3. Find for the given circuit the following (f=25 kHz): a. Itot b. Ptrue. c. Pr d. Pa S 12/0° V R₁ ww 220 Ω R₂ www 390 Ω 42 L₁ m m 0.5 mH 1 mH C₁ 0.01 μF C₂ 1800 pF

Q: Gy(x) H₂(s) G2 H₁0 G3(s) G₁(s) -exas H11 G(s) Ges Hy(s) G,(s) Find the universal transfer function…

A: In this question We need to determine the transfer function using the Mason gain formula.  We know…

Q: 3. Suppose the voltage on a load terminals is equal to v(t)=311.12cos(wt+30) and the current is…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: Write the output expression for each circuit

A:

Q: a) Draw the root locus for P(s) = = s(s+1.2)(8+2) b) Find the range of K that keeps the system…

A:

Q: The frequency of rotor current in an induction motor is       slip times the frequency of stator…

A: The frequency of the rotor is based on the value of slip and input frequency. The slip value can be…

Q: 19. Express the total impedance for the given circuit in both polar and rectangular forms. Xc 25Vrms…

A:

Q: Q.1 (Fill in the Blank): ________________ is the conversion of discrete-time continues-valued signal…

A: The process of converting discrete-time continues valued signal into a discrete-time discrete-valued…

Q: Determine:   a) The circuit impedance, Z, in Complex form   b) The circuit current, IS, in…

A: We need to find out the impedance and current for given circuit.

Q: G(S) K(S+20) S(S+ 2) (S + 3)

A: R H Criterion Find Characteristics equation 1+G(s) H(s)=0 Find RH Criteria Table The first-row…

Q: A point electric charge +5nC moves past point P(3 m, 4 m, 5 m) with a velocity v = v(3 ax - ay +2a₂)…

A:

Q: Example 2. In Figure 4, if R = 100, L=5H, and C=2mF. Find a, w, s₁, and s₂. What type of natural…

A:

Q: Using two pairs of emitters and detectors allows turning an incremental shaft encoder into an…

A: The answer is option 2 2. Usually the two emitter/detector pairs are out of phase by an angle of 90…

Q: 10. Initially, the capacitors in the circuit in the given figure are uncharged. Determine the…

A:

Q: Q3 For the given circuit, I₁ = I2 = 0,5 mA and RD-2,8kQ2. Current gain of Q3 transistor is ß= 80.…

A:

Q: find out the stability of the following closed loop transfer function by using routh hurwitz criteon

A:

Q: Pulse width modulation (PWM) can be used to control the speed of a DC motor. Which statement is…

A: The correct statement is statement 4

Q: 1.7 The charge flowing in a wire is plotted in Fig. 1.24. Sketch the corresponding current. q (C) A…

A: The current through a device is defined as change in charge per unit time. In differential form,…

Q: Q1:-Design and connect a subtractor operation amplifier circuit if the R1=R2=R3=Rf and V1=2V, V2=5V,…

A:

Q: Q.1. Find the current through the 100 resistor utilizing Thevenin's Theorem. ₁-20 V₁-10V 52-502…

A:

Q: For the open-loop pole-zero plot in the following figure (with unity feedback): R(S) G(s) with G(s)-…

A: Given, Gs=ks+1s+2s+3.

Q: b) Design (Find the values of L₁, L2, and C) the oscillator circuit shown in the below figure to…

A: We need to find out the value of inductor for given oscillator .

