3. Find the transmission parameters of the circuit as shown in the figure. 30 2 40 2 60 2 6.3 472 2 Answer: [T] = [0.425 S 32 20 Ω 50 Ω 20 Ω

Q: Change the value of the resistor such that the final current is 90mA. What is the calculated resista...

A:

Q: Two positive charges Ql and Q2 are separated by a distance r. The charges repel each other with a fo...

A:

Q: A current transformer has 15 turn on the primary and 75 turn on the secondary. The relay burden is (...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: Question No.33 In a single connected to infinite bus bar system, alternator voltage is 1.5 pu and it...

A: Given, Alternator or generated voltage, Eg=1.5 pu Terminal voltage, Vt=1 pu (as reference) Reactance...

Q: Provide 2 examples of open-loop and closed-loop control system. Identify the input, output, and proc...

A:

Q: You are to asked to generate a 12 Hz, 10% duty cycle pulse wave using a 16 bit timer on the Arduino ...

A: The duty cycle is a measurement of the input signal's peak-to-average ratio over time. Although ampl...

Q: 3.- Express the following terms in their polar form. a) -18.5-j26.1 b) 17.9-j12.2 c) -21.6+j31.2.

A: (a)  -18.5-j26.1=-18.52+-26.12tan-1-26.1-18.5=31.99∠54.670  

Q: 50. It is the resistance of a material when there is no supply. Hot Resistance Infinite Resistance ...

A:

Q: : Derive an expression for voltage equation then, current equation.  Find:  a. Capacitor Current E...

A: In this question, We need to derive an expression for voltage equation then, current equation.  Capa...

Q: . Assuming the passive sign convention and an operating frequency of 5 rad/s, calcualte the phasor v...

A:

Q: 13 Obtain Fourier series where f0 = of period 2t for $c ), -下SYくO メ oく*くて

A:

Q: ONE-STALE PILTER Vin Vout onalhsupe

A: We will apply virtual short principle to find transfer function of op-amp. We have: VinR1+1sC1=0-Vou...

Q: A coil of 20 ohms resistance has an inductance of 0.2 H and is connected in parallel with a 100 micr...

A:

Q: The base impedance and base voltage for a given power system are 10Ω and 400V, respectively. Calcula...

A:

Q: Example:find the current through the 10 ohm resistor.

A:

Q: The maximum value of the load resistance is given by: (R, + R ) V. sat :- R3 m Rm = R, + R, + R,

A: Apply Kcl and Kvl at load terminal  when we keep increasing Vin Vo will get saturated Vsat.

Q: -10 931+1=2"{-1+31 10 (-1+i) = -8(1+l} %3D

A:

Q: a), with Consider the sum of harmonic motions *(t) = x, (t) + x2(t) = Acos (wt + x, (t) = 15 cos wt ...

A: The solution is given 

Q: 4.- Express the following terms in their rectangular form. a) 32ej125.3° b) 21.7ej34.3° c) 37.9ei124...

A:

Q: mee point charges are located as shown in the figure: • q = 2x 10-12 (C) and d = 3 [cm] • 2 = 6x 10-...

A:

Q: ) The following figure shows a transistor-level (CMOS) circuit for some logic gate. Sketch the logi...

A: The transistor-level (CMOS) circuit is shown below,

Q: what are the electrical, electronic, and robotic components of the robotic circuit?

A: The major electrical components of the robotic circuit are as follows:  Resistors  Capacitor  Induc...

Q: vz = 150 sin 314.2t and vz 90 sin (314.2t – ) volts respectively. Determine a) the voltage of the su...

A:

Q: 3) Determine (V,) for the circuits below using superpositic ww SIx ww Vx 10 V 2 A

A: Given circuit shown       

Q: 26. Transform each of the following into phasor form: (a) 11 sin 100t; (b) 11 cos 100f; (c) 11 cos(1...

