2.0m 100 kg 2.0 m 0. 1.5m 1.5m The pulley at E is frictionless. Point B is a pinned connection; support A is a fixed support. The pin at Cis in a smooth slot. Determine the magnitude of normal force the pin C exerts on the smooth slot, = N. Determine the magnitude of of the y-component of the reaction force at B, By=. N. Determine the magnitude of of the x-component of the reaction force at B, Bx- N. le

2.0m 100 kg 2.0 m 0. 1.5m 1.5m The pulley at E is frictionless. Point B is a pinned connection; support A is a fixed support. The pin at Cis in a smooth slot. Determine the magnitude of normal force the pin C exerts on the smooth slot, = N. Determine the magnitude of of the y-component of the reaction force at B, By=. N. Determine the magnitude of of the x-component of the reaction force at B, Bx- N. le

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.72P

See similar textbooks

Similar questions

The bar ABC is supported by three identical, ideal springs. Note that the springs are always vertical because the collars to which they are attached are free to slide on the horizontal rail. Find the angle at equilibrium if W = kL. Neglect the weight of the bar.
Repeat Prob. 4.152 assuming that the 400-kN force is applied at O instead of L.
The homogeneous bar AB weighs 25 lb. Determine the magnitudes of the forces acting on the bar at A and B. Neglect friction.
The homogeneous plate of weight W is suspended from two cables. Determine the force P that is necessary to keep the plate in the position shown.
The uniform ladder of weight W is raised slowly by applying a vertical force P to the rope at A. Show that P is independent of the angle .
The simplest truss consists of two rods and is loaded by the block. Given: block weight Q = 9,4 kN. Angle α = 31 degrees. Find: the algebraic (positive or negative) value (in kN) of normal force N1 in the rod 1, considering that N1>0 for tension and N1<0 for compression.
Statics, Find the force in member BC, BE, and EF of the truss and state if the members are in Tension or Compression, given :P1 = 95 kN, P2=75 kN, P3=85 kN, L1=3 m, L2=5 m(Use positive values to indicate Tension and negative values to indicate Compression)
A 363.8N horizontal steel shaft is suspended by a vertical cable from A and by a second cable BC which lies in a vertical transverse plane and loops underneath the shaft. Calculate the tension T1 (N) in the cable.
A 12.0 kg weight hangs from a 7.50 m pole as illustrated in the diagram. The pole has a mass of 8.0 kg. Determine the tension in the cable, and the "Frictional" and "Normal" forces felt from the wall.
Determine the value of T if the force systems shown in the figure is in equilibrium
1. What is a Spatial Force System? 2.Three-dimensional equilibrium problems for a rigid body can be solved using what procedure?
A 200 lb rock is being lifted by a pry bar. Determine the force “P” required to lift the rock into the position show.