2500 cm3 of water was measured in 120 minutes for the experiment from a sample with a diameter of 15 cm and a length of 30 cm, on which the constant level permeability test was performed. There is a height difference of 2.5m between the level from which the water is taken and the fixed water level. Find the permeability coefficient of the test sample? (π=3.14) will be taken

2500 cm3 of water was measured in 120 minutes for the experiment from a sample with a diameter of 15 cm and a length of 30 cm, on which the constant level permeability test was performed. There is a height difference of 2.5m between the level from which the water is taken and the fixed water level. Find the permeability coefficient of the test sample? (π=3.14) will be taken

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.22P: Refer to Figure 7.24. The following data were collected during the field permeability measurement of...

See similar textbooks

Similar questions

In a falling-head permeability test, the time taken for the head to fall from 27 cm to 3 cm is 10 minutes; if the test is repeated with the same initial head, i.e., 27 cm, what time would it take for the head to fall to 9 cm?
Calculate the coefficient of permeability in mm/s of a soil sample, 6 cm in height and 50 cm2 in cross sectional area, if a quantity of water equal to 430 ml passed down in 10 minutes, under an effective constant head of 40 cm
For a permeability test with variable load, the following are given: soil sample = 380 mm; sample area = 6.5 cm², k = 0.175 cm/min. what should be the area of the piezometer so that the charge drops from 650 cm to 300 cm in 8 minutes?
Refer to Figure 7.24. The following data were collected during the field permeability measurement of a confined aquifer using a pumping test. Determine the hydraulic conductivity of the permeable layer. Use Eq. (7.49). Thickness of the aquifer, H = 4.5 m Piezometric level and radial distance of the first observation well: h1 = 2.9 m; r1 = 17.8 m Piezometric level and radial distance of the second observation well: h2 = 1.8 m; r2 = 8.1 m Rate of discharge from pumping, q = 0.5 m3/min
1. A constant head permeability test is conducted on a certain soil. The diameter of the sample is 7.5 cm, length is 20 cm, and the constant head is 42 cm. The mass of water collected in 64 seconds is 88 grams. Solve for the coefficient of permeability in cm/min.
For a falling head permeability test find the value of permeability in (mm/sec) if the initial height of water 1500mm, final height 605mm, time of the test 281 sec, length of the sample 150 mm, diameter of the sample 100mm and diameter of the stand pipe 5mm.
Suppose the following values are obtained through a Constant Head Apparatus while measuring permeability. Calculate the coefficient of permeability. · Volume of water passing through soil in time (t) = 100ml · Cross-sectional area of specimen = 500 mm2 · Thickness of specimen = 8 mm · Hydraulic head = 5 mm · Mean temperature of water during test = 20oc Time interval t = 2 minute
The figure shows the layers of soil in the tube that is 10 cm by 10 cm in cross section. When the tube is supplied with water, a constant head difference of 30 cm is observed. The coefficient of permeability of each sample are as follows: A. Find the equivalent coefficient of permeability. B. Determine the hydraulic gradient. C. Compute the rate of water supply.
In a constant-head permeability test, a sample of soil 12 cm long and 6 cm in diameter discharged 1.5 x 10^(-3) m^3 of water in 10 minutes. The head difference in two piezometers A and B located at 1 cm and 11 cm, respectively, from the bottom of the sample is 2 cm. Determine the hydraulic conductivity of the soil. What is the soil type tested?
A falling head hydraulic conductivity test is performed on a sample of soil. The standpipe. having a diameter 0.35 cm is observed and it takes 80 seconds for the water to drop by 70 cm from an initial hydraulic head of 90 cm. The sample has a length of 22 cm, and a diameter of 5 cm. Compute the rate of flow of water in the soil (in cm³/s). Answer in 3 decimals Pls answer asap
A slug test was made using a piezometer with a casing radius of 2.54 cm and a screen of radius 4.54 cm. The well was screened fully within a confined aquifer that was 3.3 m thick. The static depth to water in the piezometer is 10.5 cm. The remaining depths to water in the piezometer versus time are given in the chart below. Find the aquifer transmissivity using the Hvorslev method from the below data (time corresponding to each depthin order): Time (min)0, 1, 2, 3, 5, 7, 10Depth to water from surface (cm)5.4, 6.2, 6.8, 7.5, 8.4, 9.0, 9.510 9.5
In a constant head permeability test, a sample of soil 12cm long and 6cm in diameter discharged 1.8 x10^-3m^3 of water in 15 minutes. The head difference in two piezometers A and B located at 1cm and 11cm, respectively, from the bottom of the sample is 2cm A.Determune the hydraulic conductivity of the soil in cm/s Choices: 0.32,0.40,0.35,0.34 B.Calculate the discharge velocity in mm/s Choices: 0.79,0.68,0.71,0.64 C. How long will it take in minutes for the test to collect 3L of water Choices: 22.29,25,26.15,27.69