A:

Q: Explain how zone protection applies to the power system from generation to transmission line. Show t...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: 45. The average power absorbed by an inductor is zero. Neither True False Either

A:

Q: Using 220kVA and 11kV as base values, express 138kV, 2MVA, 60A, and 660Ω as per unit values.

A:

Q: 32. A time domain circuit with  v(t) = 100 sin(377t) in 5mS, what is the effective current if the lo...

A: 32. v(t) = 100 sin(377t) v(t) = vm sin(wt) Where vm = 100 v Load R = 10 ohm Vrms = 0.707 vm   = 0.70...

Q: 29. The following figure shows the circuit design of logic operations. Select a FALSE statement. an...

A: The given circuit design of logic operations is shown below,

Q: 3. Determine the impulse response of the initially relaxed system below. x(n) +) +) y(n) 0.2 0.2

A: The time domain signals can be continuous or discrete. The time domain signals can be periodic as we...

Q: Consider two charge Q1 = 9 × 10-0 [C) and Q2 = 5 x 10- [C) separated by a distance r = 0. 05 (m). a....

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: H.W. 1 Write out the First three terms of the following infinite series: (-1)" Sin nt cosnt nt 2. n=...

A:

Q: The value of Qe supplied by the generator for the specification E = 1.53 p.u, V = 1 p.u, 80 = 21.5, ...

A: When an alternator is connected to a bus of Voltage V, then supplies active power to the Bus bar. An...

Q: SELF-TEST 1. Draw the schematic symbols representing the SPST, SPDT, DPST, and DPDT manu- ally opera...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for yo...

Q: Find the phase current if a three-phase star-connected system is connected to a 400 V, 50 Hz AC supp...

A: Given a three phase star connected system is connected to, Line voltage, VL=400 V Phase impedance, Z...

Q: A capacitor is connected in parallel with a coil having L = 5. 52 mH and R = 10 ohms to a 100 V, 50 ...

A:

Q: Q/ Calculate the value of the current shown in the cirauit below, given that thevalue of the resista...

A: The solution is given below 

Q: 3) What are the rise time, fall time, and average propagation delay of the NMOS gate in the below fi...

A:

Q: What mass of water can be heated from 25.0° C to 50.0° C by the addition of 2825 J? O 27 gm O 22 gm ...

A: Given, Initial temperature (T1) = 25.0°C Final temperature (T2) = 50.0°C Quantity of heat (Q) = 2825...

Q: 1. Properties of Linear Convolution include. Commutative %3D (u) Ix * (u)Tx= (u)7x * (u)'r Associati...

A:

Q: 3. Simplify the following expression in sum-of-products form using a 4-variable gh map. f (w, x, y, ...

A: Given Boolean expression  f(w,x,y,z)=w¯ x¯ y¯ z¯+w¯ x y¯+xy¯z+w¯yz¯

Q: D Find the Fourier expansion for the function fit)= t_t3 in the intervad -ist <I

A:

Q: Analyze the given circuit and determine the minimum and maximum input voltage that the given Zener d...

A:

Q: Ps: The differente equation of the Rillowing. dingram. is 3. -4

A: Block deduction- In control system, the whole system is represented in block form which are deduced ...

Q: For the system shown take the output to be the displacement x1. Find the response of the system to a...

A:

Q: 16 V 5.6 k2 V. Si -4 V

A:

Q: HiW. 2 D Find the Fourier expansion for the Function fit) = t- t³ intervad in the %3D

A: Note: We are authorized to answer one question at a time, since you have not mentioned which questio...

Q: VcC 10V R1 10kn 10% RC {3.6kN 10% C2 B = 150. 01 2N3904 RS C1 1kn 10% RL vs 1.5kn 10% CE 470uF R2 RE...

A: We need to find out the voltage gain for given circuit

Q: ) Find the current (1) in the circuit below using the superposition principle. ww ww 16V 4 A 12 V

A: