3. A door leaf is designed to be free to move in the direction of the x and y axes with the hinges attached to the z-axis. If the door handle is at (1,0,1) and you are pushing the door with force (5,2,1), find the torque against a hinge attached to (0,0,1). Also determine the torque of the door against the axis of the door.

3. A door leaf is designed to be free to move in the direction of the x and y axes with the hinges attached to the z-axis. If the door handle is at (1,0,1) and you are pushing the door with force (5,2,1), find the torque against a hinge attached to (0,0,1). Also determine the torque of the door against the axis of the door.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.15P: The structure is supported by a pin at C and a cable attached to A. The cable runs over the small...

See similar textbooks

Similar questions

Determine the resultant internal torque acting on the cross sections through points B and C. Please help me with this exercise with a complete solution so that I may study it later on. thank you.
Find the magnitude of the torque about P if a 36-lb force isapplied as shown in #40.
What is the mass supported as shown, when the torque created by an axis at position A is 1800 mN?
, The total torque of the forces on the ruler around a axis perpendicular to the ruler and passing through point 0 is t=-7N.m Calculate the value of the force F
Show the location of the axis of rotation and r for each force that produces torque in the diagram. Also, check calculations, I am off by 1 degree.
Find the internal force systems acting on sections 1 and 2.
The structure is supported by a pin at C and a cable attached to A. The cable runs over the small pulley D. Find the internal force systems acting on sections 1 and 2.
What is the y component of a force with magnitude of 5kn applied 120 degrees with respect to the positive horizontl axis?
Find the normal force at the point Q
A piece of metal subjected to three forces is fold as shown in the figure. Replace the three forces with a wrench equivalent torque and determine: (a) The magnitude and direction of the resulting R. (b) The pitch of the torque wrench. (c) The point where the axis of the wrench torsion intersects the yz plane.
A thin rectangular plate is acted upon by 4 forces as shown. The 200 N makes an angle of 30 degrees with the horizontal. a. Calculate the net torque on this plate about the center A due to the four forces shown assuming there is no friction at the center. b. Calculate the net torque on this plate about the center due to the three forces shown if there is a frictional torque of 10.0 Nm at the center.
solve this without the application of MOMENTS please. the answer is attached also