2. In a three phase system the named voltage isdefined as theO Line to ground voltagePhase to ground voltageO The line to line voltagethe generated voltage minus the load voltage

There are certain notations we use to refer physical quantity in power system and it is a type of…

Answered: 2. In a three phase system the named…

2. In a three phase system the named voltage is defined as the Line to ground voltage Phase to ground voltage The line to line voltage the generated voltage minus the load voltage

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter33: Single-phase Motors

Section: Chapter Questions

Problem 2RQ: The voltages of a two-phase system are how many degrees out of phase with each other?

See similar textbooks

Related questions

Q: A composite wall layer consists of layer A covered by layer B. The thermal resistance of layer A is…

A: Solve the problem

Q: A BTS sending information at 1800 MHz with a 10 Watt (W) output power will only cover half the area…

A: Given that due to the frequency, a BTS broadcasting data at 1800 MHz with a 10 Watt (W) output power…

Q: Two conducting spherical shells have radii a = 9 cm and b = 12 cm. The interior is a perfect…

A: Given,a=9 cmb=12 cmεR=15C=?

Q: List three applications of electrical transformers.

A: Brief description : Transformers works based on the principle called electromagnetic induction and…

Q: 202 UA source rans formab's. Calculate V also find us usilg principle auperposibon loop- andlyno!…

Q: The signal is created using a NRZ-I line coding scheme. Find the data bits or symbol. USE: No…

A: The signal is created using an NRZ-I line coding scheme. We need to find the data bits or symbols.…

Q: A 1-phase alternator has a nameplate rating of 380V, 60Hz. If the equivalent impedance of the…

A: Here voltage is given as 380 voltage and power factor is 0.8 leading.

Q: 2. A flanged bolt coupling consists of six ½-inch steel bolts evenly spaced around a bolt circle 12…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: The voice signal with maximum frequency of 2kHz, is to be transmitted using sampling frequency fs =…

A: Bandwidth: It is the range of the frequency in which the frequency of the signal exists. Its unit is…

Q: 3. A 3V aud luutelnal hesistauce 0 used hesistance Rr lo Pupply pouves' to of a variable loadk of…

Q: SKetch the root-locus plot for the system shown in Figure below

Q: H.W: Estimate the root of the equation for the following equation usind Newton- Raphson method: f(x)…

Q: In a balanced three-phase system, the abc-phase- sequence source is wye connected and Va = 120/20° V…

Q: An ABC sequence set of voltages feed a balanced three-phase, wye-wye system. The load resistance and…

Q: 7. A coil 12 H. The urent 50 aud tof the has hesistance tuductante thiough coil io inereased…

A: It is given that: R=5 ΩL=1.2 H

Q: 5. Current on phaser diagram of unbalanced Y- connected load has a. No symmetry b. Symmetry c.…

A: given statement about unbalanced star load

Q: 1. How many resistors and switches would be required to implement a 6-bit resistor-string DAC?.

A: As per the guidelines of bartleyby I need to answer only first question.So kindly repost other…

Q: For the network below, VD = 9 V. Determine: ID. VS and VDS. VG and VGS. VP. 18 V 2 kN 750 k2 A6 = 1…

A: We need to find current and voltage for given circuit

Q: Given the magnetic field vector potential: A= y z ax +2 x y z ay-xz az (A/m), find: (1) magnetic…

Q: An emitter stabilized amplifier has the following data, R3 = 560K, Rc = 4.7K, RĘ = 1.2K, B= 160, ro…

Q: 7.) A three - phace, three- wire, 240 V ACB system supplies power to a wue - connected bad with…

A: In this question, We need to find the total average power delivered to the load? A three-phase,…

Q: A region D = 4a,+ (-6)a, + (4)a, nC/m² has a relative permittivity of 1.76. Find |VV|. Round your…

Q: 2. Determine the range of sampling interval T, that will make the closed loop system shown below…

A: Steps: Find G(s) and then G(z) Then Using G(z) ,find T(Z) Find pole of T(z) Then range of T for the…

Q: The area of the hysteresis loop is related to the amount of the energy dissipation. Select one: True…

A: The area of the hysteresis loop is related to the amount of the energy dissipation. Ans : True…

Q: (b) Output signal from a linear time-invariant (LTI) discrete system is given as follows: y[n] = {…

Q: What would be the current in a circuit that has two2Ω resistors followed by 3Ω resistor in parallel…

Q: 11.47 In a three-phase balanced delta-delta system, the source has an abc-phase sequence. The line…

Q: A current filament of 10 7 A in the +X direction lies along x-axis, and a current sheet, K=2 ay A/m…

A: Given that; Current filament of 10π Ampere in +Ve x direction along axis→ produces H1 at P(2,4,3)…

Q: ) Consider a combinational logic circuit in Figure Q.2 (a).i and Q.2 (a).ii. Determine the Boolean…

Q: Problem 50: Use nodal analysis to find the voltage across and current through all resistors. 24 V 10…

Q: Given: VT = 9 volts C₁ = 8µF С₂ = 6μF C3 = 6μF Solve for: CT, QT, UT, Q1, Q2,…

Q: Q2// Find the equivalent resistance across terminals XY in part A, and MN in part B.

