Solve via mechanical energy balance equation Table 2.1. Roughness of Clean Pipe²€, mmPipe materialRiveted steelConcreteWood staveCast ironGalvanized ironAsphalted cast ironCommercial steel or wrought ironDrawn tubingGlassPlastic (PVC, ABS, polyethylene)1-100.3-30.2-10.26 (0.25) ¹0.15 (0.15)0.12 (0.13) b0.046 (0.043)0.001500"Adapted from Fischer and Porter Co., Hatboro, PA,Catalogs section 98-A (1947).Values in parentheses from Colebrook (1939). 2.A fire truck is sucking water from a river and delivering it through a longhose to a nozzle. The total length of the galvanized iron hose corrected for valves,fittings, entrance, etc. - is 90 [m]. The energy provided by the fire truck for pumpingthe water is 53 [kJ/kg].What diameter is needed for the hose to provide an average velocity of 30 [m/s]?riverII30 [m]pump16

Given: In this question, the given details are, A fire truck is sucking water from the river and…

2. A fire truck is sucking water from a river and delivering it through a long hose to a nozzle. The total length of the galvanized iron hose- corrected for valves, fittings, entrance, etc. - is 90 [m]. The energy provided by the fire truck for pumping the water is 53 [kJ/kg]. What diameter is needed for the hose to provide an average velocity of 30 [m/s]? river 30 [m] pump

2. A fire truck is sucking water from a river and delivering it through a long hose to a nozzle. The total length of the galvanized iron hose- corrected for valves, fittings, entrance, etc. - is 90 [m]. The energy provided by the fire truck for pumping the water is 53 [kJ/kg]. What diameter is needed for the hose to provide an average velocity of 30 [m/s]? river 30 [m] pump

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Thirty (30) liters/second of stream water must be pumped up a vertical height of 12 meters to irrigate a farm. If head loss in casing and pump results in 62% pump efficiency and the electric motor used has 91% efficiency, what horsepower rating should the motor have and how many kilowatts will it use while pumping? GIVEN: q=30 l/s 0r 108 cu.m/hr h=12 m ME=91% PE=62% density of water =997 kg/cu.m
pump discharges 1129.52 kg/min of water to a vertical tank (10ft dia by 15 ft height). Find the total time (in minutes) the tank will be 3/4 full.
A 1⁄2-horsepower (372.85-watt) compressor motor has 3.24 amperes ofcurrent flowing through it when running. What voltage is supplying the currentto this motor?
9.The pump shown delivers 115 li/s of oil, sg = 0.84, toreservoir D at elevation 72 m. The energy lost in thesuction line is 3.2 J/N and in the discharge line is 7.6 J/N. a.Compute the total head added by the pump. b.How many kW does the pump supply the system? c.If the pump is 85% efficient, how much power does it need?
Show complete solution. Units must be included in all calculations. All numerical values should be rounded off to the nearestthousandths. 6.A standpipe 20 ft in diameter and 40 ft high is filled with water. Calculate the potential energy of the water if theelevation datum is taken 10 ft below the base of the standpipe.
A pump draws 52 lit/sec of water from reservoir A to reservoir B as shown. Assuming f = 0.041 for all pipes, compute the horsepower delivered by the pump Elevation of reservoir A = 13 m Elevation of reservoir B = 89 m Pipeline 1 : 236 mm, 712 m (diameter, length) Pipeline 2 : 156 mm, 1595 m (diameter, length) Round your answer to 3 decimal places.
Convert the following air pressure readingsfrom cm H2O to Pa.a. 1.5 cm H2Ob. 3.7 cm H2O
9.4.2 Bernoulli Equation Example 9-407 The Orifice Origin: Textbook Compute the velocity of the water through an orifice that is draining a 10-m high tank.
24. Reservoir A and B have elevations of 100 m and 160 mm respectively. A pump is installed near reservoir A to pump water from A to B. The rate of flow in the pipes is 650 L/s and the pipe length of 1000 m with a diameter of 600 mm. If C= 120 what is the Energy added by the pump?76.1 m56.5 m87.3 m68.2 m
Ball A is released from rest at height 85m at the same time that a second ball B is thrown upward from a distance 2m above the ground. If the balls pass one another at a height 25m.(a) Determine the speed at which ballB was thrown upward. (b) Determine the speed of ball Bwhen the balls pass one another (c) Determine the total time of travel when the balls pass one another. acceleration due to gravity = 9.81m/s2
The water system in a suburban area consists of an old 9-inch pipeline 2392 ft. long which conveys water from a pump to a reservoir whose water surface is 332 ft. higher than the pump. Water is pumped at the rate of 2.86 cfs. Determine the horsepower saved by replacing the old pipe with a new 13-inch pipe. Assume the values of f as equal to 0.042 and 0.016, respectively, for the old and new pipes. Neglect losses of head except friction head.
The water system in a suburban area consists of an old 8-inch pipeline 2,500 ft. long which conveys water from a pump to a reservoir whose water surface is 350 ft. higher than the pump. Water is pumped at the rate of 2.5 cfs. Determine the horsepower saved by replacing the old pipe with a new 10-inch pipe. Assume the values of f as equal to 0.033 and 0.022, respectively, for the old and new pipes. Neglect losses of head except friction head. Round your answers in 2 decimal places.