4. Determine the mesh currents. (Assume clockwise direction) lon 40V ( +) 20v
Q: For the circuit shown. If the peak voltage V, -120 L 20 V, X = 4.Y=2, and Z = 4. Answer the…
A:
Q: Which of the following statements are correct for three phase circuit: A. Sum of all the three phase…
A:
Q: Over string of three phase transmission line has a four insulators and Ce=0.12 C. If the voltage…
A:
Q: Choose the correct answer: Line voltage is V3 times higher than phase voltage for STAR connection.…
A: In this question we will write about star connection line voltage and phase voltage relation...
Q: Given the circuit shown below, if Zx = 100/0 o determine the current in each branch by: a) Nodal…
A: To determine the current in each branch
Q: Each line of a 3-phase system is suspended by a string of 3 similar insulators. Find the string…
A:
Q: Assume that a primary feeder length L=2.4Km has a constant K = 0.002 (%VD/KVA.mil) and that a lumped…
A:
Q: Over string of three phase transmission line has a four insulators and Ce= 0.12 C. If the voltage…
A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…
Q: Determine the value of the mesh currents shown below. 12 12V 10 V
A:
Q: 1. Match the load to the line using a shunt stub: a) Short-circuited Open-circuited a) ZL = 500 ohms…
A: We need to match the load to the line using a shunt stub: a) Short-circuited. b) Open-circuited.…
Q: (i) Determine the currents for the electrical network shown in the following figure, using Gauss…
A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: (ii) A string of suspension insulators consists of three units if the voltage across the line unit…
A:
Q: calculate percentage of voltage regulation and ( receiving end complex power ) for the following…
A: In the question, calculate percentage of voltage regulation 2. receiving end complex power V(RNL) =…
Q: wwwA www w Using Kirchoff's current law, calculate the unknown currents in the above circuit.
A:
Q: The real power consumed by a single phase pure capacitive load is equal to zero. Select one: O True…
A: In a purely inductive or a purely capacitive circuit that contains reactance, (X) the current will…
Q: Using Maxwell’s (mesh) Loop method, determine the mesh currents IA, IB, IC and branch currents I1,…
A:
Q: secondary, the maximum flux in the core is 0.02 Wb, if the full-load copper loss is 0.5 kW on the…
A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…
Q: Find out the sending end voltage (Vs) and %efficiency for the given readings VR(line to line)=…
A: Given VR(line to line)=382 vcosϕR=0.8IR=0.63 AResistance R=24 ΩXL=24 Ω
Q: A 3-phase transmission line operating at 10 kV has a resistance of 192. The percentage resistance of…
A: Given, A 3-phase transmission line with, Rated line voltage, V = 10 kV Resistance, R=1 Ω Base kVA =…
Q: 4. For the Figure shown below, determine nodal voltages using Nodal Analysis. 40 SA 120 4A ww ww ww
A: In the given circuit there are 3 nodes exists. Out of which one node is taken as reference in nodal…
Q: Circuit Impedance Z = Phase Angle = arc cos R/Z = , Calculated Es = Calculated Ec = Calculated ER =…
A:
Q: mple 4.1: Calculate the Sequence Components o nced, Line-to-Neutral Voltages with “abc" sequen Va =…
A:
Q: ww B 10 V 'DŽ 12 2 Ic E 12 V
A: Nodal analysis is nothing but combination of both KCL and ohm's law.
Q: A certain installation has 150 kW, 400V, 0.9 pf, 3 phase load. Load is to be fed by a 4 core cable.…
A: Given P=150 kW V=400 V pf =0.9 length of cable =150 m total voltage drop =5% of nominal voltage
Q: no load test, VNL= 220 V P= 310W INL= 6.2 A load test , V = 220 V P;= 3650 W N = 1710 rpm %3D | =…
A:
Q: (a) ...is uncertain (True) (False) (b) ...is intermittent (True) (False) (c)...is random (True)…
A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…
Q: A 380 V system as shown below, obtain the line currents and phase voltages * 1j 3+2j 2-3j 1-4j 1 j 1…
A:
Q: 1. Refer to the figure below. Find the line currents passing through the line impedance 0.6+j0.5 068…
A: The three impedances of 30-j20 Ω are connected in the delta configuration. This can be converted to…
Q: 32 20A Gov
A:
Q: For the circuit shown in Figure, determine the branch currents using Kirchhoff's laws 50.1 Ω 0.05 Ω…
A:
Q: 1. Using nodal voltage method, determine the magnitude and direction of the current / in the network…
A: Given circuit- Before applying node voltage method to the above circuit, First applying source…
Q: For the shown W xh rectangular loop that is parallel to an infinitely long wire carrying current I =…
A:
Q: 1) The line currents in a 3-ph 4 -wire system are Ia = 100<30°; Ib = 50<3000°;Ic = 30<180°. Find the…
A:
Q: Find % Regulation for the given readings VRILine to Line) 394 Volts, Vs(Line to Line ) = 458 Volts…
A: In this question we will find percentage regulation.... Note:- as per our guidelines , I will answer…
Q: For the circuit of Figure 24–48, if Iab = 10 A ∠21°, determine all the line voltages.
