4- The input to the circuit shown below is the voltage of the voltage source. Theoutput is the inductor current. Represent the circuit by a second-orderdifferential equation that shows how the output of this circuit is related tothe input for t > 0.t = 0UsR₁wwwR2↓i(t)+v (t)

Given Data:An RLC transient circuit with,DC voltage source Output inductor current Node voltage To…

Answered: 4- The input to the circuit shown below…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

solve for the dc quantities, VB(Q1), and VB(Q2)
For the circuit in Figure 3 the switch is in the left position for several minutes: (a) Find the Initlal voltage, V, on the capacitor just before the switch is flipped (b) Find an expression v(t) that describes the voltage across the 20 N resistor after the switch has been Figure 3 U 09 flipped to the right NOTE: Remember what we said in class: use a Circuit-Specific Equation to get a value you know. Then solve for whatever else the problem asks for +50 µF 380 0 20 2
In the circuit below, (Capacitor voltage Vc(t), inductor current IL(t)) and output quantities (I1(t) and I2(t)) Equations of state for in the following format get it.
my question is for the correct follow up answer and not explanation and NOT THE ORIGINAL ANSWER. first of all why is vab(0-)=2ix shouldn't it be 3ix? where did the relation vc(0-)=vc(0+)=vab(0-)-3ix come from? can you elaborate on that? and when t=0 can we always consider a voltage source of 1v? or is it case specific can you explain that? and in t infinity where did u get the equation vc(t)= vc(inf) + vc(0).... from? i dont understand how we reached that relation? same thing for ic(t) and once again how is vAB(t)= vc(t)+3ix? please answer each question individually as i really need to understand the problem and needless to say i will give a thumbs up if answer is good. PLEASE ANSWER PROPERLY AND BASED ON THE GIVEN SOLUTION IN THE FOLLOW UP.
circuit theory I want the answer before 30 minutes, please. I want the answer as soon as possible, because I do not have time, and if I skip the specified time, I do not benefit from the answer.
Electrical Engineering The response of a standard second order under damped system to a unit-step input is shown in the figure. What will be the value of tm in seconds? Response time 2.42 3.63
Describe and solve the following differential equation: y"-4y' + 3y = x²-2x+1
The differential equation x2y "-y "sinx+ (y)²+y (Inx)=e* is not linear because A because of the term (y) ² (B) because of the term y Inx because of the term -y" sinx because of the term x²y
Learning Goal: To analyze an RC circuit to determine the initial voltage across a capacitor, then to find the step response of the capacitor voltage, and finally to find other circuit quantities, such as current, voltage, power, or energy. The step response of an RC circuit is the response of the capacitor voltage to a sudden application of a DC source. When the switching occurs, the capacitor stores or releases energy. (Figure 1) Figure R₁ R₂ www R3 b R4 ,t=0 1 of 1 R6 R5 ww Part D Write an expression for the capacitor voltage, v(t), for t > 0. Express your answer as an algebraic expression in terms of Vs, Is, R3, R5, R6, C. ► View Available Hint(s) v(t) = Submit Part E p(t) = ΑΣΦ Submit vec Write an expression for the power dissipated in the resistor R6 for t > 0+. Express your answer as an algebraic expression in terms of VS, Is, R3, R5, R6, and C. ► View Available Hint(s) V ΑΣΦ ? ↓↑ vec V ? mW
4) For the circuit in figure a) What is the relation between Icharging and q? b) Write down Kirchoff's potential law clockwise around the circuit in terms of the variables q and dq/dt. c) Seperate the differential equation so that it is ready to integrate. Do not integrate. Switch S. Vs 5) For the circuit in figure a) Write down Kirchoff's current law at the point e. b) Write down Kirchoff's potential law around the loop abcdea. c) Write down Kirchoff's potential law around the loop abcdefgha. Do not solve the equations 4=18 V 0.50 250 S. S150 050
Draw the combination circuit for the given expression below. A’(B+(C’D)’) + (A’(C’ + D))’
Task 2 The electric circuit in the figure below contains a current source driving a series inductive and resistive load with a shunt capacitor across the load. The circuit is representative of motor drive systems and induction heating systems used in manufacturing processes. Excessive peak currents during transients in the input could damage the inductor. Therefore, the equation below is used to compute response of the current through the inductor to a step in the input current to ensure that the manufacturers stated maximum current is not exceeded during start up as per the underdamped system. i(t) = = e 0.599 t (t) Load [0.678 sin (1.3227 t) + cos (1.3227 t)] (1) 2-A) Use Excel to plot i, vs t per equation (1). The range of t should be from 0 to 13 seconds. The range of it is to be chosen adequately by you. Make sure to label all axes, add grid lines, and title your graph. Note that the arguments of trigonometric functions are all in radian. 2-B) Use your plot in part (2-A) to…

SEE MORE QUESTIONS

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS

4- The input to the circuit shown below is the voltage of the voltage source. The output is the inductor current. Represent the circuit by a second-order differential equation that shows how the output of this circuit is related to the input for t > 0. + t = 0 t Us R₁ R2 i(t) + v (t)