3. A 15-AN truck having the wheel loads shown runs on top of a truss bridge as shown below. Assume the truck can travel only from left to right on the bridge. Also assume the members are pin connected at the gusset plates. The maximum tension in member BJ is mostly near: (15%) (A) 6kN (B) 9kN (C) 15kN (D) 18.75kN

3. A 15-AN truck having the wheel loads shown runs on top of a truss bridge as shown below. Assume the truck can travel only from left to right on the bridge. Also assume the members are pin connected at the gusset plates. The maximum tension in member BJ is mostly near: (15%) (A) 6kN (B) 9kN (C) 15kN (D) 18.75kN

Mechanics of Materials (MindTap Course List)

9th Edition

ISBN:9781337093347

Author:Barry J. Goodno, James M. Gere

Publisher:Barry J. Goodno, James M. Gere

Chapter1: Tension, Compression, And Shear

Section: Chapter Questions

Problem 1.4.14P: A crane boom of mass 450 leg with its center of mass at C is stabilized by two cables AQ and BQ (Ae=...

See similar textbooks

Similar questions

The figure shows a three-pin arch. Determine the horizontal component of the pin reaction at A caused by the applied force P.
Repeat Prob. 4.152 assuming that the 400-kN force is applied at O instead of L.
A bungee jumper having a mass of 55 kg leaps from a bridge, braking her fall with a long elastic shock cord having axial rigidity EA = 2.3 kN (see figure). If the jumpoff point is 60 m above the water, and if it is desired to maintain a clearance of 10 m between the jumper and the water, what length L of cord should be used?
A crane boom of mass 450 leg with its center of mass at C is stabilized by two cables AQ and BQ (Ae= 304 mm2 for each cable) as shown in the figure. A load P = 20 KN is supported at point D. The crane boom lies in the y-z plane. (a) Find the tension forces in each cable: TAQand TBQ(kN}. Neglect the mass of the cables, but include the mass of the boom in addition to load P. (b) Find the average stress (s) in each cable.
Find the support reacions and joint force of the construction shown on the figure, if; P=12 kN q=9 kN/m M=12 kN and L=2 m
Two gondolas on a ski lift are locked in the postion show in the figure while repairs are being made elsewhere.The distance between support towers is L = LOO ft.The length of each cable segement under gondolas weighing WB= 450 lb and Wc=650 lb are DAB=12 ft, DBC=70 a , and DCB=20 ft . The cable sag at B is AB = 3.9 ft and that C is A = 7.1 ft.THe effective cross-sectional area of the cables is Ae=0.12 in". (a) Find the tension force in each segment; neglect the mass of the cable. (b) Find the average stress(σ) in each cable segment.
The simplest truss consists of two rods and is loaded by the block. Given: block weight Q = 9,4 kN. Angle α = 31 degrees. Find: the algebraic (positive or negative) value (in kN) of normal force N1 in the rod 1, considering that N1>0 for tension and N1<0 for compression.
The simplest truss consists of two rods and is loaded by the force F. Given: F = 5,1 kN. Angle α = 69 degrees. Find: the algebraic (positive or negative) value (in kN) of normal force N1 in the rod 1, considering that N1>0 for tension and N1<0 for compression.
nonuniform beam 4.50 m long and weighing 1.40 kNmakes an angle of 25.0° below the horizontal. It is held in position bya frictionless pivot at its upper right end and by a cable 3.00 m fartherdown the beam and perpendicular to it . The center ofgravity of the beam is 2.00 m down the beam from the pivot. Lightingequipment exerts a 5.00 kN downward force on the lower left end ofthe beam. Find the tension T in the cable and the horizontal and verticalcomponents of the force exerted on the beam by the pivot. Start bysketching a free-body diagram of the beam.
A loading car, as given in figure, is at rest on a track forming an angle of 25 with the vertical. The gross weight of the car and its load is 5500 lb. and it is applied at a point 30 in. from the track, halfway between the two axles. The car is held by a cable attached 24 in. from the track. Determine the tension in the cable and the reaction at each pair of wheels.
Find the support reactions and joint force of the construction,shown on the figure ,if P=12 kN q=9 kN/m , M= 12 kN , and L=2m
A 2.3 m long stick with a uniform mass distribution extends horizontally from abuilding. There are two wires attached to the stick, wire A is attached to the beam 3/5 of theway from the building to the end of the stick, it pulls up at a 63° angle to the stick; wire B isattached 1/6 of the way from the building to the end of the stick, and pulls it down at a 32° angle to the stick.The tension in cable a is 112 N. What is the tension on wire B?