2.4 For the circuit shown, a) Ifi, - 0.5 A and G = 50 mS, find v, and the power delivered by the current source. b) If v, - 15 V and the power delivered to the conductor is 9 W, find the conductance G and the source current i c) If G = 200 uS and the power delivered to the conductance is 8 w, find i, and

2.4 For the circuit shown, a) Ifi, - 0.5 A and G = 50 mS, find v, and the power delivered by the current source. b) If v, - 15 V and the power delivered to the conductor is 9 W, find the conductance G and the source current i c) If G = 200 uS and the power delivered to the conductance is 8 w, find i, and

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A PV system is using 80 W, 12 V panels and 6 V, 155 Ah batteries in an area of unshaded sunshine. The battery efficiency is 73% and the depth of discharge is 70%. If, in wintertime, there are 5 hours of daylight, estimate the number of PV panels and batteries required for a 24 V application with a load of 2600 Wh /day and three days of storage.
Solve this question1)In concentrating solar power - central receiver, one of the following advantages is wrong comparing to parabolic troughSelect one:a. it requires less gross land area and less capital costb. None of thesec. No need for miles of tubes absorber tubes circulating HTFd. Less water usee. Achieves higher temperature and pressure2) The temperatures necessary to get sufficient efficiency to convert the earth’s heat to electrical power is:Select one:a. 160 °Cb. 230 °Cc. 130 °Cd. None of thesee. 200 °C
Q2- For PV /Battery Stand-Alone System, the system nominal volage=120V. The days of autonomy=12 day. The total daily load=34Ah/day. 1- Find the battery capacity. Hinit: take capacity to be 1.5 of calculated value. 2- For PV panel of V ,p,=24V and lLyp,=6.1A, A:L=1.5, sun hours(SH=4h) and efficiency of system=70%. a-Find the number of PV panels for each string(N,). b- Find the number of strings (Ny). c- Find the total number of PV panels used.
The headphones have a resistanceof 600Ω . The headphone amplifier in a battery-powered deviceis designed to deliver 0.1 W to the headphones. If theresistance of the headphones is 24 , calculate thevoltage and current required from the dependentvoltage source (Av in our model) to deliver 0.1 Wto the headphones. How much power is deliveredfrom dependent source? How much power is lost inthe output resistance?
A) Use any analysis method to calculate the voltage Vo and the power dissipated by the dependent source indicating whether the dependent source absorbs or generates power.Indicate the method you used in the analysis and explain your procedure.B)If the 2 Ω resistor, where the voltage Vx is defined, is short-circuited, what circuit would be left? What would be the value of the volage Vx? What would happen to the current dependent source? Explain your reasoning.
d. If V2 = 8 V and E = 14 V, find V3. e. If R1 = 4 Ω, R2 = 2 Ω, R3 = 4 Ω, and R4 = 6 Ω, what is RT? f. If all the resistors of the configuration are 20 Ω, what is the source current if the applied voltage is 20 V? g. Using the values of part (f), find the power delivered by the battery and the power absorbed by the total resistance RT.
a)Determine a numerical value for each current and voltage (i1, v1, etc.) in the circuit shown below.b)verify that the principle of conservation of power in indeed true
In the circuit, V1=128 V, R1=6 Ohm, the current through R1 flowing from left to right, iR1 = 6 A.Find the potential of the node "1" (Unit: V)
For the circuit given belowΒ1=200, β2=25, VBE1=VBE2=0.7 Va) Calculate the value of R1 when VEQ2=5 Vb) Calculate Avo
#2write your solution pls pls
A meeting hall in an organization is to be provided with a lighting installation. The hall is 30 m × 20 m × 8 m (high). The mounting height is 5 m and the required level of illumination is 144 lm/m2. Design a lighting system for the hall with the given data. Lumens/watt for 200-W lamp = 12 and Lumens/ watt for 500-W lamp = 16. Utilization coefficient = 0.6 Maintenance factor = 0.75 space/height ratio=1 Using metal filament lamps, estimate the following: Draw the spacing layout of these lamps State the reason if any of these 2 lamps cannot be arranged in the hall with the given specification. What is the significance of ‘room surface maintenance factor’ and ‘utilization factor’ in the lighting design
(c) A PV cell of area 4.0 cm. having a short-circuit current of 50 mA/cm, open - circuit voltage of 0.4V and a fill factor of 60 %. By connecting 36 identical PV cells in series to make PV module .Ignore the loss of electrical energy due heat then (i) Calculate the area of a PV module (ii) Find the short circuit current of a PV module (iii) Find the open circuit voltage of a PV module. (iv) Calculate the theoretical power of a PV module (v) Calculate the power delivered by the PV module at the maximum power point