Answered: 3.) Express the following functions in…

Engineering

Electrical Engineering

3.) Express the following functions in cosine form (a) 4 sin/wt - 30 ) (b) –10 sinlwt + 20)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.3MCQ: If a phasor representation of a current is given by I=70.745A, it is equivalent to a. 100e/45 b....

See similar textbooks

Related questions

Q: R1 1k V1 VOFF = 0 VAMPL = 4V FREQ = 10kHZ C1 0.1uF Figure 2 2.3 Plot the waveform v for the voltage…

Q: Calculate Fermi Function in the following scenarios: Energy level at positive infinity

A: Fermi function when the energy level at positive infinity....?

Q: wwwmm -/20 60 For the circuit shown, ifI=24, the reactive power absorbed by j4 Q inductor in VAR is;…

A: The given circuit is: The parallel combination of 6 and -j2 can be solved as:

Q: ermine the following, . Amplitude i. Frequency ii. RMS value of Voltage Figure Al

A: Bartleby has policy to solve only first 3 subparts of a question. So reupload the question

Q: Question. The figure given below is a plot of a sinusoidal wave. From the plot, determine values for…

Q: 16.) Calculate the inductance or capacitance in series for the impedance 60240° ohms. Assume the…

A: We need to find out the value of inductance for given impedance

Q: 10. Find an expression for the equivalent inductance for the circuit shown Leq = Lea elle elle

A: Given circuit,

Q: 2. What is the value of a sinusoidal voltage at 5 us (micro second) from the positive going zero…

A: 2) To find the value of a sinusoidal voltage at 5 microseconds Given: Vp = 20 v and f = 50 kHz

Q: Derive the formula for the RMS value for the following

A: In this question, We need to derive the formula for the RMS value for the following.?

Q: Find the following paramters of the waveform given above: a) Vp-p= V b) Vmax = V c) Vave(half-wave)=…

Q: Vpk wt 2n

Q: What is the value of form factor of sinusoidal voltage?

A: form factor is the ration of the rms value to the average value

Q: Find the following paramters of the waveform given above: a) Vp-p= b) Vmax = V c) Vave(half-wave)= V…

A: In this question, Waveform is given Find the all unknown parameters as per required.

Q: A sinusoidal voltage with effective value

Q: A sinusoidal voltage trace displayed by an oscilloscope is shown, if the 'time/div' Hs, switch is on…

Q: pure capacitor

A: Conductor-Materials which have free electrons in valence which can flow when comes under any…

Q: State the phase difference between voltage and current of an inductor in an AC circuit with one…

Q: 7 Find the average and effective values of voltage for sinusoidal waveform shown in Figure. Vm = 100…

A: Given Waveform in the question, Form the above figure, it can be observed that the waveform is an…

Q: 15 Ω woa юа 10j Q 10210° Awgk/rms

Q: Given the inductance of 2.5 µH with a reactance of 400 Ω. What will be the value of the frequency?

Q: What will be the impedance of an inductor of inductance 15.5 mH when it's connected to an ac source…

A: The impedance of an inductor of inductance L can be expressed as

Q: Express the sinusoidal waveform υ(t) = −4sin(8π ×103t −45o) V in standard cosine form and then…

Q: Q5:-An electron [pc-620 keV and Eo-511 keV]. Find the phase and group velocities of its de Broglic I…

Q: i) Define R.M.S value of an alternating quantity and derive its expression for sinusoidal current.

A: To calculate the rms value of sinusodial current and define thr rms?

Q: What is the peak current in a AC circuit with a 50 ohm resistor, 3.3 mH inductor, and a 480 nF…

A: This is the series RLC circuit and concept of resonance Use fundamental formulas

Q: B. Determine the instantaneous value of a sinusoidal waveform.

Q: Given a sinusoidal voltage v(t) =200cos(377t + 30degrees) volts. What is the smallest positive value…

A: Sinusoidal signal is a periodic signal. The signals which repeats itself after a certain period T…

Q: Q2JA) Evaluate the following integration Sin (8t) dt

A: In this question we need to evaluate the given integration.

