3. What is the shear strength in terms of effective stress on a plane within a saturated soil mass at a point where the total normal stress is 295 kN/m² and the pore water pressure 120KN/m²? The effective stress parameters of the soil for the appropriate stress range are c'= 12 kN/m² and ɖ'=30° .

3. What is the shear strength in terms of effective stress on a plane within a saturated soil mass at a point where the total normal stress is 295 kN/m² and the pore water pressure 120KN/m²? The effective stress parameters of the soil for the appropriate stress range are c'= 12 kN/m² and ɖ'=30° .

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter9: In Situ Stresses

Section: Chapter Questions

Problem 9.4P

See similar textbooks

Similar questions

In an area where the ground surface is level, the underlying soil has a unit weight of 16 kN/m3. Determine the principal stresses acting at a depth of 5 m if the lateral pressure is one-half the vertical. The vertical pressure (stress) is the product of the soil unit weight and depth, and is the major principal stress.
The total normal stress in a saturated soil mass is 295 kN / m2 , gap water pressure is 120 kN / m2 shear in terms of effective stresses in a plane measured as Calculate its strength. Effective tensile strength parameters for soil c '= 14 kN / m2 and φ'=28 degree.
A layer of saturated clay 4m thick is overlain by sand 5m deep, the water table being 3m below the surface. The saturated unit weights of the clay and sand are 19 and 20 kN/m^3, respectively; above the water table the (dry) unit weight of the sand is 17 kN/m^3 . Determine the effective stress at mid-height of the clay layer in kPa. Round your answer to 2 decimal places.
A 5-m depth of sand overlies a 6-m layer of clay, the water table being at the surface. The saturated unit weight of the sand is 19 kN/m3 and that of the clay is 20 kN/m3. Use the unit weight of water (?!) is 9.81 kN/m3. (a) Determine the total and effective vertical stresses at the centre of the clay layer. (b) The coefficient of lateral earth pressure at rest, ?", of the clay is identified as 0.8. Calculate the total and effective horizontal stresses at the centre of the clay layer.
A 3 m-thick sand layer is underlain by a deep bed of clay where the water content is 29%. The water table is at the bottom of the sand layer. The unit weight of sand is 18 kN/m3, and Gs for clay grains is 2.70. Find the effective vertical stress at a depth 10 m below the ground level.
A soil stratum has two layers a 4m-thick dry sand underlain by a 5m–thick saturated sand. Dry unitweight and saturated unit weight of sand are respectively 16.21 KN/m3 and 20.88 KN/m3. a. What is the total stress at the bottom of the soil stratum?
A granular soil is subjected to a minor principal stress of 200 kN/m2. If the angle of internal friction is 30°.What is the maximum shear stress induced? a.300 b.200 c.224.2 d.173.2
The soil in a dry granular deposit has an angle of internal friction equal to 35°. At a point in the soil mass where the lateral pressure (minor principal stress) is 1,000 psf, what maximum vertical pressure (major principal stress) can be imposed?
A flexible circular area of radius 3.3 m. is uniformly loaded by q = 341 kN/m². Determine the increase in vertical stress, 3.2 m. deep at its center.
Given soil formation and the corresponding properties of soil in each layer. To consolidate the ground, a load is added at the top as shown or dewatering are being considered. (A) With the load only, what is the increase in stress at mid-layer of the bottom soil assuming a trapezoidal stress distribution of 1 horizontal to 2 vertical. (B) With dewatering by 2 m., what is the stress increase at the mid layer at the bottom of soil as water is lowered down? (C) How much must the water level be lowered to be more effective than the load added at the top?
A 30-kN concentrated load is imposed at the surface of a granular soil deposit. Determine the subsurface vertical stress created at depths of 5 m and 10 m directly beneath the loading and at a horizontal distance 5 m from the line of application (5 m and 10 m depths) for:(a) Boussinesq conditions.(b) Westergaard conditions.
A 5 m-thick clay (Gs = 2.65, water content = 0.28) is overlain by a 4.50m-thick layer of sand (Gs = 2.60, e = 0.70, S = 0.85). The ground water table is located 4.50 m from the ground surface. Compute for the following: 1. At what depth would the vertical effective stress be equal to 120 kPa? 2. What is the vertical effective stress at a depth 9 m below the ground surface? 3. The depth of excavation required to reduce the effective stress at the bottom of the clay layer by 100 kPa. Question 1: A. 1.94 Question 1: B. 3.99 Question 1: C. 6.44 Question 1: D. 8.49 Question 2: A. 168.9 Question 2: B. 44.1 Question 2: C. 120.1 Question 2: D. 124.8 Question 3: A. 1.83 Question 3: B. 7.67 Question 3: C. 3.17 Question 3: D. 6.33