4. An oil tank is an upright cylinder, buried so that its circular top is 10 feet beneath ground level. The tank has a radius of 5 feet and is 15 feet high, although the current oil level is only 6 feet deep. Calculate the work required to pump all of the oil to the surface. Oil weighs 50 lb/ft?.

4. An oil tank is an upright cylinder, buried so that its circular top is 10 feet beneath ground level. The tank has a radius of 5 feet and is 15 feet high, although the current oil level is only 6 feet deep. Calculate the work required to pump all of the oil to the surface. Oil weighs 50 lb/ft?.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.31P: Resolve the 360-lb force into components along the cables AB and AC. Use =60 and =40.

See similar textbooks

Related questions

Q: A 1.5m semi cicular gate is submerged in oil having an SG of 0.95. its base is 2m from the surface…

Q: A conical tank of top radius 4-ft and height 4-ft is filled with oil with a specific weight of…

Q: 10. How far below the water surface is it necessary to immerse a vertical plane surface, 1m square,…

A: The Centre of pressure is defined as the point of application of the total pressure on the surface…

Q: 9. (A.) Find the approximately height of water upstream of the dam or the headwater in meters, such…

Q: A water tank in the shape of an inverted right circular cone has an altitude of 15 feet and a base…

Q: A vertical semi-circular area of radius r is submerged in a liquid with its diameter in the liquid…

Q: A horizontal cylindrical tank 4ft in the diameter and 10ft long is full of water. Find the work done…

A: Draw a diagram for the problem. Here, G is the center of gravity of the cylindrical tank filled…

Q: An open cylindrical tank of having a diameter of 4ft and a height of 6 ft is partially submerged in…

A: Given data: The diameter of the cylindrical tank is D = 4 ft.The height of the cylindrical tank is h…

Q: A hemispherical tank of radius 4 meters is full of water. find the work done in pumping all the…

Q: A pond with water, whose width is b, is divided by a partition. On one side of the partition the…

A: For the given system To determine Force acting on the septum

Q: 2. A vertical cylindrical tank is filled to the top with water at a temperature of 20°C. The…

Q: Find the work required to pump the water out of a tank shaped like an upside down pyramid with…

Q: A cylindrical water tank 4 meters high with a radius of 2 meters is buried so that the top of the…

A: Consider a layer of water with thickness ∆y at a distance y metres from orifgin.r=2…

Q: Problem 2: A 20 cm^3 cylindrical object has a density of 0.876 g/ml. When placed in a container of…

A: Volume of the cylindrical object, Vobject= 20 cm3 Density if the cylindrical object, ρobject= 0.876…

Q: A rectangluar swimming pool 25 feet long, 15 feet wide, and 7 feet deep is filled with water to a…

Q: vertical cylindrical tank (1m in diameter and 4m Height) open at the top end is full of water. If…

Q: find the specific gravity of the denser fluid

A: For solution refer below images.

Q: 5.1 An open, 500 mm diameter tank contains water to a depth of 900 mm when at rest. If the tank is…

A: Dear student, According to the guidelines I am allowed to answer only one…

Q: A frustum of a right conical vessel stands vertically on its vertex. It has an altitude of 1.0 m.…

A: Given: dbottom=0.5 mdtop=0.8 mh=1mN=90 rpmTo find:volume of water remained after rotation=?

Q: A double purpose tank 18 ft wide, 24 ft long and 4 ft depth is filled with water. What is the weight…

A: Write the given data with suitable variables.

Q: A cylindrical tank 2m diameter, 3m high is full of oil. If the specific gravity of oil is 0.9, what…

Q: Calculate the weight of a reervoir of oil if it has a mass of 550kg. If the same reservoir has a…

A: Write the expression to obtain the weight of a reservoir of oil.

