for different cases.

Q: For the system as shown in the following figure, convert the components to same base voltage and…

A: The power system network is given we need to calculate and redraw single line diagram of base taken…

Q: A fault occurs at bus 4 of the network shown in Figure Q3. Pre-fault nodal voltages throughout the…

A: x=1y=7Note: reactance of element right to bus 4 is not given. Hence we will not consider that in…

Q: A steady current of 400 µA flows through the plane electrode separated by a distance dof 0.5 cm when…

A: The initial current and separation,The final current and separation,

Q: Given the block diagram of the system below: x[n] Z Ţ -1| N 2 (a) Determine the system function…

A:

Q: Using two D flip-flops only, Design asynchronous Counter. The Counter counts in the sequence 1, 6,…

A: Requirement:An asynchronous Counter using D-Flipflops to count the sequence of,1637...

Q: Circuits (2) :- Va= Um Cos (out) ia= Im Cos (wr_d) | Pa= Um Im Cos (wt) _ Cos (wt -d) | Pb = √m Im…

A: The above question is based on the power in a 3 phase balanced circuit.

Q: Write the mathematical expression for bandwidth efficiency of M-ary signals. Find the bandwidth…

A:

Q: "An infinitely long conductor is lying on x = 1, -infinity <= y <= +infinity, z = 0 (in meters).…

A:

Q: In the circuit shown below R1=220, R2-440 and R3=660 The voltage across R1 will most nearly be 12v+…

A: Circuit diagram is given as,

Q: Find the equivalent resistance in the following circuit. 12V A B D 4Ω 15Ω 7.4Ω 10.4Ω 5Ω 6Ω

A: We need to find the equivalent resistance of circuit?

Q: A diesel power station has the following data Fuel consumption/day = 1000 kg Units generated/day =…

A: It is given that:Fuel consumption/day = 1000 kgUnits generated/day = 4000 kWhCalorific value of fuel…

Q: A- A 10 kHz signal wanted to be sent and encrypted using FHSS with a factor of 10, if Af=5KHz…

A: FHSS stands for Frequency Hopping spread spectrum. It is a wireless communication technique where…

Q: A 762 KVA. 2200V. 50Hz.three-phase.star- connected alternator has an effective resisance of 0.6 ohm…

A:

Q: A generating station has 4 sections busbars. Bach section busbar has a generator connected to it of…

A: Each section busbar has a generator connected to it with a rating of 5000 KVA and a reactance of…

Q: A composite TV signal has a bandwidth of 40 MHz and is transmitted with a power of 0.1 W through a…

A: Bandwidth=40 MHz,Transmitted power=0.1 Watts,White noise has two sided PSD of 10-15 Watts/Hz.

Q: In cylindrical coordinates, let p = 0 for p 1.5 mm. Find D everywhere: ly

A: Electric/Displacement flux density Electric flux lines is always perpendicular to the displacement…

Q: A- A 10 kHz signal wanted to be sent and encrypted using FHSS with a factor of 10, if Af-5KHz…

A: FHSS stands for Frequency Hopping spread spectrum. It is a wireless communication technique where…

Q: Binary data is transmitted using ASK through a channel that adds AWGN with power spectral density…

A: here we have to find the amplitude of the received carrier signal.

Q: 12. For the VII characteristic shown in Fig. A, calculate the resistance of the load. V(V)* 60 40 20…

A: The V-I characteristic shown is,

Q: 6- Determine z- transform of the following signals ( (b) (c) - - (d) x(n) = u(n − 1) +2¹u(n − 1) —…

A: The above question is based on the Z transform of exponential signals and their region of…

Q: please show the calculation data in step 4 and step 5

A: More insight for steps 4 and 5 of the linked question has been provided here. The question is based…

Q: The LTI system (Linear time-invariant system) of digital signal processing is described by the…

A: To find the output response of the given LTI system with the input signal , we will use the…

Q: 5. It is required that at the crossover frequency of 4 rad/s, phase margin will be 60 degrees.…

A:

Q: 3.34 Obtain the transfer function of the circuit in Figure 3.31. 3.35 Consider the circuit shown in…

A: Given different circuits we have to calculate transfer function,current and impulse response.

Q: Reduce the block diagram to a single transfer function.

A: The transfer function needs to be obtained from the given block diagram by using the block diagram…

Q: -1 h) Determine the closed-loop transfer function of the following control system. R(s) + G(s) (($)…

A: For this given control system we need to find the closed- loop Transfer…

Q: Q1/ Find E at the origin if the following charge distributions are present in free space: point…

A: Given:-point charge, 12nC at P(2,0,6)Uniform line charge density, 3nC/m at x = -2, y = 3Uniform…

Q: An impedance of 20+j60 ohms is shunted by lossless capacitor of 50 ohms impedance. Find the input…

A: Given:An impedance of 20+j60 ohms is shunted by lossless capacitor of 50 ohms impedance.To find:Over…

Q: (a) Determine the heat energy required to convert 20 kg of water at 30°C completely to steam at…

A:

Q: 01- t K h e num, 11.85 A regular household system of a single-phase three- wire circuit allows the…

A: In this questionsWe need to determine the unknown currents as shown the circuit and also determine…

Q: draw this logic circuit ABC + AC' please do include the truth table

A:

Q: Find Vo in the following circuit

A: In this questionWe need to determine the value of output voltage Vo as shown the circuit. We are…

Q: - sketch the root locus for a unity feedback system that have G(s) = k(s²-9) (s²+4)

A:

Q: 0.5 F 0.5m(t) A 10 ΔΙΩ 아날 FIGURE 3.33 For Problem 3.36.

A: Given circuit:To determine:Expression for i0(t)