27 KVA single phase transformer has a voltage of 13.89 KV on the primary and 235V on the secondary determine the current which will be the basis on the secondary Side when sizing a circuit breaker/fuse. Round off answer to two decimal places

27 KVA single phase transformer has a voltage of 13.89 KV on the primary and 235V on the secondary determine the current which will be the basis on the secondary Side when sizing a circuit breaker/fuse. Round off answer to two decimal places

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.10P: A single-phase step-down transformer is rated 13MVA,66kV/11.5kV. With the 11.5 kV winding...

See similar textbooks

Related questions

Q: What is the voltage across the capacitor when the source voltage is 100V and the Q factor is 10?

A: Given, Source voltage, Vs = 100 V Quality factor, Q = 10

Q: c. For the network below, determine Zi, Zo, and Vo if Vi = 2 mV 12 V 3 k2 120 k2 68 k2 10 µF 0.01 uF...

Q: Q4/ Find the values of incremental fuel costs using LaGrangian multipliers for the two-unit system s...

Q: ple the circuit in Figure 1 with R = 470k2, C = 47µF and source voltage about %3! 5V. Place the swit...

Q: What is the permissible ohmic range of the given resistor? *

A: The solution is given below

Q: Find the total energy stored ( in units of mJ) in the group of capacitors shown below given that the...

A: Given circuit, Voltage across the circuit, Vab=19.4 V

Q: Create a split type zener regulated power supply circuit.

A: Answer - The regulated power supply is indeed an electronic circuit which is designed to provide a p...

Q: j40 le a 30 I2 j20 0.51, 1220 v I3 d I 62 -j307 1020'v A I4 60 8 20°v Ix ell 'n

Q: 1. Find the transfer function, G(s) = V(s)/V(s), for the operational amplifier circuit shown in the ...

A: As per company guidelines we can solve only first question kindly post another question separately

Q: 6Ω 오 20 V 6 A

Q: 2. A diode has a voltage of 0.7 V and a current of 100 mA. What is the diode power?

Q: A 45-km, 220-kV, 60-Hz three-phase overhead transmission line has a per-phase resistance of 0.2 ohm/...

A: Transmission lines- Transmission lines are basically a part of an electrical system, through which e...

Q: Two transformers are to be operated in parallel such that they share load in proportion to their KVA...

A: Given: Two transformers are to be operated in parallel with share load to their kVA ratings. Rating ...

Q: In a Varactor diode, the junction capacitance varies with the reverse bias. Select one: O True O Fal...

Q: 7. How many pairs of poles are required to operate a 60 Hz, 120 V motor at 900 r/min?

Q: Determine the following: (a) Total Current and Total power of the circuit; (b) the current passing...

Q: d. Given the packaged amplifier below, determine the gain AvL and Avs with RL = 1.2 k2.

Q: A sinusoidal voltage with maximum value (336 V), and a Frequency its value (50 Hz), w applied on a s...

A: As per company guidelines we can solve only first three sub parts kindly post another parts separate...

Q: + V2 - + + + V3 V4 V1

Q: Q1)Design moving coil ammeter as a voltmeter to read 15 V (RMS) alternating voltage. If the internal...

A: As per guidelines given to us, we can provide the solution of one question in multiple type of quest...

Q: The rotor resistance and standstill reactance of a 3-phase induction motor are respectively 0.015 oh...

Q: Given thee capacitors C 20 aF. C15 F, and C30 F. what amangement of paeralel and series connections ...

Q: The voltage v = 207 sin(100t+50°) V is connected acroos a 5-H inductor. Determine the inductive reac...

A: Inductive reactance = wL Where w is the frequency in rad/second and L is the frequency.

Q: Using thevenin theorem, determine the charge and discharge equivalent circuits for the Figure 4. ske...

A: Brief description : Here in the question they have mentioned a transient circuit which consists of r...

Q: The organization of a memory chip is 4KX8. How many bits wide is each memory location? 4 8 4K 32K

Q: 2.A series R -L-C circuit is to be made resonance when connected to a 200 – volt 500 cycle source. I...

Q: Find V0 in the network using norton's theorem

A: In this question, We need to find V0 in the network using norton's theorem?

Q: 2.1 Why this is done. 2.2 How pre-emphasis is done. 2.3 How de-emphasis is done.

A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the se...

Q: Determine the resistance of a four-band resistor having a color sequence of red, yellow, black and g...

Q: 1. A system has the following transfer function, derive state and output equations. Y(s) 1 %3D U(s) ...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: A group of cells consisting of four rows connected in parallel, each row containing five cells conne...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: How many GPS Satellites are present?

A: In this case, the number of satellites present in GPS needs to be obtained.

Q: An RL circuit has an emf of 5V, a resistance of 502, an inductance of 1 H and no initial current. Fi...

Q: A 17 KVA single phase transformer has a voltage of 13.9 kV on the primary and 232 on the secondary d...

