Choose the correct answer.*Please answer it ASAP if you can* 31 Calculate the the Output Voltage of a non-invertingop-amp with the following parameters Rf =360kOhms, Vo = -9.3V, and Vi=-0.3V.a. 32 kOhmsO b. 31.2 kOhmsO c. 31 kOhmsO d. 12 kOhms

In this question we will find input resistance of opamp...

Answered: 31 Calculate the the Output Voltage of…

31 Calculate the the Output Voltage of a non-inv op-amp with the following parameters Rf = 360kOhms, Vo = -9.3V, and Vi=-0.3V. a. 32 kOhms O b. 31.2 kOhms O c. 31 kOhms O d. 12 kOhms

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.3P

See similar textbooks

Related questions

Q: find the resistance of one lamp If three identical lamps are connected in parallel and the combined…

Q: Find V4 by using Superposition theorem R₁ w R₁ 3011 En 12 ㅎ R: +1 1241 18 가 E

Q: 16, determine the For the spring assemblages shown in Figures S nodal displacements, the forces in…

A: The given spring assemblage is shown below:

Q: The solenoid as shown in the figure below has 200 turns, the current is (10A), length of 4 cm and…

A: Given Data, Number of turns(N)=200 Current (I) =10A Length (l)=4cm or 4×10-2m Radius (a)=1.2cm or…

Q: 3. For the circuit in Figure 3, find the mathematical expressions for ic (t) and vc (t) in the…

A: Transient analysis:

Q: In an RC coupled clamping circuit, the relationship of the circuit discharge time constant and the…

A: In the above given question they are discussing about an RC coupled clamper circuit. By using the…

Q: Q3) Find the power dissipated in the resistance 100 shown in fig.3, using Thevenin's theorem. www 60…

A: In this question, We need to determine the power across the 10 ohm resistance using the Thevenin…

Q: -Q5/What the value of Rr.Fr, are required in the circuit below. 47 kOhm 0 022 uf HH 0.022 uf 47 kOhm…

Q: Using a vector model, sketch and show the effect of the following RF pulses on the thermal…

A: RF pulse means the radio frequency pulse it is technique the RF oscillation is gated at rate of…

Q: Consider the circuit of Figure 21-6: RG = 50 + 16 sin wt 0.044 μF FIGURE 21-6 a. Find the resonant…

Q: SECTION 13.2 Sinusoidal ac Voltage Characteristics and Definitions 1. For the periodic waveform of…

A: The given waveform is a periodic waveform and the required parameters can be calculated based on the…

Q: Explain the concept of 1x1 convolutions and how it can be used?

A: An 1×1 filter in a convolution layer can be used at any point of the network in order to control the…

Q: A real transformer with 100 turns in the primary winding and 800 turns in the secondary winding has…

Q: A circuit is used to clip a portion of its input waveform. The output waveform a. can not be used…

A: A circuit is used to clip a portion of its input waveform. The output waveform

Q: H.W: Find the Laplace Transform of the following: 1) L(2+e³t+ cos2t + sin 6t) 2) L(e-²t cos3t) 3)…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Simplify the following functions, and implement them using NAND and NOR gates only: F(A, B, C, D) =…

A: The given Boolean expression can be reduced by using the Boolean algebra laws and the same can be…

Q: A will light two different colors, such as red or green, depending on the direction of the current…

A: .........will light two different colors, such as red or green, depending on the direction of the…

Q: 3. For the circuit shown, determine the circuit impedance, all the currents, voltage drops and…

A: As per the guidelines given to us we can only provide the solution of first three subpart in multi…

Q: signal processing 1.what are the singularity problem of CMA algorithm 2. Why such singularity…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 1. Explain the difference between digital and analogue electronics devices, and then Explain the…

A: Digital devices:- In digital devices signals are discrete in time and values. Signals are…

Q: The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 25 feet. The per…

A: Given data : distance D=25 feet

Q: W W R₁ R₂ E If E=49 V, R1= 15 Ohms, and R2= 70 Ohms, find the total current in Amperes.

A: Given, The circuit is E=49 VR1=15 ΩR2=70 Ω

Q: Neamen - Problem 7.8 (Note: parts (a) and (b) appeared on a previous homework Consider a GaAs…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Q3: A 2 MVA three-phase, 33/6.6 kV, delta/star transformer has a primary resistance of per phase and…

A: Given data, The value of primary resistance = 8Ω The value of secondary resistance =…

Q: The three phase power and line-line ratings of the below electric power system is given below Vm…

Q: 7.a. Weight and humidity are examples of A. discrete outputs. B. discrete inputs. C. voltage…

A: Weight and humidity are examples of What statement best describes the CPU scan?

Q: Determine the impedance ZL for maximum average power transfer and the value of the maximum average…

Q: - 4.5 The work done by the force F = 4a − 3a, + 2a. N in giving a 1 nC charge a displace ment of…

A: Given data, Force F=4ax-3ay+2az N Charge q=1 nC Displacement dl=10ax+2ay-7az

Q: = 12.) (Neamen: Problem 7.22) - Consider a GaAs pn junction at T 300K. The junction capacitance at…

Q: Subject name: Signal processing measurement Question: Is there any difference between the metallic…

A: Resistance is the property of opposition to the flow of current and is the important property of…

Q: Find the value of resistance so the circuit behave as a difference amplifier with input resistance…

A: Differential amplifier is the difference between the two voltage and make the operational amplifier…

