380 <0° V 380 /120° V a n a 380 /-120° V I 1Ω B 2 Ω m Μ A ·J2Ω C

Q: Simplify the following using K-map: a) Y = W'XYZ + WX'YZ + WYZ+X'YZ

A: In this question we use k map to simplify the given Boolean expression

Q: Q2: The op amp in the circuit shown in Fig. 2 is ideal. a) Calculate va when vg equals 4 V. b)…

A: Question 2: For the given op-amp circuit in fig,(2) calculation of following : calculate the va…

Q: The fuel costs of two power plants are: f₁ = -0,8 p² +10P, +25 Rs./h 2 1₂=0₂27P2² +6P₂ + 20 Rs./h It…

A: Different type of power plant are depending on fuel used for generation of bulk power thermal and…

Q: V(t) sine R1 25 0

A:

Q: Problem # 2 A solenoid that is 100.0 cm long has a cross-sectional area of 10.0 cm². There are 500…

A: Given: A solenoid with Length, L=100.0 cm Cross sectional area, A=10.0 cm2 Turns, N=500 Current,…

Q: A solenoid of length 8 cm has 130 turns of radius 5 cm. a) Ignoring end effects, what is its…

A: Given, A solenoid has L=8 cmN=130 turnsr=5 cm

Q: Example 2.5 Obtain state model by direct decomposition method of a system whose transfer function is…

A:

Q: Determine the approximate value of lp of Figure 56. 18 V Ip • 750 ΚΩ '91 ΚΩ Vas 2 ΚΩ OV 9V Pos loss…

A: Given circuit is shown below. We know that ID=IDSS1-VGSVP2

Q: digital signal prossesing

A: The solution is provided in the following section.

Q: Electrical Engineering assume a switch connects 24 stations. assume each link operates a rate of 20…

A: Given: A switch connects 24 stations. Each link operates at a rate of 20 Mbps except for one station…

Q: An amplifier operating over the frequency range of 455 to 460 kHz has a 220-kΩ input resistor. What…

A: In this question we will find noise voltage at the input of amplifier......

Q: A 400V, 50Hz generator supplies two parallel connected loads A and B. Load A draws an active power…

A:

Q: Q1/ The following information is given for a 250-kW, 500-V, long-shunt compound generator : Shunt…

A: The terminal voltage of the generator is 500 V The power produced is 250 kW The armature resistance…

Q: a) Calculate the line currents, the power consumed (consider the internal resistance of the coil)…

A: As per Bartleby policy we can answer only one question at a time. Please repost it for other…

Q: In a certain region of space, the electric field has a value of 5.4928 ap-2.5582a0 +4.2134az V/m.…

A:

Q: Combining the equation for the convection current density and the equation relating the drift…

A: Brief description: For the given statements we need to define the correct option with reference to…

Q: A 3 phase,50Hz ,8 pole induction motor has a full load slip of 4%. The rotor resistance is…

A: The ratio of the maximum torque to full load torque is given by the expression as shown below:…

Q: how many hours do i need to charge my 2 batteries that is in parallel connection in a solar panel?…

A: Solar modules convert Solar radiation energy into electrical  It generates DC voltage across the…

Q: Three Impedances each of (8 - j18) are connected in mesh across a three-phase 410V ac supply.…

A: In this question we need to find a line current , phase current , real power and reactive power of…

Q: reactance Rp = 3-ohm Xp = 15-ohm Rs = 0.03-ohm Xs = 0.15-ohm Find the primary voltage required to…

A: Solution- Ans- Equivalent circuit of 1- phase transformer referred to primary,…

Q: Q2] The efficiency of a 6600/384V, 200kVA, 1-phase transformer is 97.5% at full load 0.8 power…

A:

Q: Q4-Chose the correct form of the verb (only 6) 1-1 (go /am going) to play football now. Goodbye 2-1…

A: Given  Few multiple choice questions.

