Answered: 248. A D.C. Generator has 6 poles, a…

248. A D.C. Generator has 6 poles, a brush shift of 6° actual means a brush shift of (a) 6° electrical (b) 18° electrical (c) 30° electrical (d) 2° electrical

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter9: Components For Electric Motors

Section: Chapter Questions

Problem 10RQ

See similar textbooks

Related questions

Q: Electrical Engineering Topicwise Solved Questions A 6 pole Lap wound de generator has 300…

A: Given, Total number of pole, P = 6. Total number of conductor, Z = 300. Emf induced per conductor,…

Q: how do you mathematically prove that both i1 and i2 have a value of 0 for this question??

A: The required current can be calculated by using the node voltage and the node voltage can be…

Q: PLEASE SHOW DETAIL of ALL YOUR WORK At t = 0, a series connected capacitor and inductor are placed…

A: In this question we need to find the voltage Vo(t) for t>0.

Q: Given the block diagram, what is Y(s)/W(s)?

A: The transfer function Y(s)W(s)of the given system needs to be obtained by using the block diagram…

Q: Find the transfer function, G(s) = X₂(S)/F (S), for the translational mechanical system shown below.…

A: A transfer function provides the relation between input and output function in mathematical form. To…

Q: Question A2 15 V ( 8 Ω WITH 200 pF 95 mH Fig A2 2 k

A: Circuit diagram is given as,

Q: Find the system transfer function H(s) = Vout/Vin.

A: The transfer function can be obtained by converting the circuit into the S domain and then by using…

Q: Draw the root-locus graph for the closed loop system given below. Using this graph, maxi-

Q: 3.7. In the circuit of Fig. 3.67, plot Ix and IRI as a function of Vx for two cases: VB = -1 V and…

A: about diode and its nature…

Q: For the linear, time-invariant discrete-time system given by the difference equation yn]+y[n- 2] =…

A: In this question we need to find the zero input response of the given system.

Q: Question 1) The amplitude of the voltage source is x=6V and the amplitude of the current source is…

A: It is given that: x=6 Vy=9 A

Q: obtain

A: Given, Req=4ohm 20ohm is connected with parallel with unknown resistance Rx . We need to find out…

Q: (7) Determine Is,Ic,IE, VB,and Vc in the following figure, where Bpc is 48. ww Rc >1.2KQ Vac 14.

A: Circuit diagram is given as,

Q: 3.7. In the circuit of Fig. 3.67, plot Ix and IRI as a function of Vx for two cases: VB = -1 V and…

A: The circuit diagram is shown below, we need to draw graph for current and voltage.

Q: Determine VB, VE, VC VCE, IB, IE, and Ic in the Figure. + R₁ 22 ΚΩ R2 10 ΚΩ Vcc +30 V Rc 1.0 ΚΩ…

Q: A 3-D power system experienced an unbalanced fault type had the following sequence voltages at the…

A: In this question we need to find the following Calculate the related phase components Identify the…

Q: The rectifier above drives a 950-22 load with a peak voltage of 3.15V. For a 100-µF smoothing…

A: RL = 950Ω, peak voltage = 3.15V. C= 100-µF, calculate the ripple amplitude if the frequency is 50…

Q: 16.12 One period of a periodic function is described by the following equations: i(t) = 5t A, i(t) =…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: P 4.7-11 Determine the values of the mesh currents of the circuit shown in Figure P 4.7- 11. a b…

Q: P 4.4-9 The node voltages in the circuit shown in Figure P 4.4-9 are V₁ = 4 V, v₂ = 0 V, and v3 = -6…

Q: The amplitude of the voltage source is x=75V, then find ZL for the maximum average power transfer…

Q: An alternator having normal current of 100A is to be protected by unit protection using stabilizing…

A: The fault current through the transformer can be calculated as follows:Fault current = 15 x 100A =…

Q: Vin D₁ + C₁RL Vout The rectifier above drives a 320-2 load with a peak voltage of 3.25V. For a…

Q: Electrical Engineering Topicwise Solved Questions A 6 pole Lap wound de generator has 300…

A: Given- A lap wound DC generator with, Total number of poles, P = 6 Total number of parallel paths, A…

Q: For uncontrolled full wave rectifier, R=44ohm, L=0.05H, f=50Hz and Vm=299V. Calculate the amplitude…

A: R is the load resistance, L is the inductance of the load, f is the frequency of the AC supply and…

Q: Convert the octal number 714g to the decimal number.

A: Given: An octal number, 7148 , To do: We have to convert above given octal number in decimal number.…

Q: (a) When the switch is closed, the transistor must be driven into saturation, thus applying nearly…

Q: ucation VB Geçiş yap... + H. R₁ W Consider the circuit shown above, assuming ß = 150and Is = 7 x…

Q: : A 3-phase, 6 Pole, 50 Hz, 400 V induction motor takes a line current of 40 A at 0.8 p.f. and runs…

A: Number of poles, P=6 supply frequency, fs=50 Hz line current, IL=40 A The power factor, cosϕ=0.8…

Q: Select the classification for the system given by: 3.6 H(s) = s²+10s +9 (= (to 3 significant…

A: given transfer function is H(s) =3.6s2+10s+9

Q: Q2: 1 The following values are obtained by sampling two timevarying signals once every 0.4 s: t…

A: The given table contain two signals y1(t) and y2(t) Signal values are given at different time We…

Q: 174. The EMF induced in the armature of a shunt generator is 500 V. The armature resistance is 0.2 2…

A: Given: A shunt generator with, Induced emf in the armature, E=500 V. The armature resistance, Ra=0.2…

Q: 2. approach. In the network given below, find i, (t) for t> 0 using the differential equation

A: Need to calculate the value of current flowing through the inductor using the differential equation…

Q: Resistors connected in series-parallel combination Resistance combination Rab b 24 Vdc Figure 5.2…

Q: VB Ic R₁ wwQ₁ 8 Consider the circuit shown above, assuming ß = 75and Is = 7 x 10-16 A. If R₁ = 9.5k,…

Q: di nden sayfa uyurular For uncontrolled half wave rectifier, R=80ohm, L=0.15H, f=50Hz and Vm=311V.…

A: We need to find out the average value of current for given rectifier.

