Question
3.45
Find current i in the circuit of Fig. 3.91.
ML
492
8 92
4 A
2Ω
6Ω
ts
30 V (+
ΙΩ
Figure 3.91
Expand
Transcribed Image Text

3.45 Find current i in the circuit of Fig. 3.91. ML 492 8 92 4 A 2Ω 6Ω ts 30 V (+ ΙΩ Figure 3.91

Expert Answer

1 Rating

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: The one-line diagram of a three-phase power system is as shown in the figure attached. Impedances ar...

A: The load at bus is S2=15.93 MW-j33.4 MvarFirst converting all the values in per-unit systemThe load ...

Q: 11- Find i (t) in the following circuit. You may employ any method you wish t = 0 22 22 24 V (t)

A: First calculate the current just after the switch is closed.Capacitor behaves as a short circuit jus...

Q: Draw an impedance diagram for the electric power system shown in the figure attached, showing all im...

A: We can obtain the impedance diagram by using below steps: -The base voltage VBG1 on the LV side of T...

Q: KCL Iav 2N 0sv Soue the curcut gnd

A: The circuit diagram is shown on the board:

Q: A short 3-phase transmission line connected to a 33kV, 50 Hz generating station at the sending end i...

A: It is given that:

Q: I am having trouble with a Differential Amplifier problem that I attached a photo of. I must "Design...

A: For a single input single output BJT amplifier for the gain of +150 we have to make some changes in ...

Q: 1012 112 100 V Figure 4.20 System diagram for Problem 4.2a 1 2 10 2 100 V Figure 4.21 System diagram...

A: a) For calculating the pick up current here we have to calculate the line to line current for bus A ...

Q: In the following circuit, use two different methods (Nodal Analysis, Mesh Analysis, or using Theveni...

A: Let us find the Nortons's Current (Isc) :

Q: Hoq do current transformers differ from voltage transformers?

A: Current Transformer is used to measure current while, Voltage transformer is used to measure voltage...

Q: 3.31 Find the node voltages for the circuit in Fig. 3.80. C, ML 1S2 4lo 2v V1 V2 11o 4 92 4Ω 1S2 ÷) ...

A: Nodal analysis primarily depends on the application of Kirchoff\'s Current Law (KCL) to various esse...

Q: When you are converting an instantaneous current to a phasor, how does the phase angle being positiv...

A: The overall solution depends on the phase angle or epoch (initial phase) of the instantaneous form o...

Q: problem 2 question 2

A: The given low pass filter is:

Q: Examiner lecturer: Hawraa Qasim Date: 16/4/2018 unleridtions&Measurements Division: Electrical Engin...

A: (a) Dynamometer:This is type of measurement device that is used to measure voltage, current, and pow...

Q: 2 A 8Ω 4Ω 12 V 6Ω 6Ω HI- Figure 3.46 For Review Questions 3.1 and 3.2. 3.2 In the circuit of Fig. 3....

A: The purely resistive circuit provided in the question can be solved by applying Kirchoff's Voltage L...

Q: The three conductors of a 3-φ line are arranged at the corners of a right angled isosceles triangle....

A: The conductors are at the corners of right-angled isosceles triangle. So, the distance between the c...

Q: For the circuit below, use superposition to find i. Calculate the power delivered to the 3-Ω resisto...

A: According to superposition theorem, the total current across any element due to all the sources is e...

Q: The ABCD constants of a three-phase, 345-kV transmission line are:A = D = 0.98182 + j0.0012447.B = 4...

A: Since, the given ABCD parameters for the 345 kV transmission lines are:A = D = 0.98182 + j0.0012447B...

Q: please help with question 45. thank you

A: The values of Z0, Z1, Z2 and Z3 as a function of A, B, C and D should be obtained by the following s...

Q: Attempt five questions only Q1.) a) Derive the basic S.I units, then write the basic dimensions for ...

A: Hii there!! Since there are two different questions in the image, I will be solving the first one. I...

Q: imu omplete SY%

A: Part (a): Refer to Figure as shown in the part (a) of the given question.According to the Maximum po...

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.39

A: Hi there!! Since there are four parts in the question, I will be answering only the first two parts....

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.19

A: Click to see the answer

Q: une nodal amolipis to Soue the euit omol vo bupe loop ondly sij ho sohe hme ardu and iud Vo S Vo Sl ...

A: This problem will be solved by the application of Kirchoff's Voltage Law and current law. According ...

Q: Find i(t) and v(t) for t >0 in the circuit in the figure attached.

A: Write the general expression for unit step function,

Q: How would I sketch the output waveform and calculate the frequency of a op-amp / signal generator?

A: Operational amplifier is a device which is linear and is capable of ideal DC amplification and is th...

Q: 1 99% 7:50 PM l Verizon LTE Done 12- Find i(t) and v(t) in the following circuit. You may employ any...

A: Figure 1 shows the modified circuit when t < 0.

Q: 5- In the following circuit find io) t-0 2Ω 2 12 o (t)

A: Figure 1 shows the modified circuit when t < 0.

Q: Resistor Color CodeWhat Color Code would a 30Ω ±5% look like?

A: Use color code table to obtain the desired result of your problem: -Let us consider a resistor have ...

Q: Three conductors of a 3-phase overhead line are arranged in a horizontal plane 6 m apart. The diamet...

A: The capacitance of each conductor to neutral per 100 km of the line should be calculated as: -

Q: 10- Find i, (t) in the following circuit. You may employ any method you wish. 12 V(+ за

A: The general expression to find the complete response of voltage for the RC circuit.

Q: what will be the output of the following meters, if the input signal is the waveform show in fig

A: The output reading of each meter should be determined.

Q: Electrical Engineering Question

A: Part (A):Given data,

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.18

A: (a). Numerator part of the gain:b(s) = b1sn-1 + b2sn-2 + …………+ bn…………………… (1)Denominator part of the...

Q: CompressionLet’s take a look at compression.Take the file Fig 05-15 which can be found on the author...

A: 1. Right click on file and go to properties to get  the type of file format.Answer: a) Chapter 5.doc...

Q: The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and ...

A: The conductors of 3 phase line are arranged in horizontal plane.

Q: e lar Cov depemaent Source loiC나 VTR 3 /2 3另

A: Follow below steps to obtain the result: -Apply Kirchhoff’s voltage law in the loop and solve as bel...

Q: At which times will Q be high? clk A) T1, T2, T3, T4 B) T2, T5 C)ll times C) D) T1 , T3, T4 Ti T23T4...

A: 1) JK flip flop truth table is given as:JKQ+00Q(no change)01010111Q’

Q: 2. Assuming ideal diode models, find status of diodes Di and D2 (on or off) D2 + 15V 10% +

A: First, assume both diodes are on,

Q: You are given that the system shown in Figure 4.25 has a 110/220 kV autotransformer. The positive- a...

A: Since there is single line to ground fault in phase a. So, fault current in phase a will be IF and f...

Q: i Gu Pevse use Modol or mesn 10 A 2 Thearen 2Ω 12 10

A: Let us apply supernode at nodes 1 and 2:

Q: The figure attached to this question shows the 1 line diagram of a simple three bus power system wit...

A: Convert the line impedances into admittances, using Y=1/Z 

Q: 1. FIGURE 52 shows the one-line diagram of a simple three-bus power system with generation at bus I....

A: Convert the line impedances into admittances, using Y=1/Z 

Q: please could you help me to find the solution of  question (b)

A: The output of each meter should be determined.

Q: Find the charge q(t) flowing through an device if the current is:(c) i(t)= 20 cos(10t + π/6)10^-6A, ...

A: Charge is defined as integral of current over a certain interval of time. The mathematical expressio...

Q: 8- In the following circuit find i() 2Ω 0

A: From the circuit, write the expression for io(t) as follows:

Q: s) We noded 0holgss to Solve the aitteisb end nd uR loop Umobtis to Solue the wrts ond find

A: a) Nodal Analysis:Let V1 is the node voltage at node. 

Q: 6- In the following circuit find io (t) t-0 3 A i, (t)

A: Figure 1 shows the modified circuit when t < 0.

Q: Nt

A: To find the thevenin resistance or equivalent resistance:Thevenin resistance is determined by open  ...

Q: .il Verizon LTE 7:42 PM 100%- Done 2- In the following circuit find ve) and i(t) given; y(1)-240 V ,...

A: We have been given with below values: -v1(t) = 240V, v2(t) = 120V, L=1H, C = (1/16) F and R=2 Ohm fo...

Q: he follo miny Cu nd R omptete ミ? 2 2. /2 レ

A: Click to see the answer