4. A batch of concrete consisted of 200 lbs fine aggregate (sand), 400 lbs coarse aggregate (gravel), 95 lbs cement, and 5 gallons of water. The relative density of the sand and gravel may be taken as 0.65 and that the cement as 3.10 What was the total volume of concrete produced?

4. A batch of concrete consisted of 200 lbs fine aggregate (sand), 400 lbs coarse aggregate (gravel), 95 lbs cement, and 5 gallons of water. The relative density of the sand and gravel may be taken as 0.65 and that the cement as 3.10 What was the total volume of concrete produced?

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.72P: 1.72 An ice chest (see sketch) is to constructed from styrofoam . If the wall of the chest is 5-cm...

See similar textbooks

Related questions

Q: Market demand for springs is 8,00,000 per annum. A company purchases these spring in lots and sells…

A: Given:Demand, D=800000 per annum,Order cost, Co=1200 per order,Holding cost, Ch=120 per stored piece…

Q: What container has the greatest pressure at the point indicated? Which point experiences the least…

A: 1 => D -) It's having a greatest pressure. 2 => Actually values not mentioned in given…

Q: A stone is thrown upwards with initial velocity of (20 m s),

Q: 7. For ethanol, a handbook gives: sp. gr. 60°F = density of ethanol at 60°F? 0.79389. What is the 8.…

Q: Question 4 The following table lists molecular weight data for a polytetrafluoroethylene material.…

Q: 0.0856-m3 drum contains saturated water and saturated vapor at 360C. (a) Find the mass of each if…

A: Given: V=0.0856 m3 T=360 C The alphabets with subscripts f indicates saturated water. The alphabets…

Q: You are the Production Planner of XYZ Food Group Company, your item is Cocoa Powder and the…

A: Given: Forcasted value by the production supervisor: →F=200000 lbs Because→1 lbs=0.453 Kilogram…

Q: If the water is at 160 C, calculate the height of a column of water equal to atmospheric pressure of…

A: Given data: P=0.981 bar Need to determine the height of a water column.

Q: -4°C ice weighing 300 g was placed on a glass that has a diameter of 6 cm. Determine the depth of…

A: Calculated depth of melted ice.

Q: The temperature of a block of aluminum increases by 10.0 K. What is this temperature increase in °…

A: Let the initial temperature of the block be T1 and the final temperature of the block be T2.

Q: Question 1 Johnny has recently purchased 110 acres of land in New Zealand. He has decided to grow…

Q: 1.5 A reservoir exists at a temperature of 25 C suitable for storing gas. It has an areal size of…

A: Given: Temperature of the reservoir→T=25°C=298.15 K Area of the reservoir→A=2.5 km2=2.5×106 m2…

Q: Transported soils a

A: 1. TRUE ( Because they are transported naturally ) 2. TRUE ( slit particles said to be particular…

Q: It is desire

Q: A concrete block is attached to the gate as shown. If the water level is 1.3 m from the bottom of…

Q: 5. Marianne stacks crates. Each crate has a volume of 1 m³. Marianne makes 4 layers, with 12 crates…

A: Given:Volume of each crate, V=1 m3total layer=4number of crate in each layer=12

Q: 5 (A) In a container there is 100°c water and vapour. If you apply more heat to the container in…

A: Dear student, we are suppose to solve only one question. Please post other question as a separate…

Q: Problem 3: Work, Energy, Power, and Energy Conservation. When TWICE went to Switzerland, Sana…

A: A) Dahyun and Sana's (mass of 48 kg and 49 kg respectively) gravitational potential energy at that…

Q: According to the four components that are involved in the design, production, and utilization of…

A: Material Science Material Science is the branch which studies the properties of materials &…

Q: If you know that the effect of the effect of reaction reaction to the year in shape is located along…

Q: These are the work elements and you are supposed to Prepare flow process chart for regular work…

Q: What is the weight in dynes of 12 oz of salt? Local g is 9.55 mps?.

