2. Find the equivalent capacitance (in terms of C), Ceq, as seen by the voltagesource, v(t) (assume all the capacitors have the same capacitance, C).i(t)CCv(t)CCCCC 4. The circuit is at steady state before the switch transitions from closed to open attime t= 0. The output of this circuit is v(t), the voltage across the capacitor.Determine v(t) fort> 0.t = 010 kQ30 kQ4 V(*20 kO2µFvli)2 Vi(t)

The given circuit is shown below.We need to calculate the equivalent capacitance (in terms of C), as…

Answered: 2. Find the equivalent capacitance (in…

2. Find the equivalent capacitance (in terms of C), Ceq, as seen by the voltage source, v(t) (assume all the capacitors have the same capacitance, C). i(t) 1+ v(t) C C C HE C C C C

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the...

See similar textbooks

Related questions

Q: In the circuit of the figure below, the switch S has been open for a long time. It is then suddenly…

A: In this question, We need to determine the time constant before the switch closed and after switch…

Q: 4H Q.13: For the circuit shown, calculate the current in each branch and the consumed power in each…

A: Magnetic coupled circuits:

Q: A transmission line has the following per-unit-length parameters: L = 0.5 µH/m, C = 200 pF/t R = 4.0…

Q: Final Project Design a 3-Bit Synchronous Irregular Counter in a given sequence. The sequence is…

A: According to the question, we need to design a 3-bit synchronous irregular counter for the given…

Q: Q5)The full wave-controlled bridge rectifier has an ac input of 120 V rms at 50Hz and a 202 load…

A: The given rectifier is a full-wave controlled bridge rectifier, the RMS current is given by the…

Q: For a causal discrete-time LTI system, it is observed that the input signal x[n] = ("u[n] produces…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: If the switch in the circuit has been closed for a long time before t = 0 but is opened at t= 0,…

Q: For the magnetically coupled circuit shown, find the values of coupling coefficient "k" when the…

Q: 12. Develop the simplest Boolean expression for the Karnaugh map below, a) graphically. b) by…

A: We need to solve the given k map .

Q: A balanced wye-delta system has a phase voltage of 108V RMS. Find the magnitude of the impedance…

Q: Question 2 In Figure 2, solve for V, by the Norton equivalent theorem. a R, { 40 R, $ 12 2 R, 12 a…

A: This question belongs to circuit theory . It is based on the concept of Norton's theorem . Have a…

Q: Q2: (40p) Find the energy density WE in free space for the region 2mm<r<3mm, 0 < 0 < 90, 0< 9 < 90,…

A: For free space permittivity is ε=εo aCalculating the electric field intensity due to the potentisl…

Q: AN-channel silicon (EG-1.1 eV) MOSFET was fabricated using N Polysilicon gate and the threshold…

A: The solution is given below

Q: For the given program shown below, LXI B, 2355 H LXI D, 5523 H LXI H, 3050 H ХСHG After execution of…

A: The above program is written in assembly language.

Q: Question 1 Show the Norton equivalent circuit and find IL. R, R,{ 12 0 R, { 40 20 V

Q: A square-wave voltage of amplitude E=100 V and frequency 60 Hz is applied on a coil wound on a…

A: The solution is given below

Q: C = 0.022 µF %3D Rp= 5 k) +15 V R- 1 kn 741 Vou -15 V

Q: Q3: For the maximum power transfer to 5KO 1KO (2000) resistor, find: 1. Turn ratio "n"? 1:n 30V 20KO…

A: The solution is given below

Q: Problem 1 Use Mason's formula to find the transfer function of the digital filter whose signal flow…

A: We need to find out transfer function for given system.

Q: A first order system is given by: ai + baæ = f(t), where a = 0.03, and b = 5. To 2 decimal places,…

A: The solution is given below

Q: Find vo) for all t>0 in the given circuit. Assume /= 3ult) A. 1Ω 10 7u(t) V 1 H 0.5 F The value of…

A: Circuit: The electrical circuit is the interconnection of the resistors, capacitors, inductors,…

Q: 8.36 Find n,(1) in the eircuit in Fig. PS.36. 100 0.1 H 0.005 F 100 cos 401 ( 40 cos (40f-30) V 0.2…

Q: A toroidal transformer has a square iron cross-section core as shown. In which direction can the…

A: Given, A toroidal transformer has a square cross section core as shown. Armature core are made of…

Q: Q4) If fr is the frequency of the fundamental component of the output ripple, then for full bridge…

A: In full wave bridge rectifier the time period of output signal is half of the time period of input…

Q: For the shown rms. ind the value of coupling coefficient "k" and put J60 J72 the dots on the coils,…

Q: Find the Thevenin equivalents to the circuits. R, R, a 12 V R2 V 12 V R, 3 2 0 R, (a) (b) Figure 1

Q: A circular conducting loop has diameter of 60cm,the value of magnetic field a point on the centre…

A: We need to find out magnetic field for given system

Q: e. Draw the phasor diagram of the currents I, IR. and Iz, and the voltage E. f. Find the current Ic…

Q: QI Sketch the input and output waveforms for a one-shot using a 555 timer triggered by a 10-kHz…

Q: The rod is kept in a magnetic field of B 0.048T as shown in the figure. Now if we move the rod at a…

A: The answer is option d .

