4.15 Calculate the force in each cable for the suspended weight shown. X- 45° PROBLEM 4.15 K W 500 lb 30° -X

Q: A shaft 70.0 mm diameter is being pushed at speed of 400 mm/s through a bearing sleeve 70.2 mm in…

A:

Q: = Q13. As shown in the image below, the 86 kg-crate is initially at rest, and at a distance d = 8.2…

A: The frictional force acting on the crate can be determined as shown below.

Q: In the figure, aluminum [E = 68 GPa] links (1) and (2) support rigid beam ABC. Link (1) has a…

A:

Q: A projectile is launched from point A with the initial conditions shown in the figure. Determine the…

A:

Q: A steady stream of water travels through an enclosed tank, as seen in the illustration. At section…

A: Given:At section 1: D1=6 cm =0.06 m, Q1=100 m3/hAt section 2: D2=5 cm=0.05 m, V2=8 m/sAt section 3:…

Q: Replace the distributed loading by an equivalent resultant force and specify its location, measured…

A:

Q: Air enters a 7-m-long section of a rectangular duct of cross section 15 cm X 20 cm at 50°C at an…

A:

Q: Consider air within a closed container fitted with a paddle wheel that transfer energy to the system…

A: The given information in the problem is listed in the following attached image:

Q: 4) If block A weighs 100 lb and block B weighs 65 lb, and initially block A moves down the plane at…

A:

Q: A cylindrical steel bar 8 mm in diameter is loaded 1000 cycles per day with a load of 15560 N. How…

A: Given: diameter of steel bar= d = 8 mmapplied load = P = 15560 NNumber of cycles per day = N = 1000…

Q: 1. Show the steps in the derivation of the continuity equation. 2. Show the steps in the derivation…

A:

Q: Air at 60°F flows over a 10-ft-long flat plate at 7 ft/s. Determine the local friction and heat…

A: Write the given data. T=60 °FL=10 ftV=7 ft/s

Q: A tall open-topped standpipe has an inside diameter of 2,750 mm and a wall thickness of 6 mm. The…

A:

Q: Q18. A ball is travelling in a straight line with a constant acceleration of 0.5 m/s². If its speed…

A:

Q: Q16. A 3.4-kip car speeds up uniformly from 0 to 57 mph in 39 seconds up the 15° incline. If the…

A: Given data  Weight of car = 3.4 kips Initial velocity= 0  Final velocity = 57mph Time = 39 seconds…

Q: Determine the force in each cord for equilibrium of the 200-kg crate. Cord BC remains horizontal due…

A:

Q: A conical bar tapers uniformly from a diameter of 4 cm to 15 cm in a length o al force of 80 kN is…

A: Given data:Diameters of the conical bars are 4 cm and 15 cm,d1=4 cmd2=15 cmLength of the conical…

Q: Q1 A smooth cylinder of 50.1 mm inside diameter and 150 m long is placed with its axis vertical. If…

A:

Q: how to get mass (in lb/m) if given weight is 960 lb. Please show the proper conversion of units when…

A: Given :-  Weight = 960 lb To Find:-  Mass (m) in lbm

Q: Calculate the forces in members AB, BH, and BG. Members BF and CG are cables which can support…

A:

Q: Determine the forces in members BE and CE of the loaded truss. The forces are positive if in…

A:

Q: A stainless-steel circumferential fin is installed on a 3-cm diameter tube. The fin's outer radius…

A: given; fin's outer radius(ro)=4cm                                      =0.04mthickness of fin(t)=1mm…

Q: Crank OA = 75 cm with an angle of 30oC with respect to horizontal;OP = 50 cm; CA = 150 cm; CD = 135…

A: Given Data OA = 75 cm θ=30 OP = 50 cm; CA = 150 cm; CD = 135 cm

Q: Q9. The 3.9-kg, uniform crate slides up the inclined surface with an initial speed of 11 m/s. If the…

A:

Q: Argon gas flows through a well-insulated nozzle at steady state. The temperature and velocity at the…

A:

Q: A system executes a power cycle while receiving 900 Btu by heat transfer at a temperature of 900°R…

A:

Q: It looks like a mistake was made. s=368 ft. Could you please re-do this problem?

