3 Ohm 6 Ohm Y + V. La Vs Ohm 2Ve 12 V

Q: Proh 12. Find the Y-parameters of the network shown in fig. 5.38.

A: An electrical circuit having 4-terminal is called a two-port terminal. A two terminal is represented...

Q: Problem: An ABCD-to-seven-segment decoder is a combinational circuit that converts a decimal digit i...

A: An ABCD to  seven segment decoder is a combinational circuit that converts a decimal digit in BCD to...

Q: (c) Find the total power consumed in the circuit of Figure Q1(c) by using mesh/loop analysis.

A: The mesh current can be calculated by writing mesh equation to all the meshes and then by solving it...

Q: A thyristor (SCR) structure is a a. N-P-N-P device b. N-P-N device c. P-N-P ...

A: SCR stand for  silicon controlled rectifier. It is a device that controls current in only one way. I...

Q: (c) A balanced Y-connected source is connected to a A-connected balanced load. The phase voltage of ...

A:

Q: 1Ω is 0.2 H 1. The order of the circuit is: 2. The impedance of the inductor is bs. What is b? 3. Th...

A: Order of circuit is equal to no. Of storage elements. S domain representation of inductor is SL  And...

Q: For a single-tone modulating signal of 5 kHz and a carrier frequency of 600 kHz, list the frequencie...

A:

Q: An input sawtooth waveform with a voltage of 20Vpk-pk at the origin has its negative cycle clipped a...

A: solve the problem

Q: In the circuit in the figure, the apparent power (S) of the second arm is given as 1490 VA. Accordin...

A:

Q: (4+/6)12 (104j12)12

A:

Q: 1. Compute the rms value of the waveform show below. v(t). 2 14 6 8 lho t

A:

Q: Part 4 Bridge Network (a) Construct the network of Fig. 14.4. Insert the measured resistor values. R...

A:

Q: b) Assume that the transmitted signal is s(t) = cos(300 x 10°71) %3D Determine the received signal w...

A: Transmitted Signal- Transmitted Signal is define as the signal which is to be transmitted with the h...

Q: What is the power transmitted by the isotropic radiator having a field intensity of 1.51 V/m at 6om?...

A: Note : After calculating the power transmitted by the isotropic radiator we come to know that none o...

Q: 0.75v, 8Ω 6 V Va 4Ω

A:

Q: What is the magnitude of a vector in a Cartesian coordinate system that originates from the origin a...

A:

Q: the different of Lighting system between Honda civic and Mercedes Benz GL

A: The car's lighting system consists of lights and display lights installed or attached to the front, ...

Q: Bridge Network (a) Construct the network of Fig. 14.4. Insert the measured resistor values. R1 R3 + ...

A:

Q: 1. Design a five turn helical antenna which at 300 MHz operates in the axial mode and possesses circ...

A:

Q: A 25 kVA alternator has a total loss of 2,000 watts when it delivers rated kVA to a load at a power ...

A: In this answer we will try to find the efficiency of the alternator as explained below.  

Q: What current does the ammeter read in milliamperes? Given: Solution:

A:

Q: R2 4 Ohm DI D2 Iş R1 5 A 2 Ohm 4i2 211

A:

Q: Calculate the flux (mWb) in a rectangular core that is 8.0 mm by 7 mm if the flux density is 4.0 Tes...

A: Given,Flux Density (B)=4TArea(A)=8×7×10-6

Q: For a single phase half wave rectifier feeding 10 ohms load with input supply voltage of 796 V and f...

A:

Q: 4. Find the transfer function Vo(s)/V(t), for each network shown in figure 4. 2/ Vo(s)

A:

Q: 3. A glass tube contains an oil of specific gravity 0.85 to depth of 150 cm. Find the gauge pressure...

A:

Q: 2.) Apply the core concepts of Faraday's law to solve the following questions a) State Faraday's Law...

A: We have given the following problem

Q: R2 10 ka R1 10 ka 12 R3 V2 5V V1 MESH 1 10 V 1 ka MESH 2 A. Determine current 12, across the resisto...

A: A.determine current I2 in terms ofI1,R2,R3 B.current I1,I2

Q: If the applied ac power to a system is 5 µW at 100 mV and the output power is 48 W, find the followi...

A:

Q: 12 i, 0.2 H 1. The order of the circuit is: 2. The impedance of the inductor is bs. What is b? 3. Th...

A:

Q: The transfer function of a linear system is 2s H(s) s+6 Find the output y(t) due to the input 5e¯"u(...

A:

Q: Q3: For the class B power amplifier of Fig. 3, calculate:(a) Maximum Po(ac).(b) Maximum Pi(dc).(c) M...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts fo...

Q: Explain charge sheet model of MOSFET transistor.

A: The charge sheet model is done in MOSFET for compressing the inversion layer of the MOSFET and conve...

Q: A 8 pole lap wound armature rotated at 350brpm is required to generate 260V. The useful flux per pol...

A: A DC machine is classified in two types. DC motors DC generators Above question is based on DC gen...

Q: ) A current of 250mA flows through a perfect inductor, when it is connected to a 5V, 1kHz supply. D...

A:  Disclaimer:  Since you have asked multiple questions, we will solve the first question for you. If ...

Q: An SSB system requires 100 W transmitted power for reliable transmission. How much power is needed i...

A:

Q: ) Referring to the waveforms shown in Figure Q1(b), 60 A 60 -20 V Figure Q1(b) (i) Sketch the phasor...

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: A pure 20mH inductor is connected to a 30V, 50Hz supply. Calculate (a) the reactance at this freque...

A: Here, we have given a pure inductor circuit. So, we should have some basic idea about the  working o...

Q: For the following circuit, if Rf= 10KN, R1= 2KN, R2= 1KO, R3= 1KQ, find the output voltage Vo in ter...

A: In this question we will find relation between opamp output voltage and input voltage...

Q: Blondel's theorem is used to specify the number of wattmeters for power (c) measurement in a system ...

A:

Q: The switch has been closed for a long time before it opens at t = 0. After the switch opens, find th...

A: Brief description : Generally transient analysis is applicable only for the circuit which have energ...

Q: 4 N 12 V +1

A:

Q: Compare analog and digital instrument performance.

A: Analog instruments are those that produce output that vary constantly with the amount to be measured...

Q: A compound DC motor with lap-wound armature is connected to a 132V source. Shunt field resistance is...

A: Note : It is not given long shunt OR short shunt so considering long shunt and drawing the equivalen...

Q: Three 8 µF capacitors connected in series will result in ( JuF capacitor.

A:

Q: The impedance of the primary windings of a single-phase transformer with a transformation ratio of 6...

A:

Q: Show that the transfer function of feed back connection is  Y(S)/X(S) = G(S)/1-H(S)G(S) Using Math...

A: In this question we will find transfer function of positive feedback control system.....

Q: Show Work for this question: find V, in the circuit in the figure. 2 mA Vo + 12 kn 6 kN 50 V 12 kN 2...

A: Apply KCL at node connecting the current sources and than find current in 6 ohms resistor.  Now usin...

Q: The circuit of the given figure represents the first three stages of a typical AM or FM receiver. F...

A:

Q: 1. If the input voltage 32VP.P and f=50HZ, sketch the output of the circuit shown below. 10kn TD ZD ...

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.