Q: A rectangular body 5 m long, 3m wide, 1.2 m height is immersed to a depth of 0.8 m in water. Find…

A: Given data,l=5mw=3md=1.2md1=Depth immersed-0.8m

Q: a conical water tank has its top at ground level(considerr this to be the x-axis) and its base 12 ft…

Q: 13. Fig 3.66 shows a gate having a quadrant shape of radius of 3 m. Find the resultant force due to…

A: Given:R=3 m

Q: A cubical tank is filled with 2m of oil having specific gravity of 0.80. Find the force acting on…

Q: 2. A triangular gate having a horizontal base 4 ft. long and an altitude of 6ft is inclined 45° from…

A: Base length of triangular gate, L=4 ftAltitude of triangular gate, h=6 ftInclination angle of gate…

Q: An oil of specific gravity 0.98 is flowing through the pipe of diameter 30cm. one end of the simple…

Q: An open vessel contains water up to a depth of 5.34 m and above it an oil of SG = 0.8 for a depth of…

Q: A cylindrical tank is 50 in. Long, has a diameter of 16 in., and contains 1.65 lb water. Calculate…

A: (3) Given data:

Q: SITUATION 5: An open cylindrical tank has a base dlalmeter Ol and contain 3.86m deep of water. The…

A: Without relative motion between particles, a fluid can be translated or rotated at constant…

Q: What is the fluid force on the vertical side of a tank shaped like a rectangle with a horizontal…

A: The fluid force on the vertical side of the tank is 1123.2 lb.

Q: How much work is required to empty the full tank shown below by pumping water up and over the top…

A: Given: The density of water, ρ = 62.4 lb/ft^3

Q: An open cylindrical tank 3ft in diameter and 5ft high contains 3ft of water. If the tank is rotated…

Q: 4. A tank half-filled with water is in the form of a rectangular parallelepiped 5 ft deep, 15 ft…

Q: A triangular gate having a horizontal base 4 ft. long and an altitude of 6ft is inclined 45o from…

A: Given:length of the base=4 ftAltitude=6 ftInclined=45o

Q: 2 Problem Solving: 1. Calculate the force acting on a 30-cm diameter porthole of a ship if the…

A: The given question (question 3) relates to fluid statics and variation of pressure with depth. the…

Q: 3.106 A sphere of radius 25 mm, made from material of specific gravity of SG= 095, is sub merged in…

A: Given data radius of sphere R = 25mm = 0.025m Specific gravity of material SG = 0.95 Radius of the…

Q: 4. Situation 2 - A cylindrical tank contains water to a depth of 0.90 m. What is the resulting…

A: To find : The resulting pressure in kPa at the bottom of the tank . Given: The depth of water is…

Q: 7. An 8 ft. square gate lies in a vertical plane. If one of the diagonal of this gate is vertical…

A: Given: Side length of the square plate, a= 8 ft= 2.4384 m Distance between center of the gate and…

Q: The bottom of a swimming pool is an inclined plane. The pool is 2m deep at one end and 8m deep at…

Q: An oil of specific gravity 0.88 is flowing through the pipe of diameter 30cm. one end of the simple…

Q: A vertical triangular gate with water on one side is shown in fig. (2.1). find the total resultant…

A: The expression for the area of triangle can be written as below, A=121.2 m1 m=0.6 m2 The expression…

Q: A simple mercury manometer connected into a flow line which is closed on the other end filled with…

Q: A tank contains water up to a height of 10 m. One of the sides of the tank is inclined. The angle…

A: Given: h = 10 m θ=60o W = 5 m

Q: Find the required diameter of a droplet of water in order to have a pressure of 1 kPa within it,…

Q: A rectangular tank 2m long, 1.5m wide and 1.5m deep is filled with oil of specific gravity 0.8. Find…

Q: An open vessel contains water up to a depth of 4.83 m and above it an oil of SG=0.8 for a depth of…

Question

Please show me how to get to the answer

4. An oil tank is an upright cylinder, buried so that its circular top is 10 feet beneath ground level. The tank has a radius
of 5 feet and is 15 feet high, although the current oil level is only 6 feet deep. Calculate the work required to pump all of
the oil to the surface. Oil weighs 50 lb/ft?.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.