Q: A Class C amplifier is as shown in Figure Q2(c) below. Determine: +Vcc =+60 V L7 = 15 µH C;= 120 pF…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: 15 +100 V Solve for the voltage at 40° OV -100 V 36.4 V 43.6 V 64.3 V 100 V

A: We need to find out the value of signal at given angle .

Q: 15. In a series RLC circuit of R= 4.2 ohms, L3 0.03 Hendry, C = 450 microfarad. If I = 10 A, find…

Q: for the hence find current flowing through 4 2 resistance. 20 ww 12 V 12 122 10 V ww 24 V

A: We need to write KVL equation for given circuit and need to find out current for given resistance .

Q: Consider the closed-loop system shown below: The loop has two proportional controllers. Kej and Ke2…

Q: Determine the Power consumed by the load (Green) when it is connected to a supply voltage of 48Vdc…

Q: 2. Unbalanced delta connected load has a. Symmetric Current b. A symmetric current c. Infinite…

Q: A 4-pole, 3-phase, 50 Hz induction motor has a voltage between slip-rings on open-circuit of 520V.…

Q: 6. If three impedance of Y and A connections are equal , than a. Z,/ Iy = 2 b. ZA/ Iy = 3 c. ZA/ Iy…

Q: (b) Based on system in Figure Q2, calculate the overall system impulse response if p[n] = { –3,4,7…

Q: In a A-connected source, the phase voltage is Ve = 102 V. What is between the lines in V? Your…

A: Given data, Delta connected source with Phase voltage, Vθ=120 V

Q: Given the equation, Ve = 42. 1 V sine, What is the value of Voltage at 151.6° A 42.1 V 84.2 V 59.54…

A: Consider the expression for the voltage is, Vθ=42.1sinθ V Consider the value of the angle is,…

Q: 1002 2 sin O (27ft-300) v

A: We need to find out output voltage for given circuit

Q: Determine the current Ip Vp IR Ip Si 5.5 ka 10V Repeat problem 2 when the diode is reversed

A: We need to find diode current for given circuit

Q: Four electrolytic capacitors are connected as shown in the figure. 12.0 V 0.00 A

Q: 3.- (33) Find the h parameters for I₁ I₂ ww V₁ N R₁ R₂ V₂ the given circuit

A: In this question, We need to determine the h parameters for the given circuit. Using the virtual…

Q: 2. In free space, let D = 8xyz*ā, + 6x²z*ā, + 16x²yz*ā, pC/m². a. Find the total electric flux…

Q: Three charges are positioned at the corners of a parallelogram as shown above right. (a) If Q = 8.0…

A: The three charges are positioned at the corners of a parallelogram as shown below,

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

2. In a three phase system the named voltage is
defined as the
O Line to ground voltage
Phase to ground voltage
O The line to line voltage
the generated voltage minus the load voltage

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The voltages of a two-phase system are how many degrees out of phase with each other?
1. Calculate the line currents for phase a, b and c.2. Calculate the line to neutral voltages at the load for phase A, B and C.3. Draw the phasor diagram of the source phase voltages and currents.
21/ In a three phase, star connection —— a. Line current is equal to phase current b. Line current is square root 3 times phase current c. Line voltage is equal to phase voltage d. Line voltage and line current is zero
In a 3-phase system, the power dissipated in the delta connected load is √3 times greater than the power dissipated in the star-connected load. select one: True ( ) False ( ) And why?
2 In three phase star connected system the line voltage is measured between _____________ a. Y phase and Y phase b. Neutral and Neutral c. R phase and Neutral d. Phase and Phase
2. For a 3-phase, 4-wire system having balanced supply and unbalanced load, the following sequence components are obtained: I1=200∠0° A, I2=100∠60° A°. If the Neutral current is equal to 300∠300° A.a. Ia, Ib, Icb. I0
In a three phase, star connection —— a. Line voltage is square root 3 times phase voltage b. Line current is equal to square root 3 times phase current c. Line voltage and line current is zero d. Line voltage is equal to phase voltage Clear my choice
3) State the relation between line and phase values of voltage and current for 3-phase STAR connected load .state the equation for active, reactive power consumed by 3-phase load.
Which of the following statements are correct for three phase circuit:A. Sum of all the three phase currents is zero in unbalanced networkB. Total power transfer to load is constant with timeC. Neutral conductor is same size in terms of material used as in single phase conductorsD. Net apparent power consumed is equal to real power
Question 1:a) Three_ phase AC power is generally preferred for generation, transmissionand distribution of electrical power. Explain why alternati current isused and give the main reason for the Choice of high voltages.b) Enumerate at least four major advantages of 3-phase powercompared to three (03) single-phase systems.c) State the formula for AC power and name the four componentsContained therein
What is the difference between a balanced load and an unbalanced load? Explain the power measurement methods in a star-connected circuit :one wattmeter method; two wattmeter method 'and three -wattmeter method 'with suitable diagram, and explain why the three-wattmeter method is not applicable for a three phase balanced load?
With neat diagram discuss 3-phase power measurement using three wattmeter method and wire down the drawbacks in this method.