25. Shown in fig. below, fluid A is oil (S.G. 0.82) and fluid B is salt solution (S.G. 1.10), Z= 21.5 in, y = 7.0 in. The local acceleration of gravity and barometric pressure and both standard. Compute the pressure at point x if the specific gravities are relative to 62.4 lbm/ft³ water. 10 Fluid A open Fluid B

25. Shown in fig. below, fluid A is oil (S.G. 0.82) and fluid B is salt solution (S.G. 1.10), Z= 21.5 in, y = 7.0 in. The local acceleration of gravity and barometric pressure and both standard. Compute the pressure at point x if the specific gravities are relative to 62.4 lbm/ft³ water. 10 Fluid A open Fluid B

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.5P: Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen,...

See similar textbooks

Similar questions

A soccer referee inflates a soccer ball to the standard required measured pressure for a game of 90kPa, before the game. The balloon has an internal volume of 2650 cm3 and the air is at a temperature of 25°C when the balloon is first inflated. The ball is brought onto the field of play, and by the time the game starts, the air temperature has dropped to 0°C. Assuming that the volume of the balloon does not change significantly. Determine the following: a. Make a schematic of the system, showing the limits and conditionsb. The mass (in Kilograms) of air in the ball.c. The air pressure in the ball when the game starts. (Measured pressure)
A 300 mm by 150 mm Venturi meter (c = 0.985) carries 0.0566 m /s of water with a differential gage reading of 0.634 m. What is the specific gravity of the gage liquid?
Using Laplace equation figure out how higher than atmospheric pressure is the inner pressure in a drop of water of radius 3 mm interfacing air at atmospheric pressure. Water surface tension 0.072 N/m. Atmospheric pressure 1.01x105 Pa.
As illustrated, a mercury manometer is attached to the side of a nearly full water tank. The reading of the mercury column is 15.5 in. Hg gage. Although air on the water maintains the pressure, the other 10-in. leg of the manometer is full of water, for H2O , ρ = 62.3lb/ft3 ; for Hg, ρ = 846lb/ft3 If the location is at standard gravity and the temperature of both the water and mercury is 60°F, what is the pressure (psia) in the tank at the level where the manometer is attached? If the tank extends 10ft below this level, what is the pressure at this depth?
Find the kinamatic viscosity of liquid in stocks who's specific gravity is 0.95 and dynamatic viscosity 0.12 poise
Q#2: Temperature rise, decreases viscosity in liquids but increases in gases, why?
a u-tube manometer filled with water ,density 62.4 lbm/ft3, shows a height difference of 10in. what is the gauge pressure? include diagram. a. 52.0 psf b. 2.488 kPa c. 3.537 atm d. 2.488 psi
Give me right solution. Determine the altitude of the atmosphere above sea level in meters if the atmosphere has an absolute pressure of 23 kPa, abs. and the atmospheric pressure at sea level is 101.325 kPa, absolute and temperature of 15 ⁰C. The gas constant of air is 286.9 joule per kilogram per degree kelvin. Assume the condition isisothermal.
Q2: The function relates the different variables in a capillary rise of a liquid is given by: h = f (d, g, ?, ?, ∅) where; h= capillary rise, d= tube diameter, ? = mass density, ? = surface tension; ∅ = contact angle Find a non-dimensionless expression relates h with the other given variables by using Buckingham theorem
in fig below, fluid A is water (density = 62.1lbm/ft^3) while fluid B is oil (S.G. 0.80). g = 32.2 fps^2 and z=14in. compute the pressure difference between X and Y if the specific gravity is relative to 62.4 lbm/ft^3 water. with drawing and explanation
A storage tank, 26 ft in diameter and 36 ft high, is fi lledwith SAE 30W oil at 20 ° C. ( a ) What is the gage pressure,in lbf/in 2 , at the bottom of the tank? ( b ) How does your resultin ( a ) change if the tank diameter is reduced to 15 ft?( c ) Repeat ( a ) if leakage has caused a layer of 5 ft of waterto rest at the bottom of the (full) tank.
7. a. If the blood viscosity is 2.7x10-3 Pa.s, length of the blood vessel is 0.35 m, tubular resistance of a blood vessel is 38.5 GPa-s/m3 , What is the radius of the blood vessel in mm?b. If the blood pressure at the outlet of the above vessel is 30 mm Hg and the flow rate through the vessel is 100 ml/min, find the inlet pressure in mm Hg. Density of mercury = 13,550 kg/m3, acceleration due to gravity = 9.61 m/s2