Q: 30 V + www 252 For the circuit shown above, if the 30 V voltage source delivers L resistor Ris (a)…

A: The circuit is, Power delivered by the source is, P=150 W.

Q: Question 3) The amplitude of the voltage source is x=4V, then find ZL for the maximum average power…

A: The thevenin's equivalent value for the circuit needs to be calculated and the average power…

Q: A diode with a reverse saturation current of Is=7.3x10-16 A carries a forward-bias current of 5.8…

Q: MT.Q3 - In the DC circuit E₁-48V, E-12V Ro-220, R₁-330, R-5,60, R₁-4,70, R-11, R-6,50 Re-110 and…

Q: 1.2 Draw the logic circuit of E(x, y, z)=xy+xyz+x+y as it is 1.3 Draw the logic circuit of the…

A: In this question we need to draw the following Draw the logic circuit of the given expression Draw…

Q: 7.2.37 Use the step-by-step method to find vo(t) for t> 0 in the given circuit. 651 GV -0 682 4 H…

Q: In the above circuit amplitude of the current source is x= 70. then find the I2 mesh current Which…

A: In this question we need to find the value of mesh current I2 .

Q: What is the current through the diode?

Q: a. For the series resonant circuit of Fig. (10), find I, VR, VL, and VC at resonance. b. What is the…

A: In a series resonance , at resonance condition the net impedance offered by the circuit is only…

Q: Vx R2 RIVER V8 VB D₁7 Ideal In the circuit above, plot ly and Ig1 as a function of Vx for two cases:…

A: Given: A circuit, To do: We have to plot Ix and IR1 as function of Vx. a) When VB= -1 V, b) When…

Q: The 10-cm-wide, zero-resistance slide wire shown in (Figure 1) is pushed toward the 2.5 12 resistor…

A: In this question we need to find the following Pushing force How much power does the pushing force…

Q: In the circuit shown below, Is = 6x10-17 A. Determine Vx for V₁ = 00, Alttaki devre için ls =…

A: Is = 6x10-17 A Vcc=3.5V, VB=772mV, Rc=1 kΩ Need to calculate the Vx.

Q: How many bits are required to represent 6 unique numbers? -2.58 3

A: Given data: How many bites are required to represent 6 unique numbers

Q: What distinguishes the old telephone networks and exchanges from their digital equivalents is the…

A: Telephone it is a device which is used simultaneous voice data transmission. It previously it is…

Concept explainers

Single Phase Induction Motor

The single-phase induction motor or engine consists of a single rotating phase in the stator and a rotating cage in the rotor. When phase one supply is connected to the stator winding, a magnetic field is generated. In the pulsating field, the rotor does not rotate due to inertia. So, a single-phase import motor does not start and requires some initial methods.

Question

248. A D.C. Generator has 6 poles, a brush shift of
6° actual means a brush shift of
(a) 6° electrical
(b) 18° electrical
(c) 30° electrical
(d) 2° electrical

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data:

VIEW

Step 2: Calculation:

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

when a generator is being driven at 1200rpm, the generated emf is 230V. What is the generated emf if the field flux is decreased by 10% with the speed remain unchanged.
10. What is the angle of lead ? (DC GENERATOR QUESTION)
A generator rotates such that the flux changes from -10,000V-s to 10,000Vs every 0.005s. Calculate the voltage difference generated. If you wished to step down this voltage to 20KV and had 2000 turns on the primary, how many turns should there be on the secondary?
8.Which of the following wind turbine contains convex shaped blades? a. Darrius Rotor b. Multi Bladed c. Single bladed d. Double bladed
How do you find the frequency of this generator given the information that is listed? I tried doing 1/T but it does not give me the correct answer which should be 12.5 Hz.
When an electric generator is in operation, it is driven or rotated by a mechanical machine that converts chemical energy into mechanical energy called
The voltage across the terminals of a generator field is 220 volts, and the field current is 4 coulombs/secs. Determine the resistance of the field circuit.
The reactance of a generator is given as 0.55 pu based on the generator of 21 KV, 350 MVA. Determine the pu reactance on a base of 15 KV, 400 MVA. New pu reactance is Answer
The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
An electric generator has 1 500 rectangular loops of dimension 0.20 m x 0.30 m. The loops are then rotated in a 0.15-T magnetic field at a frequency of 70 Hz. What is then the maximum voltage output of the generator? 2 268 V. 5 937 V. 7 163 V. 9 512 V. 12 060 V
A 4-pole dc generator with duplex lap winding has 48 slots and 4 elements per slot. The flux per pole is 2.5 x 106 maxwells and it runs at 1500 rpm. Find the output voltage.
1. What is the idea of interchanging two lead if the direction of rotation is wrong?