A: Given: F1=2 i+6 j-2t k F2=t2 i-4t j-1 k F3=-2t i W = -9 k To find: Distance from origin

Q: (06) Air is compressed polytropically from 101 kPa and 23°C and delivered to a tank at 1500 kPa and…

A: Introduction In this problem, we will calculate the polytropic work transfer and heat transfer…

Q: Q2. In the image shown below, according to the provided datum line, determine the gravitational…

A: Given data:

Q: If the flow velocity is the same in magnitude and direction at every point in the fluid  it is said…

A: given = If the flow velocity is the same in magnitude and direction at every point in the fluid it…

Q: The conveyor belt is moving at 5.5 m/s as shown in (Figure 1). The coefficient of static friction…

A:

Q: Determine the moment produced by force FB about point O. Point O is at the base of the pole as…

A:

Q: 13 ст 2 X Com This pic is with d 29 см NNY T 26cm right Triangle that made from Iron rody P 8 11…

A: Given Data: Length of the base of triangle B=26 cm Length of the height of  triangle H=13 cm Length…

Q: Q2. As shown on the right in image below, the force Facting on the box varies with displacement s,…

A: Given data  Coefficient C = 18  Find the work done by the force to the box when the has displaced s…

Q: At time t = 14 s, the velocity of a particle moving in the x-y plane is v = 0.14i + 2.87j m/s. By…

A:

Q: Afy H B -1.5 m-1.5 m 6 kN F C D 1.5 m 1.5 m 6 kN 12 kN Figure 3: Problem 3 ΟΠΟΙΟ E 2 m 2 m

A:

Q: Calculate the weight of an air column between 1000 mb and 900 mb with a 1 m^2 cross-sectional area.…

A: Given Data: Pressure P1=1000 mb=1000×10-3 bar Pressure P2=900 mb=900×10-3 bar Area of…

Q: 0.2857 kg of pure carbon dioxide is contained in a rigid steel vessel which has an internal volume…

A:

Q: Determine the moment of inertia of the central crank about the x-axis. The material is steel whose…

A:

Q: A fluid flows through a pipe and exits into a container that sits on some scales. At the beginning…

A:

Q: Given two Orthographic views of an object, construct an Auxiliary view of the indicated (→→)…

A: Find Construct an auxiliary view of the object.

Q: The "flying car" is a ride at an amusement park which consists of a car having wheels that roll…

A: Given Data: Constant speed of the track vt=3 ms The radius of the circular path R=9.8 m The total…

Q: QUESTION 1 Three concurrent and coplanar forces in equilibrium are shown in the figure. Hint: Use…

A: given; load(P1)=60KNload(P2)=50KNload(P3)=94.5KN

Q: Calculate the force and moment reactions at the bolted base O of the overhead traffice-signal…

A: Given Mass of beam OC = 74 kg Mass of beam AC = 65 kg Mass of traffic signal = 25 kg To find Forces…

Q: The wall of a box furnace is made of a composite material. Layer A is directly in contact with the…

A:

Q: When the 11-lb block A is released from rest it lifts the two 15-lb weights B and C. Neglect the…

A:

Q: We can ensure that the higher the percentage of carbon, the higher the mechanical properties of…

A: The behavior of any material can be determined with the help of the mechanical properties of any…

Q: Q14. As shown in the image below, the 20-kg box is pulled up the inclined plane with a constant…

A:

Q: For has the instant represented, crank Counterclockubise of w=0.9 rad/s a acceleration respectively…

A:

Q: An inventor claims to have developed a refrigerator that at steady state requires a net power input…

A: