4. The plan of a flexible rectangular loaded area is shown in the figure below. The uniformlydistributed load on the flexible area, q, is 100 kN/m² . Determine the increase in the verticalstress, Aoz, at a depth of z = 2 m belowа. Рoint Ab. Point Bc. Point C4 m1.6 m|2 mB0.8 mq = 100 kN/m²A1.2 m→

Answered: Image /qna-images/answer/cdcfdb33-5f47-4551-a985-4d9b39b1ebaa.jpg

4. The plan of a flexible rectangular loaded area is shown in the figure below. The uniformly distributed load on the flexible area, q, is 100 kN/m? . Determine the increase in the vertical stress, Aoz, at a depth of z = 2 m below a. Point A b. Point B c. Point C 4 m 1.6 m- |2 m B 0.8 m q = 100 kN/m² A 1.2 m→

4. The plan of a flexible rectangular loaded area is shown in the figure below. The uniformly distributed load on the flexible area, q, is 100 kN/m? . Determine the increase in the vertical stress, Aoz, at a depth of z = 2 m below a. Point A b. Point B c. Point C 4 m 1.6 m- |2 m B 0.8 m q = 100 kN/m² A 1.2 m→

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter6: Vertical Stress Increase In Soil

Section: Chapter Questions

Problem 6.11P

See similar textbooks

Similar questions

It is required to design a cantilever retaining wall to retain a 5.0 m high sandy backfill. The dimensions of the cantilever wall are shown in Figure 15.52 along with the soil properties. Check the stability with respect to sliding and overturning, based on the active earth pressures determined, usinga. Coulomb's earth pressure theory (δ' = 24°), andb. Rankine's earth pressure theory.The unit weight of concrete is 24 .0 kN/m3
A retaining wall 6 m high supports cohesionless soil having a dry density of 1600 kg/m³, angle of resistance 32 and void ratio of 0.68. The surface of the soil is horizontal and level with the top of the wall. Neglecting wall friction and using Rankine’s formula for active pressure of a cohesionless soil. 1. Determine the nearest value of the total earth thrust on the wall in KN per lineal meter if the soil is dry. a. 73.1 b. 86.7 c. 62.4 d. 98.1 2. Find the nearest value of the thrust on the wall in KN per lineal meter if owing to inadequate drainage, it is waterlogged to a level of 3.5 m below the surface. a. 112 b. 171 c. 147 d. 153 3. Find at what height above the base of the wall the thrust acts during the waterlogged condition. a. 2.21 m b. 2.00 m c. 1.74 m d. 1.42 m
11. A rectangular channel with width = 10 meters and depth = 3 meters has a flow slope of 0.001 and roughness n = 0.025. The flow rate is 80 m3/s. Determine the shear stress on the channel in Pascals.
Given Figure E1, draw the active earth pressure distribution. Use gw = 9.81 kN/m3. Determine the magnitude and location of the active thrust.
A concrete gravity dam with a trapezoidal section is holding water as shown in the figure. A distance of 15 meters from the toe, a drain is located. The drain has a pressure due to uplift of zero and increasing uniformly to full hydrostatic at the heel. Upstream face 1H:5V, while downstream face is inclined 1H:2V. Which of the ff nearly gives the maximum foundation pressure on the base of the dam in kilopascal ? Assume 23.54 kN/m3 for the unit weight of concrete. a. 3114 b. 1095 c. 4115 d. 964 e. 680
Q.1. Refer to the infinite slope shown in Figure 1. Given: β = 19 ͦ, ɣ = 20 kN/m3 , Ø = 33 ͦ, and c’ = 47 kN/m2 . Find the height, H, such that a factor of safety, Fs = 3.1 is maintained against sliding along the soil-rock interface. Also Determine the thrust on the wall if the water table rises to a level 2 m below the surface of the sand. The saturated unit weight of the sand is 20 kN/m3 .
A 6m high vertical retaining wall is used to retain a soil of unit weight 18 kN/m3 and slope 20°. The soil is a cohesionless soil with internal friction angle of 40°. Compute the coefficient of active earth pressure from the given data.
A level site underlain by fully saturated clays is cut over a few days as shown in the figure below. The water table is located at the ground surface across the site. Determine the resisting moment in kN.m for the circular slip surface depicted in the Figure below shortly after excavation. Consider the soil wedge above the circular slip surface as a single free body, whose plane area is equal to 100 m2 and the centre of gravity of the soil wedge is given at Point C.
For a railway track 7 m high embankment is required. The clay to be used for the embankment was found to have c = 20 kN/m2and unit weight = 19 kN/m3 Compute the critical maximum side slope angle for the embankment if a hard rocky stratum was found 3.5 m below the ground level. Assume ϕ for the clay equal to zero. The following values are given from Taylor's chart for depth factor D = 1.5 :
45.) A retaining wall supports a horizontal backfill that is composed of two types of soil. First layer: 5.91 meters high, Unit weight of 17.26 kN/m3, coefficient of active pressure of 0.291 Second layer: 5.36 meters high, Unit weight of 18.85 kN/m3, coefficient of active pressure of 0.301 Determine the distance of the total active force measured from the bottom of the wall. Round off to three decimal places.
A retaining wall has a vertical back and is 7.32 m high. The soil is sandy loam of unit weight 17.30 KN/cum, it shows a cohesion of 12KPa and angle of friction 20 degrees. Neglecting the wall friction, determine the thrust on the wall in KN/m. The upper surface of the fill is horizontal. 121 343 232 104
3. An infinite slope has shear strength parameters at the interface: c = 30 kPa, φ = 30°, γ = 17 kN/m3 (Assume 1 m strip perpendicular to the paper and 1 m strip along the inclination of the infinite slope). a. If H = 5 m, and β = 20°, find the sliding force. b. If H = 5 m, and β = 20°, find the force that resist sliding on the rock surface. c. If HCR = 8 m, find the minimum angle β so that the slope is stable.