Q: 1k 50 mH 50 nF 1 sin2pi1000t 1 cos2pi1000t

Q: A 70-Vac source has the following waveform. Determine: a. Vpk b. Vpk-pk c. Vrms d. Period e.…

A: Note :- As per guidelines we are supposed to answer only first 3_sub-parts. So I request you to post…

Q: 3. Write the sinusoidal expressions for voltages and currents having the following rms values at a…

A: Dear,as per company guidelines we can answer only one question at a time, kindly post other question…

Q: 5.) Calculate the inductance or capacitance in series for the impedance 502-60° ohms. Assume the…

A: We need to find out the value of capacitor

Q: 1. Derive the formula for the RMS value for the following a) tespe 文 RSITY SAIN

A: The solution is given below

Q: Determine the peak-to-peak voltages, RMS voltage, frequency, period and phase shift for the…

Q: Q9. Which of the following is one means by which energy or electrical noise can couple from one…

A: Coupling capacitors are used in electronic circuits to pass the desired AC signal and block unwanted…

Q: A sinusoidal voltage has a peak amplitude of 12 volts at t = 60 ms. Determine its equation as a…

A: It is given that the sinusoidal signal has a peak voltage of 12 and the peak happens ar 60 ms.

Q: 元。 Coil 1 Coil 2 (も)

A: The equation for induced emf across the two inductors is as follows: When there is change in I1…

Q: The current through the 20-Ohm inductive reactance is given. What will be the sinusoidal expression…

A: The voltage across the inductor can be evaluated using the Ohm’s law:

Q: 4. Given that power is the product of voltage and current (p = i e), plot the waveform for power for…

Q: following voltage expression: v=150sin(40 pi t) + 52sin(280 pi t) Find: a) The…

Q: ?What is the period of the following sinusoidal voltage signal v(t) = 158 cos (304t + 16°) V .Write…

A: The time period can be given as

Q: A telephone receiver has an impedance of 306 ohms at 800 cps and a resistance of 60 ohms. For what…

Q: 2.It is possible to use the voltmeter for measuring the non sinusoidal A.C voltages ? and is it…

A: Yes it is possible to use a voltmeter to measure non-sinusoidal AC voltage. Oscilloscope (CRO) is…

Q: Calculate the value of capacitance required to produce 150 Ω of reactance at 950 MHz. Round the…

Q: Given the sinusoid v(t) = 30 cos (240pt + 45°) V. %3D a. Determine the effective value, RMS, angular…

Q: For the following pairs of voltage and current, indicate their phase relationship (e.g. v leads i by…

A: Voltage leads current by 90 in inductive circuit Voltage lags current by 90 in capacitive Voltage…

Q: Find the closest standard value inductance that has the reactance of 2ohm at frequency of 14.47kHz

A: The inductive reactance of the coil is:

Question

100%

3.) Express the following functions in cosine form
(a) 4 sin/wt - 30 )
(b) - 10 sin/wt + 20)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If a phasor representation of a current is given by I=70.745A, it is equivalent to a. 100e/45 b. 100+j100 c. 50+j50
Complete and clear solution pls. Sinusoidal voltages and currents
Given the system below, find the sinusoidal expression for the unknown current ?1 if i? = 30 × 10−6 sin(?? + 80°) and ?2 = 4 × 10−6 sin(?? − 50°).
A certain circuit element is known to be a resistance, an inductance, or a capacitance. Determine the type and value (in ohms, henrys, or farads) of the element if the voltage and current for the element are given by a. v(t) = 100 sin (200t + 30°) V, i(t) = cos(200t + 30°) A; b. v(t) = 500 cos(100t + 50°) V, i(t) = 2 cos(100t + 50°) A; c. v(t) = 100 cos(400t+30°) V, i(t) = sin(400t + 30°) A.
2. At what frequency will a 2-μH inductor have a reactance of 300 ohm? note: write by computer
Given a sinusoidal voltage v(t) =200cos(377t + 30degrees) volts. What is the smallest positive value of t at which the voltage v will be equal to zero?
What impedance vector 10 + j22 represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a resistance.
Two sinusoidal voltages of the same frequency have rms values of 8 V and 3 V. What is the smallest rms value that the sum of these voltages could have? The largest? Justify your answers.
A 50 Hz, alternating voltage of 150 V (rms) is applied independently to (a) Resistance of 10 Ω, (b) Inductance of 0.2 H, (c) Capacitance of 50 μF. Find the expression for the instantaneous current in each case. Draw the phasor diagram in each case.
Exercise 2: Resistance-Capacitance Series Circuits on an AC Supply Calculate (a) peak to peak voltage (b) time period (c) Total impedance (d) Total voltage and (e) Voltage across the resistor for the circuit given.
3. A voltage across a 0.5 H is provided below. What is sinusoidal expression for the current? e =100 sin 20 t4. The voltage across 1 micro farrad capacitor is provided below. What is the sinusoidal expression for the current? e= 30 sin 400 t
1. Transform these sinusoids in to phasors 2.If voltage v= 10cos(100t + 30°) is applied to a 3uF capacitor, calculate the current through the capacitor.