A: We need to find out primary current for given transformer

Q: Rs 1N4001 100KO A 1000 Rx 5v A 5000 V,x 1N4001 CircuitNumber One CircuitNumber Two Set-up circuit nu...

A: In an electrical and electronics, various circuits are there which perform and indicate different op...

Q: What is a receptacle? What is meant by “service drop”? What are sets of service-entrance conducto...

A: As per the guidelines given, we can only provide the solution of one question in multiple type of qu...

Q: This.

Q: VrtVLtvet 0.06H 0.2mF t. f = 60 V - 310 Find a: It and 2T 6. VR, VL; Va C. PR, PL, Pa

Q: Q 2. What current flows through the Zener diode? 1.8 k2 Iz 15 V Vz = 12 V

Q: Q1)Design moving coil ammeter as a voltmeter to read 15 V (RMS) alternating voltage. If the internal...

A: As per the guidelines, we can only provide the solution of one question in multiple type of question...

Q: A 5 hp motor with a 0.60 lagging power factor and efficiency of 92% is connected to 208V, 60HZ suppl...

Q: An electromagnet is used to support a solid piece of steel, as shown in the figure below. A force of...

Q: If Z= 1/(4 + 8i), then we can write Z as: a. 0.05 + 0.3 i O b. -0.05 - 0.2 i c. 0.05 - 0.1 i d. -0.5...

A: Given, Z=14+8i

Q: ode is used as a voltage regulator.

A: Zener diode : Zener diode is a semiconductor device which have the special property that it allows t...

Q: Explain the working principle of LED bulbs used in homes.

A: LED bulbs use principle of electroluminiscence.

Q: Ci Find the transfer function for the following system. RI R4 R1 R2 R3 C2 ei

Q: 11. F = A'B'C'D' + ABC + ACD + ABD

A: The solution is given below

Q: fourier transform

A: Delta Function- It is also known as the unit impulse function. It's value is equal to zero everywher...

Q: g- The angular frequency for the waveform v(t) = 10 sin 2000t is: 1- 1000HZ, 2- 1000rad/s. 3- 2000 r...

Q: Determine Vout for fig. 2 VEE 5V D1 R1 D2 1.5kO silicon diode Germanium Diode Vout R2 1.5kQ

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

A 27 KVA single phase transformer has a voltage of 13.89 KV on the primary and 235V on the secondary determine the current which will be the basis on the secondary Side when sizing a circuit breaker/fuse. Round off answer to two decimal places

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The nameplate on a transformer will indicate whether or not it is a Class 2 transformer. (True) (False) (Circle the correct answer.)
A single-phase step-down transformer is rated 13MVA,66kV/11.5kV. With the 11.5 kV winding short-circuited, rated current flows when the voltage applied to the primary is 5.5 kV. The power input is read as 100 kW. Determine Req1andXeq1 in ohms referred to the high-voltage winding.
All values of a transformer are proportional to its __________________ ___________________.
A 23 KVA single phase transformer has a voltage of 13.8 kV on the primary and 230 on the secondary determine the current which will be the basis on the Primary Side when sizing a circuit breaker/fuse. round off answer to two decimal places.
A 20 KVA single phase transformer has a voltage of 13.67 on the primary and 240V on the secondary determine the current which will be the basis on the Primary Side when sizing a circuit breaker/fuse. Round off answer to two decimal places
Do you need to connect a fuse in the secondary circuit of a current instrument transformer as protection from short circuits? Yes, but on both sides. Yes. No. Yes, but it must exceed 20 A.
(Please Calculate Correct) The ohmic value of impedance to be connected in the neutral to ground circuit of a 2000 kVA transformer with Earth fault relay set to 40%, with respect to 400 V side calculate ohmic value of impedance?
A 1500 kVA, 3% impedance transformer is to be operated in parallel with a 1250 kVA, 3% impedance transformer, the total load is 2500 kVA, What KVA load carried by each?
1. A 10 kVA, 440/110 V, two-winding transformer is reconnected as a step-down 550/440 V autotransformer. Determine (a) current in the common winding, (b) new kVA rating as an autotransformer and (c) power conductively transferred. BOX THE FINAL ANSWER Subject: Electrical Apparatus and Divices
4. A 200-kVA, 2300/460V, 60Hz two-winding transformer is to be used as an autotransformer to step-up the voltage of 2300V to 2760V. Determine the kVA rating of an autotransformer.
A 220-kVA transformer with .2% resistance and 4% reactance and another120-kVA transformer with 3% reactance and .15% resistance with the samevoltage ratio. the phase angle is 33 degree and the total load .25 MVA.How much the load of each transformer.
A 30 MVA, 18 kV generator is connected to (18/220) kV transformer. If base value of voltage 36 kV is assigned at the generator, then the base value of the voltage in kV at the high voltage side of the transformer is equal to: