4. A wastewater treatment plant disposes of its effluents into a Units Effluent Stream Item m3/s mgll 0.20 0.50 Flow 2.00 8.00 Dissolved oxygen °C 26 22 Temperature mg/l 40 BOD, at 20°C Assume that the deoxygenation constant K, at 20°C (base e) = 0.20 d-1 and the re-aeration constant K, at 20°C (base e) Equilibrium concentration of dissolved oxygen C, for the fresh water is as follows: 0.40 d-1 for the mixture. %3D Temperature °C 18 20 22 23 24 25 26 C, (mg /1) 9.54 9.17 8.99 8.83 8.53 8.38 8.22 The velocity of the stream downstream of the point A is 0.2 m/ s. Determine Ee critical oxygen deficit and its location. TUS temperature coefficients of 1.04 for K, and 1.02 for K,)

4. A wastewater treatment plant disposes of its effluents into a Units Effluent Stream Item m3/s mgll 0.20 0.50 Flow 2.00 8.00 Dissolved oxygen °C 26 22 Temperature mg/l 40 BOD, at 20°C Assume that the deoxygenation constant K, at 20°C (base e) = 0.20 d-1 and the re-aeration constant K, at 20°C (base e) Equilibrium concentration of dissolved oxygen C, for the fresh water is as follows: 0.40 d-1 for the mixture. %3D Temperature °C 18 20 22 23 24 25 26 C, (mg /1) 9.54 9.17 8.99 8.83 8.53 8.38 8.22 The velocity of the stream downstream of the point A is 0.2 m/ s. Determine Ee critical oxygen deficit and its location. TUS temperature coefficients of 1.04 for K, and 1.02 for K,)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A manufacturing facility that manufactures printed circuit boards puts washwater that was used to wash solvents from the circuit boards into a septic tankwhich discharges into ground water. The wash water contains 7.34 mg/L of dissolved trichloroethylene (TCE). The daily rate of discharge is 13.6 m'/day. Theunderlying aquifer has an average linear groundwater velocity of 0.34 m/day.The discharge has been going on long enough so that steady state conditionshave been reached. Assuming no degradation of the TCE, what is the concentation at a monitoring well located 22 meters downgradient of the septic tankdischarge (* = 22 m, y = 0 m)? Assume a value for b.
1) Design a UASB reactor to treat wastewater at 30°C from a food processing plant. The wastewater fow rate is 500 m3/d with a solubleCOD concentration of 6000 mg/L. The design parameters are asfollows:Reactor effectiveness factor (E) = 0.85Upfow velocity = 1.2 m/hOrganic loading rate = 12 kg sCOD/m3 ·dY = 0.08 kg VSS/kg CODkd = 0.03 d–1μmax = 0.25 d–1Ks = 360 mg/LHeight for gas collection = 3 mUsing the given information, determine the following:a. The reactor area and diameterb. The reactor liquid volumec. Liquid depth and total height of the reactord. The average SRT (assuming 97% degradation of sCOD)
1) Design a UASB reactor to treat wastewater at 30°C from a food processing plant. The wastewater fow rate is 500 m3/d with a solubleCOD concentration of 6000 mg/L. The design parameters are asfollows:Reactor effectiveness factor (E) = 0.85Upfow velocity = 1.2 m/hOrganic loading rate = 12 kg sCOD/m3 ·dY = 0.08 kg VSS/kg CODkd = 0.03 d–1μmax = 0.25 d–1Ks = 360 mg/LHeight for gas collection = 3 mUsing the given information, determine the following:a. The reactor area and diameterb. The reactor liquid volumec. Liquid depth and total height of the reactord. The average SRT (assuming 97% degradation of sCOD) 2) Determine the methane gas production rate (m3/d) for the reactorfrom problem 1) Assume COD equivalent of VSS equals 1.42 kgCOD/kg VSS.
An Engineer in charge of a reservoir has to release water from it for being picked at a distance of 50m km d/s side. The average width of the stream is 40m. The mean daily class A pan evaporation for that season is 0.5 m. estimate the mean daily evaporation loss to be considered by the engineer in releasing water in Ha-m. Take Cp= 0.7.why has the engineer taken note of evaporation and its measurement.
A tank contains three liquids; kerosene (s= 0.80), crude oil (s=0.90) and sea water (s=1.05) with depths of 0.60 m, 0.40 m, 0.80 m respectively. An orifice 100 mm diameter is located at the bottom with a discharge of 29 L/s. Knowing that the diameter of tank is 1.2 meter. Determine the the time to remove both sea water and crude oil only. a. 34.5 sec b. 62.3 seconds c. 70.2 seconds d. 63.6 seconds e. 59.8 seconds.
The BOD of a sewage incubated for one day at 30o C has been found to be 100 mg/L. What will be the five day 20o C BOD? Assume K = 0.12 (base 10) at 20o C, and θ = 1.056
2.A 25–mm diameter commercial steel pipe,50 m long,isused to drain an oil tank. Determine the discharge whenthe oil level in the tank is 5 m above the exit of the pipe.Neglect minor losses and assume f = 0.12.
A new water treatment plant is going to be constructed in Jacksonville to replacethe existing plant. The average annual water temperature is 19 oC. The following designassumptions for a flocculation tank have been made:Number of tanks = 1Detention time = 40 minVelocity gradient = 25 s−1Impeller type: radial, 3 flat blades, Np = 0.33Impeller diameter = 1.1 mRotational speed = 30 rpmWhat is the design flow rate in m3/d?
8. An oil having specific gravity of 0.85 and a kinematic viscosity of 1.8x10-5 m2/s flows in 10 cm diameter pipe at 0.50 liters/sec. What type of flow is it? a. Critical b. laminar c. turbulent d. sub-critical
Oil flows at 62 L/s in a pipe of 175mm diameter and 50m length. SG of oil is 0.9 and viscosity is 0.04 Pa-sec. If head loss is 5.22m, determine:
An oil (s.g=0.85) and viscosity of 1.8 x 10−5 m2/s flows in a 10cm diameter pipe at 0.50L/s. Is the flow laminar or turbulent?
An open cylindrical tank, 2.4 m diameter and 6m tall has 1m of glycerin (Sgglycerin=1.5), 2.5m of water, and 1.5m of oil (Sgoil=0.82). Determine the discharge through the 125mm diameter located at the bottom of the tank. Assume C=0.65