3. A 120-volt AC voltage is applied across a 20-ohm resistive load. Find values of current, max voltage, peak - to - peak voltage, average voltage, maximum current, peak - to - peak current, average current and power.

3. A 120-volt AC voltage is applied across a 20-ohm resistive load. Find values of current, max voltage, peak - to - peak voltage, average voltage, maximum current, peak - to - peak current, average current and power.

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 2RQ: What is the advantage of alternating current over direct current?

See similar textbooks

Related questions

Q: What will be the voltage drop and regulation in resistive, inductive, capacitive load with the…

Q: Question 1 List the pins on Arduino that can do analog write. In a PWM, given that…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: The speed regulations of two 800-kW alternators A and B, running in parallel, are 100% to 104% and…

Q: what are the types of instruments used for measurement of AC and DC current

Q: Explain with neat sketch the operation of regulated DC power supply.

A: A fluctuating DC voltage supply may result in an unsuitable operation of electronic devices and…

Q: Explain the characteristic of alternator running under load.

Q: List the pins on Arduino that can do analog write.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: B// Explain the important functions of the condenser in a thermal power station.

A: Important of condenser 1. The condenser creates the vacuum required for steam to exit the turbine…

Q: single phase AC/AC converter operates with ON/OFF control. If the input voltage is 220 V, 50 Hz and…

A: The folllowing data is given Vin=220 V,f=50 HZV0=110 Vwe have to findno.of ON cycle=n=TONTno.of OFF…

Q: What is dc and what is ac ?

A: Electricity can flow in two directions, alternating current (AC) or direct current (DC). The passage…

Q: Q22. Define the crest factor of a current waveform and explain why it is important for the rating of…

Q: Every device in a DC, whether a light or electric motor, can be replaced by an electric ________?

A: In DC, light or electric motor can be represented by resistors.In DC, inductor acts as short circuit…

Q: d by a 300-V dc power supply. What is the output voltage range of this chopper if the duty cycle can…

A: Given data: Input voltage, Vs = 300 V The output voltage of buck-chopper is given as, Vo=αVs Here α…

Q: Define the crest factor of a current waveform and explain why it is important for the rating of a…

A: The crest factor of the current AC waveform is the ratio of the higher the number of the nominal…

Q: 2- Did you observe a difference in the values of operate and release voltages in case of AC supply?…

A: Contactors in a motor starter use as a switch. This starter serves two purposes: limiting the excess…

Q: The single - phase ac voltage controller with inductive load. Plot the waveform of output voltage…

A: According to the question we have to plot waveform according to given conditions.

Q: Given field excitation at 10A in an alternator that exerts current of 150A (short circuit) and a…

A: The solution is given below

Q: 5. Why the efficiency of large size alternator should be larger than that of small size?

A: Because conducting material have wide contact with atmosphere in large size alternator, the heating…

Q: The AC Voltage controller shown below is used for heating a resistive load of 5 Ω and the input…

A: Given,Vs=120 Vf=60 Hzn=125 cyclesm=75 cyclesR=5ΩVm=2×120=169.70…

Q: How to measure high alternating currents and high alternating voltages during the transmission and…

A: The device that is used to measure the high alternating current is known as the current transformer.…

Q: Explain in your own words what an Aircraft Alternating Current (AC) System is?

A: An Aircraft Alternating Current AC System is the network of the generation , transmission…

Q: 1. Compare the reaction of Dc motor and dc generator. Also explain rule by which DC generator/motor…

A: The effect of the armature flux on the main field flux is known as armature reaction. It causes very…

Q: Define three (3) advantages of alternating current (AC) for long distance power ransmission compare…

Q: Explain AC exciter with an example.

A: It is asked to explain AC exciter with an example. The system which is used to provide the necessary…

Q: What causes sparking at the brushes

A: In this question, we need to discuss about the cause of the sparking at the brushes.

Q: volt, 50 Hz supply, the secondary is open circuited. If the power absorbed 72 watts, find (a) iron…

Q: HOW TO Plot on the same graph two cycles of the primary current, the primary flux linkage, he…

A: Two coils share a common magnetic flux in the transformer. Phaser diagram: (V:alternativie)…

Q: The single - phase ac voltage controller with inductive load. Plot the waveform of output voltage…

A: Draw the circuit diagram for a single-phase ac voltage regulator with the inductive load as below.

Q: What is the difference between the AC and DC supplies?

Q: What will be the frequency (in Hz) for 100kW, 230V, 12-Pole, alternator running at 12 rps?

Q: 6. A relay has a resistance of 350 ohms and an inductance of 0.8 henry. When 57 volts is suddenly…

Q: 2. A DC to DC buck converter has a 400V DC source and feeds a resistive load of 25 ohms. a) If…

Q: For a star connection network, consuming power of 1.8kW and power factor 0.5, compute the inductance…

A: In a three phase system there are two ways to connect a three phase load. Star/Wye Connection Delta…

Q: Introduction and explanation about alternator regulation

Q: e) What causes frequency variations in the power system? What determines the direction of frequency…

A: A healthy power system always operates at a constant frequency. There are two major reasons of…

Q: Why we do not usually operate AC circuit at max power?

Q: What is the effect of the field excitation to the short circuit current of the alternator?

A: The short circuit current of alternator is given as: Ia=EfjXs Here we have neglected armature…

Q: List any two merits and demerits of hydroelectric power plant.

A: Need to find merits and demerits of hydro power plant

Q: Describe the efficiency of an electric motor decreases at part load.

A: A motor is an electromechanical device which is used to convert the electrical power into mechanical…

Q: block diagram of the electromechanical energy conversion of a power tool

Q: 2. Suppose 2000 turns of copper wire are wrapped around one portion of an iron hoop, and 3000 turns…

Q: What is the power factor for a load connected to an AC source?

A: Real power: If the power dissipated by a load then its called real power or true power. It is the…

Q: 2. What is the relationship between the clipping level and the DC voltage?

A: The maximum DC voltage level will serve as the reference point for clipping, in such a way that any…

Q: 1. Thyristor switched reactor(TSR) for power factor improvement (i need explained if possible)

A: 1. Thyristor switched reactor(TSR) for power factor improvement

Question

3. A 120- volt AC voltage is applied across a 20- ohm resistive load. Find values of current,
max voltage, peak – to - peak voltage, average voltage, maximum current, peak - to
- peak current, average current and power.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

a. Draw the relationship between excitation current and short circuit, and Please explain. b. At what volts is the alternator end voltage short-circuited? At nominal voltage What will happen if a short circuit is made?
Define all the power related to the ac circuit.
Given field excitation at 10A in an alternator that exerts current of 150A (short circuit) and a terminal voltage of 900 volts (open circuit). what is the internal voltage drop given load current at 60 amperes is being applied?
A dc-source has positive and negative polarities. Is it correct to say that an ac-voltage source has no polarity? Why or why not?
Suggest a scenario where a DC supply might offer a better alternative to AC.
1. Find the required single-phase excitation voltage at rated voltage and frequency, in Volts 2. Find the required single-phase excitation voltage when both terminal voltage and frequency are 80% of their rated values, in Volts
What is the difference between the AC and DC supplies?
Using the polarity tester how can we tell the difference between DC voltage and AC voltage?
what is a difference between AC AND DC load line
Whats is an ac circuit? Determine and explain the electrical power in AC circuits and how it works. (in paragraph form)
Explain the basic principles of electrical generation in a thermal power plant.
Introduction and explanation about alternator regulation