4) A tank contains 20 kg of salt dissolved in 5,000 liters of water. Brine that contains 0.03 kg of salt per liter of water enters the tank at a rate of 25 liters per minute. The solution is kept thoroughly mixed and drains from the tank at the same rate. How much salt stays in the tank after half an hour?

4) A tank contains 20 kg of salt dissolved in 5,000 liters of water. Brine that contains 0.03 kg of salt per liter of water enters the tank at a rate of 25 liters per minute. The solution is kept thoroughly mixed and drains from the tank at the same rate. How much salt stays in the tank after half an hour?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A tank contains 1,500 L of water and 20 kg of dissolved salt. Fresh water is enteringthe tank at 15 L/min (the solution stays perfectly mixed), and the solution drains at a rateof 10 L/min. How much salt is in the tank at t minutes and at 10 minutes?
A tank contains 1,500 L of water and 2020 kg of dissolved salt. Fresh water is entering the tank at 15 L/min (the solution stays perfectly mixed), and the solution drains at a rate of 10 L/min. How much salt is in the tank at 10 minutes?
A container contains 200 g of solution in which 30 grams of salt are dissolved. Brine containing 1 g of salt/L is then poured into the tank at the rate of 4L / m * i * n and the solution is mixed well and is pumped out of the same rateFind the amount of salt in the container after 5 minutes ?
A Brine containing 2 lb of salt per gallon runs into a tank at 2 gal/min, brine from this first tank runs into a second tank at 3 gal/min and brine runs out of the second tank at 3 gal/min. Initially, the first tank conditions 10 gal of brine with 30 lb of salt in solution and the second tank 10 gal of fresh water. Assuming uniform consideration in each tank, find the quantity of salt in the second tank at the end of 5 min.
50 lb. of salt is dissolved in a large tank holding 200 gallons of water. A solution is in at a rate of 2.5 gallons/minute and pump out a 2 gallons/minute. The concentration of the solution entering is a 2 gallons/minute. How much salt in the tank at time t?
A well stirred tank with a capacity of 500 gal originally contains 200 gal of water with 100lbs of salt in solution. Brine containing 1lb of salt per gallon is pumped into the tank at a rate of 3 gal/min, while fluid is allowed to flow out of the tank at a rate of 2 gal/min. What is the salt concentration at the instant that the tank overflows? What about ten minutes later?
A tank contains 100 L of water. A salt solution containing 2 kg of salt per liter flow in at the rate of 3 liters per minute and the well stirred mixture flows out at the same rate. When will the tank have 100 kg of salt? Show solution. Answer : 23.1 mins
2. A river with 400 ppm of salts (a conservative substance) and an upstream flow of 25.0 m3/s receives an agricultural discharge of 5.0 m3/s carrying 2,000 mg/L of salts (see Figure below). The salts quickly become uniformly distributed in the river. A municipality just downstream withdraws water and mixes it with enough pure water (no salt) from another source to deliver water having no more than 500 ppm salts to its customers. What should be the mixture ratio F of pure water to river water?
how much salt (NaCl) is carried by a river flowing at 25.0 m3/s and containing 40.0 mg/L? Give answer in kg/day
A tank contains 1000L of brine with 15kg of dissolved salt. Pure water enters the tank at a rate of 16L/min. The solution is kept thoroughly mixed and drains from the tank at the same rate. How much salt is in the tank after 20 minutes?
The partial pressure for CO2 at the earth’s surface is 10^−3.4 atm. 1) Determine the partial pressure of CO2 in the groundwater aquifer if the dissolved CO2 is known to be 10 parts per thousand and pressure is 1atm 2) Calculate the ratio between the surface and the ground water please explain and solve
An urban sludge basin has a volume of 500 m3. The basin is initially 64% full. The sludge with a density of 1320 kg/m3 is taken away from the basin at a rate of 4 ton/day. How long will the basin take to be fully emptied? Assume the basin is now initially full and re-estimate the time to empty it completely