2400 kg 15m Question # 1. A fixed crane has a mass of 100-kg and is used to lift a 2400-kg crate. It is held in place by a pin at A and a rocker at B. The center of gravity of the crane is located at G. Determine the components of the reaction at A. Az = -10933.3N - Ay = 3400N ↑ Az = 10708 N + Ay = 3331 N ↑ Az = 95484 N + Ay = 24525 N ↑ Ax = 0 Ay = 23544N ↑

2400 kg 15m Question # 1. A fixed crane has a mass of 100-kg and is used to lift a 2400-kg crate. It is held in place by a pin at A and a rocker at B. The center of gravity of the crane is located at G. Determine the components of the reaction at A. Az = -10933.3N - Ay = 3400N ↑ Az = 10708 N + Ay = 3331 N ↑ Az = 95484 N + Ay = 24525 N ↑ Ax = 0 Ay = 23544N ↑

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.45P: The uniform, 30-lb ladder is raised slowly by pulling on the rope attached at A. Determine the...

See similar textbooks

Similar questions

Find the stable equilibrium position of the system described in Prob. 10.56 if m = 2.06 kg.
Two concrete blocks weighing 320 lb each form part of the retaining wall of a swimming pool. Will the blocks be in equilibrium when the pool is filled and the water exerts the line loading shown?
The uniform, 30-lb ladder is raised slowly by pulling on the rope attached at A. Determine the largest angle that the ladder can attain if the maximum allowable tension in rope BC is 120 lb.
PROBLEM 1: The 1500-kg beam ABC has fixed support at A and connected to beam BD by hinge at B. Beam BD has a mass of 2000 kg and supported by a cable at D. The cable is attached to the 20-cm-diameter pulley at E and pulled vertically at the other end, by tension T. Given: a = 1.5 m; b = 0.9 m; c = 1.8 m d = 0.6 m; e = 1.4 m; θ = 75°. Calculate the required tension to maintain in equilibrium. (ANSWER: 12.830KN) Calculate the moment reaction at A. (ANSWER: 28.499) Calculate the total reaction at A. (ANSWER: 22.192) Calculate the vertical reaction at E. (ANSWER: 25.223)
Consider a floor crane operated by a driver which carries a drum as shown in figure. The total weight of floor crane and driver is 2700 kg acting at the point of center of gravity, G. mm; = 1 = Considering L1 = 14m, L2= 3 m L3 - 6 m, 14 = 2 m LS = 1 m; L6=7m 1. If the weight of the drum lifted by the floor crane is 800 kg, determine the total normal reaction on the rear wheels at A and total normal reaction on the front wheels at B when the boom is inclined at an angle of 25" with the horizontal, 2. Utilizing the same data given above for the same position of boom, determine the largest weight of the drum that can be lifted without causing the crane to overturn. (Hint: When the floor crane tends to overturn about point B, the wheel at A will leave the ground). Note: 1. Consider the entire system as coplanar 2. Take g 9.81 m/s wherever necessary = 9 Total normal reaction on the rear wheels at A= Total normal reaction on the front wheels at B= Largest weight of the drum=
2-D PROBLEM: A spherical tank with a radius of 3.41m that has a mass of 28928.644kg was supported in the system shown. Assuming friction and the bar weight is negligible, determine the following: β: 21.774° θ: 46.452° 1. The reaction @ point D. 2. Tension @cable BE 3. The x and y-component of the reaction @ A 4. The reaction @ A
Take F = 310 N and d = 1.0 m Determine the force in cable AC and AB needed to hold the 24-kg ball D in equilibrium.
Don't copy from other websites solution. The wall crane supports a load of 660lb. The jib ABC has a weight of 152lb and member BD has a weight of 38lb. Each member is uniform and has a center of gtravity at its center. A)Determine the horizontal component of reaction at the pin A. B)Determine the vertical component of reaction at the pin A. C)Determine the horizontal component of reaction at the pin D. D)Determine the vertical component of reaction at the pin D. E)What is the force in the cable at the winch W?
An athlete of 60 kg and 1.70 m tall performs the ring exercise called "the Christ", in which he keeps his body immobile with his arms extended horizontally as shown in Fig.-Prob.17(a). The angle with the vertical of the cords from which the rings hang is theta = 10. (a) Determine the tension T in the cords holding the rings. (b) Considering each arm of the athlete as a rigid horizontal bar subjected to the forces indicated in Fig.-Prob.17(b), calculate the value of the components RX and RY, the value of the reaction “R” and of the beta angle.- W is the weight of the arm, applied in the middle of its length.- R is the reaction at the shoulder joint O.- RX and RY are the horizontal and vertical components respectively of the reactionapplied at the shoulder joint O.- Note: Consider that the mass of each arm of the athlete is 3% of the total mass, and thatthe length of the arm is equal to 35% of its height. Fig.-Prob.17(a): Man performing the position of "The Christ"Fig.-Prob.17(b):…
90-kg smooth circular cylinder A with a radiusof 0.6 m is held in equilibrium by a cord CD and abar BC of negligible mass. The length of bar BC is2.4 m. a) Draw the FBD of the circular cylinderand the bar BC.b) Determine the tension in the cord CD.
One end of a rod of length L and density ρ is fixed by a frictionless pivot at a depth d under water. Determine the equilibrium positions of the rod in terms of its angle α measured from the vertical, and the investigate whether the equilibrium positions are stable or unstable, given that (a) ρ = 500 kg/m3 ; (b) ρ = 853 kg/m3 (The density of water is ρw = 1000 kg/m3 .)