A: In this question we need to find a line voltage of the given three phase system
Q: R, = 4N XL= 30 %3D R2= 10N R3 = 120 Xc=50 240 V. 50 Hz
A: Given circuit shown
Q: In Figure 2, arrangement is shown for a voltage supply of 410V. For xyz sequence assume that Vw = V,…
A: The phase sequence is xyz, considering Vxy as reference voltage, Vxy=410∠0° VVyz=410∠-120°…
Q: Problem No. 1. Using mesh analysis, solve for Vo. B=100 9 Volts Vb Rb 20 KOhms Rc 500 Ohms C V₁ =?…
A: In this question, We need to determine the Voltage Vo as shown the circuit. The current gain,…
Q: 3 P, 10 kVA, 400 V, s ynchronous generator rmature resistance of .8 Q per phase and sy eactance of…
A:
Q: (ii) A string of suspension insulators consists of three units if the voltage across the line unit…
A: A string of suspension insulators consists of three units if the voltage across the line unit is VL…
Q: A single phase line has a resistance 0.001 Ohm/meter with a total length of 50 km. The apparent…
A: Given data Resistance r =0.001 Ω/m Total length L = 50 km = 50,000 m Apparent power S = 100 KVA…
Q: Circuit Impedance Z = Phase Angle = arc cos R/Z = Calculated Es = Calculated Ec = Calculated ER =…
A: In this question, Find the voltage acros each element and total voltage. What is total impedance…
Q: For a 3-phase ac device, full load current is 50A, line voltage is 400V and reactance value is…
A: Note: Since you have not specified any question to be answered, as per our honor code, we are…
Q: A transmission line connecting Ibra and Sur carries 33kV and 300OA. The substation concerned is…
A: What is the rating of the number of turns of primary and secondary side winding of PT.
Q: In wattmeter both current and pressure coils are required. For -4 *.obtaining the required phase…
A: Here choose the given Statment is true or false? In wattmeter both current and pressure coils are…
Q: AC resistance of conductors used in electrical machines which is operating with AC power supply is…
A: In the question, the given Statment "AC resistance of conductors used in electrical machines…
Q: A 440 V, 3-phase 4 wire system has the loads 4 – j8, 6 + j2 and 6 + j3 Ω connected in star.…
A: Given: Z1 = 4 - j8 Ω Z2 = 6 + j2 Ω Z3 = 6 + j3 Ω and voltage supply Line voltage, VL = 440 V…
Determine mesh currents. Show step by step solution thank youu.
Step by step
Solved in 2 steps with 2 images
- For the figure below, determine the mesh currents ?1 , ?2 and ?3 .a 3 units suspension insulator, the voltage across the top and middle units are 30% and 32% respectively of the line voltage, find the ratio of capacitance of insulator to that of its capacitance to earth and efficiency of the system.Solve the following using Maxwell’s Mesh Method 1. What will be the mesh current of the following circuit?
- A concentric cable has a core diameter of 10 mm. The inductance of the cable is 4 × 10−7 H/m. Ignoring inductance due to internal linkages, determine the diameter of the sheath. Assume that the relative permeability is 1.Using Maxwell’s (mesh) Loop method, determine the mesh currents IA, IB, IC, IDIt is better to have common earth rather than having different earthing for electronic instruments and instruments carrying high currents? a)True b)False
- Given the circuit shown below, if Zx = 100/0 o determine the current in each branch by: a) Nodal Methodb) Maxwell’sMethodSolve for the equivalent resistance at terminal A&B using Wye-Delta/Delta-WyeTransformation, when 1 kilo-ohm resistors are connected in the shape of a hexagonal prism.Using Maxwell’s (mesh) Loop method, determine the mesh currents IA, IB, IC and branch currents I1, I2, I3, I4
- For the arrangement shown in Figure below, find the current IxH:10) Connect a battery to a solenoidA cylindrical solenoid 40 cm long with a radius of 2 mm has 300 tightly-wound turns of wire uniformly distributed along its length (see the figure). Around the middle of the solenoid is a two-turn rectangular loop 3 cm by 2 cm made of resistive wire having a resistance of 195 ohms. One microsecond after connecting the loose wire to the battery to form a series circuit with the battery and a 20 resistor, what is the magnitude of the current in the rectangular loop and its direction (clockwise or counter-clockwise in the diagram)? (The battery has an emf of 9 V.) ................A clockwise counter clockwiseUsing Maxwell’s (mesh) Loop method, determine the mesh currents I1, I2, I3.