29. A cylinder contains an amount of gas. At pressure of 460 kPa and at temperature of 27°C, the gas occupies a volume of 0.08 m. It is then compressed according to Boyle's law until its pressure is 1.2 MPa, and then expanded according to Charles' Law until its volume is 0.05 m. Calculate the final temperature of the gas. a. 292.3500 C b. 248.8500°C c. 216,2250°C d. 280.3181°C

29. A cylinder contains an amount of gas. At pressure of 460 kPa and at temperature of 27°C, the gas occupies a volume of 0.08 m. It is then compressed according to Boyle's law until its pressure is 1.2 MPa, and then expanded according to Charles' Law until its volume is 0.05 m. Calculate the final temperature of the gas. a. 292.3500 C b. 248.8500°C c. 216,2250°C d. 280.3181°C

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter1: Heat, Temperature, And Pressure

Section: Chapter Questions

Problem 17RQ: Convert 22C to Fahrenheit.

See similar textbooks

Similar questions

18 - A cylindrical tank with a diameter of 20 cm and a height of 50 cm was filled with water to a height of 30 cm. If the tank is rotated about the vertical axis of symmetry at a constant speed of 21 rad/s, what will be the pressure difference between the bottom center and bottom edge of the tank? a) 1750 Pa B) 1045 Pa NS) 3327 Pa D) 2205 Pa TO) 1125 Pa
What is the specific weight of octane gas at 1.5 kgf/cm^2 gauge and 60 °F?
A Boeing 767 due to fly from Montreal to Edmontonrequired refueling. Because the fuel gauge on the aircraft was not working, a mechanic used a dipstick todetermine that 7682 L of fuel were left on the plane.The plane required 22,300 kg of fuel to make the trip. Inorder to determine the volume of fuel required, thepilot asked for the conversion factor needed to converta volume of fuel to a mass of fuel. The mechanic gavethe factor as 1.77. Assuming that this factor was in metric units the pilot calculated the volume to beadded as 4916 L. This volume of fuel was added andthe 767 subsequently ran out the fuel, but landed safelyby gliding into Gimli Airport near Winnipeg. The errorarose because the factor 1.77 was in units of pounds perliter. What volume of fuel should have been added?
QUESTION1 1.1 Name and explain three forms of density ?1.2 A mixture of two liquids of equal volume is made; the one has a relative density of 0.8 and the other a density of 980 kg/m3. What will be the weight of 2 500 liters?
1. A full gas cylinder contains nitrogen gas at 70° F and the maximum allowed pressure [2640 lb/in.2 (gauge)]. If it were left in the sun and the contents reached a temperature of 210° F, what is the resulting pressure in the cylinder?
A coal sample gave the following analysis by weight, Carbon 66.9 per cent, Hydrogen 6.58 per cent, Oxygen 8.77 per cent, the remainder being incombustible. For 20% excess air , determine actual weight of air required per kg of coal. Round your answer to two decimal places.
All perfect gases have the same density at 25°C and 1 bar. a) True b) False
A 5-feet diameter Chimney is designed to handle a flue gas produced in a steam power plant at a rate of 17 lb/s. The barometric pressure is 29.92-inch Hg. Outside air enters the combustion chamber at 90 F. The average temperature of the flue gas inside the Chimney is 572 F and its molecular weight is 30. Cv = 0.35, Rair = 53.342 ft-lb/lb-R. Calculate: a. The total draft, feet of air. b. The height of the Chimney, feet
Gas dynamic
AN AUTOMOBILE TIRE CONTAINS 3730 cu. in. OF AIR AT 32 psig AND 800f. (a) What mass of air is in the tire? (b) In operation, the air temperature increases to 1450F. If the tire is inflexible, what is the resulting percentage increase in gage pressure? ( c) What mass of the 1450F air must be bled off to reduce the pressure back to its original value?
A 5-feet diameter Chimney is designed to handle a flue gas produced in a steam power plant at a rate of 17 lb/s. The barometric pressure is 29.92-inch Hg. Outside air enters the combustion chamber at 90 F. The average temperature of the flue gas inside the Chimney is 572 F and its molecular weight is 30. Cv = 0.35, Rair = 53.342 ft-lb/lb-R. Calculate: 5. The total draft, feet of air. 6. The height of the Chimney, feet
SECOND LAW OF THERMODYNAMICS write your soln. complete. draw a sketch and explain if necessesary THANK YOU! answer it in 1hr