20 kΩ 60 kΩ 20 kΩ + 20 kΩ 100 kΩ 20 kΩ Vz 60 kΩ |Vy 20 kΩ Vw 20 kΩ 20 kΩ

Q: -j10 ww j22

A:

Q: Identify the DC motor that can be used in Lift. Also, explain the requirement of a DC Motor to be se...

A: DC motor- A DC motor is an machine than converts DC electrical input fed to the armature (assuming t...

Q: Find the Nyquist rates for the following signals: X(t)= sin (20t) X(t) =4sin (30nt) + 3cos (70nt) X(...

A:

Q: The message signal m(t) = a cos(2rf t)is used to either FM or PM for the carrier A cos(27f t). Find ...

A:

Q: who is father of engineering

A: Mokshagundam Visvesvaraya is the father of engineering .He was born on 15 September 1861 near Chikka...

Q: Q1. For the circuit shown in Figure below find the maximum and minimum values of zener diode current...

A: This question belongs to analog electronics . It is based on the working of zener diode.  Zener diod...

Q: Gr. R2 2 kaI2 ) Det I,. L Is

A:

Q: Bridge Circuit

A: Wheatstone Bridge- It is a circuit constructed to find the unknown resistance with the help of the k...

Q: Activity 1: Try To Solve Me! Directions: Solve the following problems systematically. Write your sol...

A:

Q: 5/ Compute the r.m.s and average values of the voltage waveform shown below v(t) 4 →t(msec) 1 -4 21

A: Calculation of r.m.s. (root mean square) and average values of the given voltage waveform : We know...

Q: Solve for the value of the voltage on 220 ohms resistor. D1 2200 02 10V

A:

Q: Given three impedance Z1=10 +j0 Z2 =3+j4 and z3=8-j6. Impedance z2 and Z3 are connected in parallel ...

A: If two impedances Z1,Z2 are connected in series than equivalent impedance is Z1 +Z2.  If two impedan...

Q: What is the important quantity to distinguish metals from insulators or semiconductors ?

A: Given: Metal, Insulators and semiconductors

Q: Using a 5 mH inductor, design a high-pass, RL, pas- sive filter with a cutoff frequency of 25 krad/s...

A:

Q: R2 4 Ohm D: D: Is 5A R1 2 Ohm 4is 21:

A:

Q: Derive the truth table for a majority function which is generated in a combinational circuit when th...

A: The answer for the following questions are

Q: Discussion 1. what are the advantages of bridge circuits ? 2. what are the two main types of bridges...

A: I am giving answer of all three questions.  

Q: If we connect a load resistor (RL ) between the terminals a and b, find the value of RL in order to ...

A:

Q: The current I in the circuit shown is 2V. 205 20 2V 2V

A: Given circuit:

Q: find lo

A:

Q: The magnetic structure in the figure below is made of silicon steel. Determine the values of IB requ...

A: Note: Relative permeability (μr) for silicon steel is not given . We assume μr = 2000     Given NB= ...

Q: Design of the voltage reference In lab 2 we found that a Zener diode can be used as a voltage refere...

A:

Q: Given an amplifier with an effective noise temperature of 10,000 K and a 10-MHz bandwidth, what ther...

A:

Q: Design a passive RC low pass filter (see Fig. 14.7) with a cutoff frequency of 100 Hz using a 4.7µF ...

A:

Q: Q2. A 7.2 V zener is used in the circuit shown in Figure below and the load current is to vary from ...

A: In this question,  We need to determine the value of resistance R to maintain value of zener diode V...

Q: Here are the list of the resistance value of each resistor, compute for the total current and total ...

A:

Q: A tuned circuits of the oscillator in an AM transmitter used a 50 micro Henry coil and a 1 nano Fara...

A: We are authorized to answer one question at a time since you have not mentioned which question you a...

Q: What is forward bias and reverse bias in PN junction diode?

A: We need to tell about forward bias and reverse bias for a diode .

Q: Calculate the intrinsic impedance of free space. Need it urgently.

A: In this case, the intrinsic impedance of free space needs to be calculated. 

Q: In the figure: R1 = 27.3 Q, R2 = 93.1 Q and R3 = 1571.12 Q, then determine the value of the source c...

A:

Q: 1. What length of standard RG-8/U coaxial cable would be required to obtain 45 degrees phase shift a...

A: It is given that: Phase shift=θ=45°Frequency=f=200 MHz=200×106 HzVelocity factor=0.66      

Q: (4) 0,lkn 3v 5V DA Vo Paw Vo

A: We need to find out output voltage and we need to draw it .

Q: Use a 250 N resistor to design a low-pass passive filter with a cutoff frequency of 8 krad/s. a) Spe...

A:

Q: 8. 20x - y - 22 = 17, 3x + 20y – 2 =- 18, 2r – 3y + 20z = 25.

A:

Q: Using the load-line methodology, please find the operating point of the Zener diode of the following...

A: Diode- Diode means uni-directional flow of current, that's why to convert Ac to Dc voltage we use re...

Q: Q2. Determine whether the transistor is biased in cutoff, saturation or linear region. (a) Rp= 75KN ...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: cylindrical copper having a diameter of 0.4 in. has a resistance of 0.00264 Ω.  Taking the resistivi...

A: Given thatdiameter d=0.4cmr=d2=0.42=0.2cmR=0.00264ΩResitivity ρ=1.745μΩ-cm

Q: Problem 2 A Y-connected balanced three-phase generator with an impedance of 0.4 + j0.3 2 per phase i...

A:

Q: A 50 and 100 microfarad capacitors are connected in series and across 100sin(w+30) voltage. Write th...

A:

Q: 0,(s) for the rotational system T(s) 2. Find the transfer function G(s) below

A: The given circuit is shown below:

Q: diode structure shown below. The diode has the following properties. P doping =1x1018cm•³ N doping =...

A:

Q: dentify the machines/equipment that requires electricity for specific rice farm production/postprodu...

A: FIND: The machines/equipment that requires electricity for specific rice farm production/postproduct...

Q: For the following mathematical model; a) Draw its block diagram. b) Construct its State-Space model....

A: I have solved both part of the question, I hope you can understand the concept now :)

Q: person represented as in Fig. 01. Position of the book is given as the reference. Feedback signal fr...

A:  

Q: A circuit in which the resistance is almost zero ohms is referred to by which of the following terms...

A: This question belongs to circuit theory . It is about behaviour of resistance when value of resistan...

Q: Problem 3 What should be the value of R such that maximum power transfer can take place from the res...

A: According to guidelines we are allowed to do only first question. Post again for remaining one 

Q: I 42 J22 42 J252 2 10.8: For the circuit shown, Find the currents w.r.t voltages equations (Y-Parame...

A: Apply KVL in two loops to find two equation in terms of voltage V1 and V2. According to KVL sum of v...

Q: • The message signal m(t) =a cos(2nf t)is used to either FM or PM for the carrier A, cos(27f t). Fin...

A:

Q: 2. Evaluate *2) dx by Gauss three-point formula. o 1+(x+1)*

A:

Q: Given the Logic Function, choose from below the corresponding Kmap E (1,2,4,5,8,11,13), d (3,9,10,12...

A: The digital circuits can be sequential or combinational circuits. The combinational circuits depend ...

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.