4. Determine the current passing through the 7K ohm resistor 1k 2k 5V 3k -7k

Q: P3.1 Consider the half-wave diode rectifier circuit shown in Figure 3.2. Assume a VĘ value of 0.6V.…

A: Half-wave rectifier diode circuit is define as a circuit which is formed with the use of single…

Q: 1. What is an inductor and what consist of inside?

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a…

Q: electromagnetism, motors and back emf.

A:

Q: Q1/ The bandwidth of an input signal to the PCM is restricted to 4KHZ. The input signal varies in…

A: We need to find out number of bits per sample and bandwidth for given pcm system

Q: What will be the Magnetic field value at the center of a current-carrying coil?

A: The solution is given below

Q: A parallel plate capacitor has plates of area 2.56 cm2 spaced by three layers of different…

A:

Q: Q9. Determine the steady state stability limit of the system shown below, if Vt= 1.0 pu and the…

A: Given: Vt=1.0 pu

Q: Show your solutions with checking. 1. Convert the decimal number 10 to a binary digit.

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: Please use NODAL ANALYSIS to solve for the breanch currents thank you. Show clean and complete…

A: The given circuit is as shown below,  We need to find the branch currents I1, I2, I3, I4, and I5.

Q: A certain op-amp has bias currents of 50µA and 49.3µA. The input offset * current is (a) 700 nA O…

A:

Q: Rf Vo is (t Rs RL

A:

Q: 12.6 A tunnel is modeled as an air-filled metallic rectangular waveguide with dimensions a = 8 m and…

A: We need to check whether the given frequency is greater than cut off frequency or not .

Q: Q1)information signal is PCM using 8 levels quantization if the signal is given as cos(4t) with…

A: According to the question, an information signal is PCM using 8 level quantization if the signal is…

Q: 10. What are the range of values for IL(Load Current) for the given circuit below? 1ka 21 25V RL 12V

A: Here the properties of zener diode has been used. The zener voltage mentioned here is 12v. The load…

Q: Q/ Using Kirchhoff's law, find the current ? R. =472 R:1502 12-2

A:

Q: Sketch the final waveform of below circuit. * V1 D2 9V R1 25V

A:

Q: An opaque surface, by 2 m, Is malhtalhed at K and is exposed to solar irradiation with G = 1200…

A: Radiation of heat transfer: It is a process where heat wave are emitted that may be absorbed…

Q: A cast steel toroid has an average diameter of 6 in and a circular section whose area is 0.48 sq.…

A: Given, Average diameter, D=6 in=0.1524 m Cross sectional area, A=0.48 in2=3.1×10-4 m2 Turns in coil,…

Q: Provide the ff 1.) expansion and conversion process 2.) canonical sop form of F' 3.) standard sop…

A:

Q: Q2. A three phase, 350 MVA, 13.8 kV AC generator has a synchronous reactance of 1.20 per unit. The…

A: The solution is given below

Q: Solve for the electric network 120 12V 200 10V ww- 150 find the values of each current across each…

A: We need to find out current through each resistor .

Q: Is the PEC a law? What is a small appliance branch circuit?

A: Small appliance branch circuit: This circuit is used for mainly in the kitchen area and not used for…

Q: 1 Find the activity factor at the output of each gate if P at A, B and C are all equal to 1/2. A C O…

A: We are authorized to answer one question at a time since you have not mentioned which one you are…

Q: 2- Use superposition to obtain vx in the circuit of Figu Answer: 0.75 A. -0-8 90 V

A: The solution is given below

Q: 5. An air-cored solenoid has a cross section of diameter 10 cm and 60 cm long. It is wound with 1000…

A:

Q: Q1. Verify Associative property of convolution for the given input and Impulse responses (using…

A: The solution is given below This is a basic problem of convolution integral of signal and systems

Q: P5.63. Consider the circuit shown in Figure P5.63. Find the phasor current I. Find the power,…

A: Ac sinusoidal analysis  Given Inductor value = 1H

Q: Use cascading to design a Butterworth active low pass filter with the following specifications: Amax…

A: According to the question, We need to design, Butterworth active low pass filter.

Q: multispeed fan motors achieve multiple speeds by inserting additional _____ in series with the run…

A: In this question we need to complete the statement.

Q: I, = 25230°A, R2 = 902, R3 = 852, X2 = -402, N1 = 3, and N2 = 1. Com- Let V3 = 302 – 20°V, Z1 = 55+…

A:

Q: 8. A 10 HP, 6 pole, 60 Hz, 3-phase SCRIM delivers 9.9 HP, with an input of 9200 W. The core loss is…

A:

Q: A certain inverting amplifier has a closed- loop gain of 25. The op-amp has an open-loop gain of…

A: It is given that: Af=25Ao=100,000Ao'=200,000

Q: A certain op-amp has a CMRR of 250,000. Convert this to decibels 100 dB O 205 dB O 108 dB O 110 dB O

A:

Q: For the amplifier a) Determine the dc collector voltage. (b) Determine the ac collector voltage. Vcc…

A:

Q: 10. What are the range of values for IL(Load Current) for the given circuit below? 1ko 21. RL 25V…

A: Here it has been solved using the properties of zener diode. Here the zener voltage is 12v which is…

Q: The open-loop gain of a certain op-amp is 175,000. Its common-mode gain is * .0.18. Determine the…

A: The CMRR is given by the ratio of open loop gain and common mode gain. Here we have open loop gain =…

Q: Problem 2 Use Gauss' theorem to determine f, D.dS, where the electric flux density is D = x²ax -…

A:

Q: Figure shows a direct-coupled (that is, with no coupling capacitors between stages) two-stage…

A: The required parameters can be obtained by using the DC analysis and AC analysis of the multistage…

Q: Utilice el análisis de mallas en el circuito de la figura 8-80 para encontrar la corriente I1. R3 =…

A: To calculate the current I1 by using mesh analysis. First consider current source and convert it to…

Q: torque. Ans[40.5 N.m, 63.6 N.m, 1333r.p.m] The resistance and standstill reactance of each phase of…

A:

Q: In a signal phase, pedestrians are allowed to cross the street walking in the same direction as…

A: It is given that: Crosswalk length=L=722 ft=36 ftWE=9 ftWE<10 ftδp=4 ft/secNpld=20

Q: Discuss with block diagram, the principle of operation of single phase energy met

A: (i provide you the solution in RULE PAPER for easily understand to the diagram and its related…

Q: Amplifiers found in the early stages of a cascaded amplifier system are called_ amplifiers. A…

A: The solution is given below

Q: The output of a system response is given as_ f(t)= 5-5e-3t 3) What is the steady state or force…

A: Given response is step response of first order system. Compare the given response with the standard…

Q: R 3 Ls V2(s) le V,(s) Cs R 2 V,(s) T(s) V,(s) Fig. P 2.1 (a)

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: A condenser is connected for 0.25 sec across a 220V supply, the current being kept steady at 0.22A.…

A: In this question,  We need to determine the value of capacitance C?  If condenser is connected for…

Q: Question 3: According to the following circuit answer the following A- Find the Maxterm for this…

A: We need to find out min and Max term for given circuit

Q: P5.86. Find the Thévenin and Norton equivalent cir- cuits for the circuit shown in Figure P5.86.…

A: In this question,  A circuit is given,  Find the Thevenin equivalent and Norton equivalent across…

Q: Q5. An LTI system is described by the following linear constant coefficient differential equation…

A: The solution is given below

Q: 6. E,=_ R, = 15 kn %3D R2 = 5 kn R3 = 250 %3D R4 = 1000 0 %3D IT = 10 mA

A: In this question we will find total voltage ET....