Q: Compute the current i(t) at the steady-state for Ao = 6, A, e(t) = 10 cos(3t), V, R= 10,ohm,, C=F/3…

Q: Using the values of the magnitudes given in the image, the injection efficiency of electrons is D₁…

A: Electron injection process is used for injecting transfer of electron from a excited state to an…

Q: Using Mesh Analysis. ΤΩ 2 cos 10: V Μ 1 F ΤΗ 19

Q: SECTION 13.2 Sinusoidal ac Voltage Characteristics and Definitions 1. For the periodic waveform of…

Q: Description Measured Computed E, Audio Generator Output voltage 10Vpp 10 Vpp E Voltage across…

A: While designing an electrical circuits, less tolerance electrical components should be preferred…

Q: 492 wwww and 1=0 Q1 of 2) The switch has been closed for a long time. It opens at t=0. i) Find i…

Q: Q3) An audio signal given by 20sin27(2000t) amplitude modulates sinusoidal carrier wave 80sin2m…

Q: Please provide Handwritten answer. Electrical Engineering Two half-wave dipole antennas operating…

A: Given,Operating frequency, f=100 MHzDistance, R=25 kmTransmitted power, PT = 100 W

Q: Given the nMOS inverter circuit as shown below: 3.3 V M1 2 V V₂ M2 The W/L ratio for M₁ is twice…

A: MOSFET: It is a transistor that has the highest switching frequency. Due to the highest switching,…

Q: For the circuit below, find I1, Iz and Vo using Nodal Analysis 330Ω V, -j450 Ω Τ j200 Ω 100 Ω 36/0°…

A: The following steps are to be followed while solving any electrical circuit using nodal analysis:…

Q: A Three-phase transposed line is composed of one conductor per phase with flat horizontal spacing of…

Q: Use a A-to-Y transformation to find the voltages and v2 in the circuit in Fig. P3.58. με αποτ Figure…

Q: Two electric bulbs rated at watt, V volt and watt. V volt are connected in series across V volt. The…

A: The total power consumption by the series combination of bulbs can be calculated by using ohms law

Q: A 24kVA, 6000/200 V transformer during the short circuit test the following result is obtained in…

A: This question belongs to electrical machine . It is based on the concept of voltage regulation in…

Q: 2-d) Draw a complete small signal circuit model, then find the voltage gain. Explain two…

Q: 4 V (V) 25-- 0 (a) f = 60 Hz WI 31. Write the analytical expression for the waveforms of Fig. 13.87…

Q: Instruction: Show complete solution. Use at least two decimal places. Express your answer in…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Industrial Motor Controls 18.a. The PLC motor speed control system you are working on has an analog…

A: A Programmable Logic Controller is abbreviated as PLC. These are used for programmable variety of…

Q: 31 157 2.2 (1) 35.52 (t) = ?

A: Operational amplifier High CMRR High input impedence Low input impedence Input bias current…

Question

100%

Choose the correct answer.

*Please answer it ASAP if you can*

31 Calculate the the Output Voltage of a non-inverting
op-amp with the following parameters Rf =
360kOhms, Vo = -9.3V, and Vi=-0.3V.
a. 32 kOhms
O b. 31.2 kOhms
O c. 31 kOhms
O d. 12 kOhms

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q2: (A): What is the advantages and disadvantages of RC coupled amplifier?
Table Q2 shows the datasheet comprising the parameters of a practicalop-amp. Please answer the following questions with reference to the data inTable Q2. Determine the full-power bandwidth for a 10-V output. Using the typical values from Table Q2, find the magnitude of thecommon-mode gain, Acm.
For an operational amplifier, the differential gain and the common mode gain are 105 and 10 respectively. What will be value of the CMRR of the opamp?
please need correct answer fast Q1) For an Operational amplifier if CMRR = 130dB and Open loop differential gain Aol = 150000, the value of Common mode gain ACM will be __?
The amplifier configuration shown in figure below is a a) common emitter b) common collector c) common base d) base follower configuration, where the is at ac ground, and the ac output voltage a) collector B) emitter C) capacitor D) base with the input. A) amplified and 180deg out of phase B) almost equal and 180degree out of phase C) almost equal and in phase D) amplified and in phase
Q.4/ Refer to the class AB power amplifier shown below:a. Determine the dc parameters VB(Q1), VB(Q2), ICQ, VCEQ(Q1), VCEQ(Q2).b. For the 5Vrms input, determine the power delivered to the load resistor.c. Determine the approximate input resistance seen by the signal source if ac=100
Tell the ideal char. of op-amp.
Given a inverting op-amp with Vin= 1Vpk,1kHz and Rin=1kΩ , Rf=10kΩ, VEE=-5V, VCC= 5V, Explain the output waveform, voltage gain, and it's phase.
What must the voltage at the inverting input of the op-amp be? What is the voltage drop across Rin? What is the input current, iin, through Rin? What is the output voltage vout?
(a) How much is the dc operating drain current? ID = _____ mA (b) Determine the magnitude of voltage gain of amplifier |AV| = ___ V/V
The resistors in the difference ampliﬁer shown are slightly mismatched due to their tolerances. (a) What are the differential-mode and common-mode input voltages if v1 = 3 V and v2 =3V? (b) What is the output voltage? (c) What would be the output voltage if the resistor pairs were matched? (d) What is the CMRR?
Given a inverting op-amp with Vin= 1Vpk,1kHz and Rin=1kΩ , Rf=2kΩ, VEE=-5V, VCC= 5V, Explain the output waveform, voltage gain, and it's phase of the circuit.