Q: with Diameter of 3 in Cove a and Length of 7 in, with wet weight lbf of 3.44 and porosity of 0.172.…

Q: n automobile accessory designer, you must choose between two materials for building bulletproof…

A: It is the best safety measure that one can take to protect vehicles, houses, or any other property.…

Q: A casting made of cast iron weighs 4.7 kg. The riser and gating system add another 2.5 kg to the…

Q: 01/Water poured into a conical tank through a faucet, this tank has a base radius of 5 ft and 10 ft…

A: Rate of change of volume in the given conical tank can be given as, Given data: The radius of…

Q: A 150 Ibm human total footprint is 0.7 square feet when the person is wearing boots. If snow can…

A: Given, Mass (m) = 150 lbm Total foot print Area = 0.7 ft2 = Pressure of snow = 2 psi = 288 lbf/ft2…

Q: 1. Take some water with a straw and put a few drops on plastic sheet. (a) What is the shape of the…

A: Question (1) is Solved here. For Other question, please Post again.

Q: . Sand is a cohesion soil

A: we have to decide of sand is a cohesive soil or not

Q: The ___________ material is used for making molding box in sand casting process. a. Paper b. Sand c.…

A: Given The ___________ material is used for making molding box in sand casting process. a.Paper…

Q: A prismatic object 8 inches thick by 8 inches wide by 16 inches long is weighed in water at a depth…

Q: 1. A full gas cylinder contains nitrogen gas at 70°F and the maximum allowed pressure [2640 lb/in.²…

A: Given:T1=70°F =294.26 KP1=2640 psi =18202 kPaT2=210°F =372.04 K

Q: 1- A mold with dimensions of 3 cm x 15 cm x 8 cm is intended in a sand plumbing through an estuary…

A: GIVEN: Dimension of mold = 30cm×15cm×8cm. length of estuary= 8cm Area of gate or entrance = 3cm2…

Q: Modulus of rigidity may be defined as the ratio of

A: Modulus of rigidity is defined as the ratio of shear stress upon shear strain . Modulus of…

Q: 4. A water bug is suspended on the surface of a pond by surface tension (water does not wet the…

A: Introduction: Surface tension: Surface tension refers to the propensity of liquid surfaces to…

Q: 1- If you just put a wooden block in water, it will float. Why do you think it floats on water? 2-…

A: When we put a bit of strong wood in water, the wood floats on the surface. The density of most…

Q: On a square plank 10cm thick and weighing 10kg, a 50-kg man stands. What is the smallest possible…

A: According to Archimedes' principle, when an object is fully or partially submerged in fluid, its…

Q: You and two friends find yourself craving a fresh pizza while preparing for the final exam on the…

A: Given data Pizza 1 has the following propertiesCost = $15 + 5% taxDelivery = $1.5Pizza 2 has the…

Q: 2.. How does a straw work to allow a person to drink a liquid ?

A: As per Bartleby policy multiple questions asked then only first question we need to solve hope you…

Q: Required information A block of wood is compressed 2.00 nm when inward forces of magnitude 139 N are…

A: As per given Force =139N Compression in block =2.nm We have to determine Length compression

Q: Calculation: 1. Total percentage of moisture in an oven dry basis: Wet Wt – Dry Wt % Moisture Oven…

Q: 15. Compute the change in temperature if 3000 Joules of heat are added to a 10-kg sample of dry air…

A: Given data Heat added to the system (Q) = 3000 J mass of sample (m) = 10 kg Cv for dry air = 0.718…

Q: A Midwest Cooperative needs to store 15 750 gallons of a liquid chemical. They are considering two…

A: Volume of stored liquid chemical = 15750 gallons

Q: Give the parameters considered in test the treated water, that must meet the limit set by law before…

A: Drinking water, industrial water supply, irrigation, river flow maintenance, water enjoyment, and…

Q: Kinetil energy ?

A: Given; Thickness=30 mmradius,r=300mmmass,m=30kgN=750 rpmKinetic energy ?

Q: 600 g of iron are at a temperature of 20°C. What will its final temperature be if it is supplied…

Q: The mechanism of powder comminution employed external mechanical forces to Select one: O a. decrease…

A: Comminution is the process of reducing the average particle size of a solid material into smaller…

Q: Based on his experience, the first author of this book has also developed a diet called the…

A: Two simple rules for the sensible diet are Rule1 Get as much of nutrients from the different variety…

Question

Need Now plsss ASAP

4. A batch of concrete consisted of 200 lbs fine aggregate (sand), 400 lbs coarse aggregate
(gravel), 95 lbs cement, and 5 gallons of water. The relative density of the sand and
gravel may be taken as 0.65 and that the cement as 3.10 What was the total volume of
concrete produced?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

complete solution Two hundred (200) bags of freshly harvested palay with 23%MC was dried and became 192 bags. Determine the moisture content after drying
1-Select a suitable material for Kitchen Vessels
A Midwest Cooperative needs to store 15 750 gallons of a liquid chemical. They are considering two possible containers, a hollow cylinder or a hollow sphere. The wall of the sphere will need to be 6 in. thick and the wall, top and bottom of the cylinder are each 6 in. thick. Due to space limitations the height of the cylinder must be 26.0 ft. (a)What will be the outside diameter of the cylinder required to hold the liquid chemical? (b)What will be the outside diameter of the sphere? (c)Assume the containers are made of aluminum, which container uses the most material?
Specifications require that a concrete mix contain 280 kg/m3 and have a water-to-cement ratio of 0.53. How much water should be used in the mix?
Hello! Can you answer these two questions? Thanks. 1. I. In evaluating the moment of a planar lamina, a horizontal strip cannot be used as a representative area.II. The moment of any planar lamina is the product of the mass of the region and its centroid. a. Both statements are true b. Both statements are false c. Statement I is true, the latter being false d. Statement I is false, the latter being true 2. I. The reaction kinetics of order 0 cannot be evaluated using the concept of integration.II. If the order of reaction is 1 in PFR, given ?, and % conversion, the initial amount is not necessary to find ?. a. Both statements are true b. Both statements are false c. Statement I is true, the latter being false d. Statement I is false, the latter being true
A large-particle composite consisting of tungsten particles within a copper matrix is to be prepared. If the volume fractions of tungsten and copper are 0.70 and 0.30, respectively, a) Compute the modulus of elasticity of this composite in the longitudinal direction. (The upper limit) and the modulus of elasticity in the transverse direction. (The lower limit), given the data that follow. Modulus of Elasticity (GPa) Copper 110 Tungsten 407 b) If the cross-sectional area is 280 mm2 and a stress of 60 MPa is applied in this longitudinal direction, compute the magnitude of the load carried by each of the fiber (tungsten) and matrix (copper) phases.
Consider a soft drink can as a materials system. List all the components in the system and consider alternative materials for each component.
1)To design a Gold chain a goldsmith has taken 2 gram of gold (22 K) wire with 4 mm diameter. Further, he drawn that as wire having diameter of 3 mm by using respective die. Now find the following, [Density of 22K Gold : 15.6 g/cc] a)In making of jewelry (22K) how much percentage of other metals should be added with gold. b)If the material can be readily drawn into wire then the property associated with that is? c)Find the volume of the gold used. d)What is the original dimension of the gold wire before drawn? e)Calculate Poisson’s ratio of the gold wire.
1. Take some water with a straw and put a few drops on plastic sheet. (a) What is the shape of the drop? (b) Move a drop around with your straw. Does the drop change? 2. Move one of the drops close to another one with your straw. What happens when two drops meet? 3. Put a small amount of one of the solids (salt, pepper, sugar, talcum powder) on one of the drops. Does the shape change? 4. Try this again with the other solids. Write your observation
Do this in paper, plz
Please give the proper solution.otherwise skip to other expert . Explain about the term kernel and determine the size of kernel for a rectangular 200 mm x 300 mm.
For my medical device, I wish to create a material that is soft and will retain a lot of water. But I also want it to be rigid and can withstand up to 50lbs of force. What material should I use?