Q: The switch in gure Q.2 has been in position 'a' for a long time. At moves to position 'b' (a)…

A:

Q: 3. Suppose the voltage on a load terminals is equal to v(t)=311.12cos(wt+30) and the current is…

A:

Q: The DTFT of x[n] is X(w). Express the DTFT of following signals using X(w). n is even n is odd 1)…

A: Given: 1)x3(n)={x(n/2),for n=even0,for n=odd we need to express DTFT of above signals in terms of…

Q: (a) A 20 kVA,2000 V/500 V, 50 Hz single phase transformer has the following parameters: Primary…

A:

Q: Q2:- Draw the circuit of the single stage transistor amplifier2) How could you increase the output…

A:

Q: Using matlab solve the following %% PROGRAM ON RESPONSE OF LTI SYSTEMS TO ARBITRARY INPUTS x =…

A: Given: MATLAB code to compute convolution of two arbitrary sequences. To find: Convolution of…

Q: Obtain the transfer functions C(s)/R(s) and C(s)/D(s) of the system shown in Figure R(1) Ge G₁ H H₂…

A: Introduction Transfer Function: For all conceivable input values, a transfer function shows the…

Q: 10/0°v( + j1 Ω -j1 Ω 1ΩΣ 2/30° A

A: Circuit is given as:

Q: Q) single-phase bridge rectifier has an RL load with R=15 Ohm and L = 60 mH. The ac source Vs = 100…

A:

Q: A three-phase, full-wave half-controlled rectifier bridge circuit is operating at a delay angle a =…

A:

Q: a) Design (Find the values of Rf, Ri, C₁, C2, and L) the oscillator circuit shown in the below…

A: Given: f0=20 kHz and Av=-8.

Q: The principle of operation of a 3-phase Induction motor is most similar to that of a…

A: The 3-phase induction motor works on the principle of electromagnetic induction. It has both the…

Q: 2. A B What particle has an electrical charge -1.6-10-19, Electron Proton C Neutron D Atom Coulomb?

A: Charge  The physical characteristic of matter that causes it to feel a force when exposed to an…

Q: Two coils having inductance of 0.2H and 2.45H are coupled and their mutual inductance is 0.14H. The…

A: Given- Inductances of coils- L1=0.2 H,L2=2.45 H, Mutual inductance M=0.14 H, To Find- The…

Q: QI 1) Convolution: If the y[n] 16,2*,-3,5,7,1; and x[n] 13,2*.-1.4; find h[n] using Iterative…

A:

Q: Evaluate 1. For the following pairs of sinusoids, determine which one leads and by how much. (a)…

A: The given sinusoids can be converted into either sine or cosine form by adding required phase angle…

Q: 1. What property/properties does the discrete time system exhibit? (check all that apply) Yn = x…

A:

Q: Q-switching technique based You Building a fast generic lasing medium to increase the production of…

A: Switching techniques: It is based on building a fast generic lasing medium and reducing the output…

Q: Q4- Calculate Vo in the op amp Circuit for given Rf =w (open Circuit) 15mV 5 ΚΩ 15 ΕΩ ΣΚΩ Rf |11 www…

A:

Q: -pole induction generator connected to grid, has a slip of 4 percent when operating at full- load…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: For the network with CE in placed, determine Rin in ks (using appropriate approximations). V₁ HH 1₁…

A: We need to find out the input impedance for given circuit , first we will do DC analysis then small…

Q: 4. Assume Q₁ = Q₂ and Q3 Q4 = Q5. Neglect the base current. (a) What are the advantages of using…

A:

Q: A 50-HP 400-volt 12-pole 60-Hz wye-connected 3-phase synchronous motor has armature resistance of…

A:

Q: the network with CE unconnected, determine Rout in ko (using appropriate approximations). =5 Z www…

A:

Q: The maximum current in this circuit passes through R2 because it is the smallest of the currents.…

A:

Q: Consider a binary symmetric channel with flip probability p. What is the transition probability…

A: We need to find out state transition matrix .

Q: Question 6 Determine VE. 10 μF 180 K ww 9V 2.7 k its 10 pF B-200, 32

A: We need to find out emitter terminal voltage for given circuit .

Q: Design D flip-flop and JK flip-flop by using T flip flop.

A: We need to design the D and JK flip flop by using of T flip flop .

Q: Using the characteristics of Fig. a. Determine the difference in drain current (for Vps > Vp)…

A: The value of drain current can be obtained from the given graph and the change in drain current can…