Q: What is the total current supplied by the voltage source in the circuit below? 202 402 M m 12 V (+…

A:

Q: Using Norton's Theorem, solve for current I1 in the given circuit below

A: The circuit given in the question is as shown below,

Q: 3. Find Nortons equivalent circuit for the circuit shown below FA 10 V ww 100 1.00 8V 80 8V Hilk 8 Ω…

A:

Q: A coil having a resistance of 5ohms and an inductance of 0.02H is arranged in parallel with another…

A: Current: It is the time rate of the change of the charges. It flows from high voltage to low voltage…

Q: The reverse gate voltage of JFET when changes from 4.4V to 4.2V, the drain current  changes from 2.2…

A:

Q: - previous 4- If V1 = 400V and the wattmeter read 800W at no load test then the value of Ro is…

A: given V1 = 400 V and wattmeter read is 800 W at no load test.here we have to find the value of R0.

Q: Design a two bit synchronous counter that count the sequence 0,1,2 using T flip flop

A:

Q: Find the Inverse Laplace of the following

A: This question comes under signal and system . It is based on the concept of inverse laplace…

Q: e nearest integer.

A: Current: I=dqdt Heat: H = I2Rt

Q: 1. A transformer takes 10 A on no-load at a power factor of 0.1. The turn ratio is 4 : 1 (step…

A: A transformer takes 10 A on no-load at a power factor of 0.1, turn ration N1:N2=4:1 (step down). If…

Q: 2 A sinusoidal Source supplies 35 kvar reactive power to the load 2= 300-500 Determine @ Power…

A:

Q: Develop the following problems in a clear and orderly way. Use 4 decimal places for magnitudes, real…

A: In delta connection line voltage is equal to phase voltage and line current is 3 times the phase…

Q: 01:- electrical heater (500w) (250V) calculate the current will draw by the heater and its…

A: By using the below formulas we can do the given sum. P = VI and  P = IxIxR  Where I = current…

Q: R1 1k m ww GND .dc V1 0 10 0.01 .probe I(R1) probe I(R2) .probe I(R3) Wiring Tools % 7==\ vcc +5V X…

A:

Q: TRUE OR FALSE Ultimate tensile strength has the same value to yield strength in brittle materials.…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Find the overall impulse response of the system below, where hy(t) = 2u(t-3). h₂(t)=3eu(-t). hs(t) =…

A: given here system and asked to find the impulse response of overall system.     we know that…

Q: Q2: For the ideal op-amp shown in figure (2). Find: 1. The voltage gain A, = V₂/V₁? 2. The input…

A:

Q: Please solve the current I1 in the given circuit using Thevenin's Theorem

A: The given circuit is as shown below,

Q: A solenoid of length 8 cm has 130 turns of radius 5 cm. a) Ignoring end effects, what is its…

A: Given  A solenoid of length 8 cm and 130 turns and 5 cm radius. We need to determine the self…

Q: Q10 A 240 v, 4-pole shunt motor running at 1000 r.p.m. gives 15 h.p. with an armature current of 50…

A:

Q: As a numerical example illustrating the use of (9), we determine H at P₂(0.4, 0.3, 0) in the field…

A:

Q: (Note that VO=V01+V02, where Vo1 is due to V1 and Vo2 is due to 11) V02 (in volt) due to 11 only= O…

A:

Q: R₁ L₂ R₂ + с 100- Figure 3 L₁ Vo

A:

Q: 3. A 120-KVA, 6,000/400-V, Y/Y 3-ph, 50-Hz transformer has an iron loss of 1,600 W. The maximum…

A: In this question we need to find a efficiency of transformer at given loading conditions.

Q: 4- Determine the nodal voltages for the networks of Fig. 202 www .3 2 = 4A80°3 6Ω; 8 Ω I₁ = 0.6A /…

A:

Q: 2. Find Vo using Superposition ww 192 6/0°v (+ 46 -ΠΩ ΠΩ 202 2/0° A

A: Given here a electrical circuit and asked to determine the value of V0 in the circuit using…

Q: 3) Find Io in the circuit below 4 ΚΩ 2 mA 6 mA 2 ΚΩ Io 12V Ε Σ4 ΚΩ

A: In this question we need to find a current Io of the given circuit.

Q: Design a 16x1 Mux. Using 4x1 Mux? Design a 16x1 Mux. Using 2x1 Mux?

A: Multiplexer : A multiplexer is a circuit used to pick out and path anybody of the several enter…

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).