30 20 T-500 N T-1500 N 12 m

Q: 25.81 kN/m 25 m A. B

A: Given data: l=25 m

Q: 3.17 The 3200-lb weight is supported by two cables. Knowing that the resultant of the cable tensions…

A:

Q: 0.35 m B. 0.4 m 20° -y 15 kg 0.7 m 0.45 m А W

A: Construction methods that involve tensioning are used to reduce the amount of traction load applied…

Q: Q.17.8 apart with one end 5 m above the other (as shown in figure below). The cable is loaded with…

A:

Q: The balloon shown in the figure is being held in place by the hooks placed in B, C, and D. If F =…

A: A0,0,6B-1.5,-2,0C2,-3,0D0,2.5,0Position vectors :rAB=-1.5i-2j-6krAC=2i-3j-6krAD=2.5j-6kForce…

Q: Problem 5 Determine the deflection curve, the length, and the maximum tension in the uniform cable…

A:

Q: The cables in Figure P6.7 have been dimensioned so that a 3-kip tension force develops in each…

A:

Q: If the tension in cable DE is 620 N, determine the moments of this tensile force (as it acts at…

A:

Q: 0.5 m 300 mm 20 mm d5m 1.5 m 300 mm 1 m 20 mm 20 kN 1.

A: Find coordinates and vector of AB: Now find unit vector:

Q: 1.) The cable shown carries a triangularly distributed load. Find the tension of cable at the…

A: Due to symmetry of loading and boundary conditions about Vertical line passing through mid of span…

Q: If the ma= 0.5 kg and må = 1.5 kg, determine the acceleration of ea block and the tension in the…

A:

Q: Q.4) Rod AB is in the x-y plane and supported by two cables as shown. The tension in cable AC is 910…

A:

Q: From the given cable shown. Use the general cable theorem. P is in kips. Let P = 20 24 24° NH D…

A:

Q: A cable weighing 40N per meter of length is suspended from point A and passes over a small…

A:

Q: 6.87 The cable is subjected to a 150-lb horizontal force at B, and an 80-lb vertical force at C.…

A:

Q: In the picture below, the beam AB is held up by cable BC on the right at B and supported by a pin on…

A: Question is base on the system in which a beam AB is held up by cable BC . Load on cable AB ,…

Q: Determine the tensions in cables A, B, C and D of the cable system supporting a weight of 100 N as…

A: Given ;

Q: 6 m -1.5 m 2 m m 2.5 m The balloon shown in the figure is being held in place by the hooks placed in…

A: Given From the diagram, the locations of the points are: In Cartesian vector form A=(0i+0j+6k) m…

Q: Rod AB is secured with a cable at point B and a smooth, up and down movable collar from point A.…

A:

Q: The two blocks started at rest. The surface of the inclined plane is frictionless. (note: neglect…

A:

Q: 4. A cable supports a load of 50 kg/m uniformly distributed along the horizontal and is suspended…

A: from the above diagarm figure        h1=10m , h2=10+10=20 m, l =100mTaking moment about A and B when…

Q: Та Tb 15° 30° Td Tc 60° 75° W

A:

Q: The cables in Figure P6.7 have been dimensioned so that a 3-kip tension force develops in each…

A: Jacking force is the force applied by a hydraulic jacking system for the purpose of installing it.…

Q: Compute the support reactions and the maximum value of w if the allowable tension force in the cable…

A: Given Data: Allowable Tension force in the cable is  The angle made by the cable with horizontal is…

Q: Q1: The cable AB supports three vertical loads as shown in next figure. Compute the resultant of…

A: Given: A cable supporting 3 downward forces. Find: Resultant of these forces and its location w.r.t.…

Q: From the given cable shown. Use the general cable theorem. P is in kips. Let P=20 [Select] [ Select]…

A:

Q: Q.1.1 A cable of uniform cross-sectional area is stretched between two supports 80 m apart with one…

A:

Q: Determine the tensions in cables A, B, C and D of the cable system supporting a weight of 100 N as…

A: Given data  Find force in member A, B, C and D.

Q: A cable spans a horizontal distance L = 18.0 m, supports a uniform load w = 4850 N/m, and has a sag…

A:

Q: Hi there. I have attached a photo of the problem I want to solve. I am familiar with solving similar…

A: The given figure is shown below:

Q: 2.3 The cable stays AB and AD help support pole AC. Knowing that the tension is 120 lb in AB and 40…

A: Schematic diagram of the given problem:

Q: 23 Determine the weight W that can be supported by ne boom if the maximum force that the cable T can…

A: Draw the free body diagram.

Q: A crane boom of mass 450 kg with its center of mass at C is stabilized by two cables AQ and BQ (A, =…

A:

Q: E P Cable 4 m D В C A -2 m -2 m- 3 m

A:

Q: The cable is subjected to a 150-lb horizontal force at B, and an 80-lb vertical force at C.…

A: Show the free body diagram of the cable as in Figure (1).

Q: Consider that the catenary cable in the figure is anchored between supports A and B and is…

A: Consider the free body diagram of the given symmetrical parabolic cable as shown below. d=20 m…

Q: A beam ABCD with a vertical arm CE is supported as a simple beam at A and D (see figure). A cable…

A: This question is related to Strength of Material or Mechanics. In this question we calculate value…

Q: y The tension in cable AB is 150 N. The 5m tension in cable AC is 100 N. Determine the sum of the…

A:

Q: The cable given in the figure is fixed at points A and E with a fixed support and the individual…

A:

Q: Q.3) The L-frame in figure below supports forces from two cables. Cable "EAD" passes through a…

A: Given: Force in cable EAD = 800lb and in OCG = 400lb Required  Moment about point B, A and O.

Q: Given that M = 34 kg, 0 = 35° and ø = 25", determine the tension developed in wires ČA and CB…

A:

Q: A load W is to be lifted using the crane BC which is hinge at B as shown in the figure. Neglecting…

A: To find  Largest weight W?

Q: Note: Rep number by Problem #4: 8 = 10+C (degrees) D В Use The street-lights at A and B are…

A:

Q: 2. Three cables are used to tether a balloon as shown. B 4.20 m 2.40 m y 둬 D 4.20 m Z Fig. P2.101…

A: Hi! Thank you for the question.  As per the honor code, we’ll answer the first question since the…

Q: Q.2) For the figure shown, 4 m what is the moment about 2.4 m A of the force exerted by the cable…

A: Given TBC=2.5kN To find MA=?

Q: Betermine the reactions at the supports, the magnitude of the cable sag at joints B and E, the…

A:

Q: A uniform steel bar of length 10 m is supported at point A and B using two cables as shown in the…

A:

Q: Three tension cables as shown on the figure are acting on a vertical post to remain its position at…

A: Tension: Tension can be defined as the force applied conveyed axial direction by a string, cable,…

Q: Determine the sag at points C and E on the cable in the figure below (Sag at point D is given), and…

A: GIVEN- L=160ft

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.