4. Use Norton's theorem to find Vo in the network. 2Ix 1220° v j22 Vo j42 320° A 1x le

Q: Draw the equivalent circuit if you are going to perform Open Circuit Test(OCT)(at terminals a-b,…

A:

Q: et a[n]. What is the sampling rate F,? -3 0.5 10-2 O a. 25 Hz O b. 250 Hz Ю с. 300 Hz O d. 30 Hz О…

A: In a given 10ms signal duration, there are 6 samples. Time duration between two samples is given by…

Q: 24.) The figure below shows a series-parallel circuit. Compute for the total active power consumed…

A: This question is related to power calculations

Q: The C-S MOSFET amplifier has three low break frequencies in low frequency band at fLI =1 Hz (caused…

A: The given circuit is as shown below,

Q: For the electrical circuit system shown, find the transfer function Io(s)/V(s)and Vo(s)/Io(s

A: In this question, We need to determine the find the transfer function Io(s)/V(s)and Vo(s)/Io(s).

Q: A communications satellite is used to link a number of mobile ground stations which transmit and…

A: The solution is given below

Q: A 230 V DC shunt motor has a full-load efficiency of 89.9%. Rated (full) load is 40 hp. Motor…

A: Solve first three sub-parts in a multiple sub-part question, unless the student has asked for…

Q: A 3-phase 50 Hz I.M. has a rated torque = 16.7 N.M and maximum torque = 40.5 N.M. If its rated speed…

A:

Q: Please write a long explanation so that we can report back to you Ideal Non-inverting Operational…

A: OPAMP with negative feedback works as amplifier. When supply is at positive terminal then its non…

Q: A signal A contains 1 period of an infinite periodic signal X, while a signal B contains 4 periods…

A: The Discrete Fourier Transform is a mathematical representation of a signal to study the following…

Q: Find the Thevenin equivalent at terminals a-b of the circuit shown below. What is the value of the…

A: In this question,   We need to determine the Thevenin equivalent across the terminal a and b.  Find…

Q: In the circuit shown below, a three-phase star-connected unbalanced load is connected to a balanced…

A: In this question,   We need to determine the value of impedance Zc if voltage difference across the…

Q: The PUT controlling is done through O Anode and gate OCathode and gate OGate

A: In this question we need to choose a correct option

Q: Ideal Non-inverting Operational Amplifier 1- Introduction Cguivalont Circuit

A: Ideal Non-Inverting Amplifier:

Q: In an antenna array, the array factor depends on Tick all that apply. O Radiation pattern. O…

A:

Q: Solve the voltage Vo of the given circuit below. Si +32V 4.7k Vo + V1 - V2 8k2 - 8V 16.72 V 12.16 V…

A:

Q: 1-Compare between calculated, direct measured and Norton's equivalent (F)Discussion:- T-Compare…

A:

Q: 13.) Calculate the inductance or capacitance in series for the impedance 7.52-53.13° ohms. Assume…

A:

Q: e) A WSS random process X(t) is applied to the input of an LTI system with impulse response h(t) =…

A:

Q: 24.) The figure below series-parallel circuit Compute for the tota power consumed by Express in four…

A:

Q: Vieblomse Find Hhe transher function for CO)la Por the fallowing Contral systems by using block dia…

A:

Q: Determine the transfer function H(s) and the impulse response of the circuit shown in Figure Q4(a).…

A:

Q: (B)- Indicate whether the following statemenits are true or false and correct the false statements |…

A: In this question we will write about field diverter method , Eddy current loss, dc series motor....…

Q: The directivity of a half wave dipole is 2.15 dBi. The antenna is operating at 1.78 GHz at an…

A: We need to find out effective area.

Q: In a phasor domain circuit, 220L30° V is applied across two series components, one of which is a 20…

A:

Q: +15V 3K 2K 1K

A:

Q: 3 After being closed for a long fime, the soitch in the eircutt s gened ot t =0 Tind k(t) for +70.…

A: We need to find out current and voltage for given circuit

Q: Q1) Define briefly: 1. Optoelectronics. 2. Electroluminescence. 3. Internal quantum efficiency.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Q3 Referring to the circuit in Figure Q3, determine the values of current, i, and iz by using nodal…

A: We need to find current for given circuit

Q: 100 hp, 440 volts three-phase, 60 hz induction motor operates with 92% efficiency, 0.85 power factor…

A: In this question we will find motor current , synchronous motor starting etc....

Q: A resistor R and an impedance coil Z are connected in series. The combination is supplied by a…

A:

Q: 7.15 Given the system -3 with zero initial conditions, find the steady-state value of x for a step…

A: 7.15)  To find the steady state value of x for a step input u

Q: 1. If A, 2B, 3C are in arithmetic sequence where the distinct numbers A, B, C are in geometric…

A:

Q: Find the current and voltage using superposition across the 4- kN resistor(I, and Vx, respectively).…

A:

Q: Transform the circuit such that the 3 kQ resistor is left unchanged and the final circuit contain…

A: We need to find current and power for given circuit

Q: 2. f Vc t) is given by the waueform below. sketch the copoutor current for -is st as. Determine the…

A:

Q: A 240 V source is connected in series with two components, one of which has an impedance of 80?60°…

A:

Q: elve for the mesh currents in the previous problem.

A:

Q: Solve the voltage across 6.8-kohm resistor of the given circuit below. 32 V ID2 AGe Si o Vo 6.8…

A:

Q: Problem 4 A Y-connected three-phase, 415V, 1460 rev/min, 50 Hz, 4-pole induction motor has the…

A: The efficiency of a motor: It is determined the dividing the mechanical output power by the…

Q: Consider the circuit below, what is the current flowing at 16 kohms? 24 V Ge 8k2 V. 16kn O 0.58 mA O…

A:

Q: -Determine: (a) the value of the current i for t 0, (b) the capacitor voltage at all times, and (c)…

A: In this question,   we need to determine the current i as shown in the circuit and voltage across…

Q: Using τ from above and the value of the resistor, calculate the value of the inductance L. Consider…

A: The solution is given below

Q: Find the z-transform of an–1.

A: In this question,   We need to Find the z-transform of an-1

Q: manufacturing plant takes 200,000 Watts, at 0.6 power factor. Form a 600 V, 60 Hz, three phase…

A: Please refer the attached images for the complete answer..

Q: Q. Use Table below to explain why the circuit of Figure below will not work as it is. How can the…

A: Integrated circuit are known as microelectronic circuit . This integrated circuit are used in…

Q: :The transformer Iron losses is .Constant independent of the applied voltageO

A:

Q: Please write a long explanation so that we can report back to you Ideal Non-inverting Operational…

A:

Q: 12 V 2.2 kM 220 k2 Z, B=60 r=40k2

A: We need to find out voltage gain for given circuit

Q: 26.) A voltage v = 220 sin (275t + Tt/2) is applied to a resistor of 21 ohms. Find the r.m.s. value…

A: When value of voltage and resistance is given , we can find current by ohms law…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.