Q: A 230 kV three phase 50 Hz line is shown in the figure.If the value of r-0.3 m then find the charge…

Q: How much resistance R1 must be added in series with a 100-0 resistor R2 to limit the current to 0.3…

A: Given circuit:

Q: , A line charge pi 4nE. C/m is located along the x-axis. Determine the potential difference VAB in…

A: We need to find out potential difference between A and B .

Q: subcarrier of 50 kHz is amplitude-modulated by tones of 1.4, 4.1, and 11.4 kHz. The resulting AM…

A: We need to find out number of frequency in modulated signal

Q: J52 K J82 For the circuit shown, find the value of coupling coefficient "k" and put the dots on the…

Q: 10. Step up transformers are a special type of transformer whose turns ration is 1 True False

A: We need to tell about whether the given statement is true or false.

Q: Test # Reading 1016 986 3. 981 990 1011 6. 1011 997 8 1044 9. 991 10 966 2. 4.

A: Test # Reading 1 1016 2 986 3 981 4 990 5 1011 6 1011 7 997 8 1044 9 991 10 966

Q: 8.31 Calculate v,( if i,() = 7 cos 100r A and i(1) = 3cos(1001 + 45") in Fig. P8.31. 10 iz(1) 1000 F…

Q: 3) f(t) = e', (0<t< 2x) Ans. F(s)=- -1 (1– s)(1-e 2")

A: We need to find out Laplace transform of given signal

Q: Page 1: 3 R1 6. 10kQ Simpson v 5.8537V VI 12v 7. 8. 6. R2 Simpnon meter 10 200k9 REFI A Simpson…

Q: : The Nyquist diagram for a control system as shown in Fig. 1. Im i-Find the system type ii-Describe…

A: Stability Criteria for Nyquist Plot N=P-Z N= Number of encirclement which closes (-1,0) Point…

Q: Q.33: For the maximum power transfer to 5KΩ 1KQ (2000) resistor, find: 1. Turn ratio "n"? 2. Maximum…

A: The solution is given below

Q: -1) + (1-e 2**) 0<t<T -TS 5) f(t) = Ans. π<t< 2r F(s)= %3D It -t

Q: 8.11 Find Z in the network in Fig. P8.11. ww j2n j21 Figure P8.11

Q: 2) Design a F.A using AND, OR, and NOT gate.

Q: A. Explain why a single-phase induction motor requires a means of starting. B. Explain the…

A: Types of Electrical Machine Transformer DC Machine Induction Machine Synchronous Machine

Q: A first order system is given by: ai + baæ = f(t), where a = 0.03, and b = 5. To 2 decimal places,…

A: The solution is given below

Q: 5. For the circuit shown in Figure C3 a. Draw the DC load line in the Graph C3 D. Calculate the Q…

Q: Q-1: For the transistor in Figure-1, determine: a- VCE when VIN =0 V. b- IB(min) if BDC = 125. с- RB…

Q: Given the electric field intensity, E = x²y°z²ax + x'y²e'ay +xyza, V/m, find the one W in moving a…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

2. Find the equivalent capacitance (in terms of C), Ceq, as seen by the voltage
source, v(t) (assume all the capacitors have the same capacitance, C).
i(t)
C
C
v(t)
C
C
C
C
C

4. The circuit is at steady state before the switch transitions from closed to open at
time t= 0. The output of this circuit is v(t), the voltage across the capacitor.
Determine v(t) fort> 0.
t = 0
10 kQ
30 kQ
4 V(*
20 kO
2µF
vli)
2 V
i(t)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given information.

VIEW

Step 2: Calculation process of the equivalent capacitance.

VIEW

Step 3: Calculation process of the equivalent capacitance.

VIEW

Step 4: Final calculation of the equivalent capacitance.

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 27 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the inductor, EL, is 104 V, and the circuit has a total impedance, Z, of 20 . The frequency of the AC voltage is 60 Hz. ETITZ20VAPFER78VIRRPEL104VILXLVARsLL
Assume that the current flow through the resistor, IR, is 15 A; the current flow through the inductor, IL is 36 A; and the circuit has an apparent power of 10,803 VA. The frequency of the AC voltage is 60 Hz. ET ER EL IT IR15A IL36A Z R XL VA10,803 P VARSL PF L
Find the equivalent capacitance C_eq for the circuit shown below.
Find the equivalent capacitance (μF) seen at the terminals of the circuit below.
Find the equivalent capacitance of given circuit between the point A and B) if the applied voltage across A-B, equal =5 VRMS , 1000 Hz. Note: Take the capacitance of each capacitor as C=680µF)
Solve the equivalent capacitance for the circuit below
A series circuit has a capacitor of 1.5625x10^(-8)F a resistor of 2x10^4 ohms, and an inductor of 1H. If the initial charge on the capacitor is zero,. if a 12-volt battery is connected to the circuit and the circuit is closed at t=0, determine the charge on the capacitor at any time t
If the expression of the voltage across a capacitor of capacitance C=10 mF is v(t)=5 sin(10t) mV, then find out the expression of the current flowing through the capacitor.
. If a 4μF capacitor is connected to a constant current source, therefore its current is given in the equation ic(t)=10mA. Determine the voltage, power and energy at 2ms.
A pure inductance of L = 120 mH is connected to a V = 102 V, 50 Hz supply. The current taken by the inductor is given by
The capacitor shown in the figure below is initially discharged. At t=0s the switch is moved to position B.Determine an expression for the voltage V across the capacitor for t≥0s.
Solve for the total capacitance from the circuit shown