3] Consider radiation of wavelength 1 = 700 nm incident on a photodetector whose measured responsivity is 0.4 A/W. What is its quantum efficiency at this wavelength? If the wavelength is reduced to 500 nm, what is the new quantum efficiency assuming that the responsivity is the same? s. 0.7086( 71%), 0.506( 51%)

3] Consider radiation of wavelength 1 = 700 nm incident on a photodetector whose measured responsivity is 0.4 A/W. What is its quantum efficiency at this wavelength? If the wavelength is reduced to 500 nm, what is the new quantum efficiency assuming that the responsivity is the same? s. 0.7086( 71%), 0.506( 51%)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

What maximum frequency of a medium is needed to obtain a capacity of 16 Mbps using 256 signal components?
Calculate the radiation resistance of a current element whose overall length is one-fiftieth of wavelength.
A linear array is to be designed that operates at 10 GHz and has a 1◦ beamwidth (assume uniform illumination). This array must electronically scan to 65 ◦ without grating lobes. What is will the element spacing be? How many elements will be used?
Consider an AlGaAs based hetero-structure laser diode having a cavity length of 150μm. The peak emission wavelength is 850 nm when the refractive index of the crystal is 3.7. a) Determine the mode integer and the wavelength separation between the modes? b) If the optical gain vs wavelength characteristic has a full width half maximum width of 6 nm, how many modes will be there in the given bandwidth? c) If the optical cavity of the laser is formed with cleaved reflectivity of each cleaved laser facet is 45 % and the loss is 10 cm-1 . Calculate the minimum required gain for lasing.
When we talk about electromagnetic energy, what parameter is used to describe it if it represents energy (a) that does not change in time, (b) that changes at rates in the hearing band, (c) that is in the ultrasonic range, (d) that is in the AM radio band, (e) that is in the VHF television band, (f) that is in the FM radio band, (g) that is in the microwave band, (h) that is in the high range for new 5G networks, (i) that is in the infrared band, (j) that is in the ultraviolet band, (k) that is in the x-ray, beta ray, and cosmic ray band?
Calculate the radiation resistance of a current element whose length is one -fiftieth of wavelength.
We have such fiber with length of 4 km and couple light from a single mode laser with center wavelength of 1337.4 nm with FWHM linewidth of 8.7 nm. Please calculate the pulse broadening (in ps) due to material dispersion!
Consider an instrument that transmits radio waves at different frequencies vertically into the ionosphere and measures the time it takes them to return. Using this technique, one can indirectly measure the electron density as a function of height. Assume a ground-based transmitter emits a vertical signal that sweeps over a range of 1 to 15 MHz. If the peak electron density in the ionosphere is 2×106 electrons/cm3, what range of frequencies will be reflected back to the instrument on the ground? Neglect any absorption effects. Frequencies from _____ MHz to ____ MHz will be reflected back. Report answers to 3 significant digits.
A plane wave at 1 GHz is normally incident on a thin copper sheet of thickness t. (a) Compute the transmission losses, in dB, of the wave at the air–copper and the copper–air interfaces. (b) If the sheet is to be used as a shield to reduce the level of the transmitted wave by 150 dB, what is the minimum sheet thickness?
Radiation resistance of a small dipole current element of length at a frequency of 3 GHzis 3 ohms. If the length is changed by 1%, then the percentage change in the radiationresistance, rounded off to two decimal places, is______________%.
Q.2] Explain the detection process in the p–n photodiode. Compare this device with the p–i–n photodiode. Q.3] a) Define the quantum efficiency and the responsivity of a photodetector. b) Derive an expression for the responsivity of an intrinsic photodetector in terms of the quantum efficiency of the device and the wavelength of the incident radiation. c) Determine the wavelength at which the quantum efficiency and the responsivity are equal