4.4 A boost-regulator has an input voltage of 5 V andthe average output voltage of 15 V. The duty cycleis(a) 3/2(b) 2/3(c) 5/2(d) 15/24.9(a(

Given a boost regulator has, Input voltage, Vin=5 V Average output voltage, Vo=15 V

Answered: 4.4 A boost-regulator has an input…

4.4 A boost-regulator has an input voltage of 5 the average output voltage of 15 V. The duty cycle is (a) 3/2 (b) 2/3 (d) 15/2

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Q3)B-A transmission line has the following per unit length parameters: L=0.2 µH/m C=300 pF/m R=5 0/m…

A: For the given value of inductance ,capacitance, resistance and conductance we need to calculate the…

Q: Find current i, in the ideal transformer circuit shown 292 ww 1:3 12 cos 21 V 692

A: given here a magnetic coupled circuit and asked to find the current ix .

Q: Calculate the load voltage in (v) as shown in the circuit below 6 kohm Si 2 kohm Hole ww 18 V 4 kohm

Q: Three distribution of charges are present in free space with: A uniform line charge of PL = 3 HC/m…

A: Electric displacement, denoted by D, is the charge per unit area that would be displaced across a…

Q: (B)- Draw the power flow diagram of d.c generator and give the mathematical Put the input power in…

A: The power flow diagram of the dc generator is shown below:

Q: In the below given figure, two capacitances are in series with a 18V source. The capacitance of the…

A: The detailed solution is provided below. The formulae used is given below.

Q: A circular ring of radius (a) arries a uniform charge pL C/m and is placed on the zy-plane .the…

Q: (b) The output voltage of an amplifier is 2 V at signal frequency of 3 kHz, and reduced to 0.5 V at…

A: We need to find out the output voltage for given change and we will find out change in voltage for…

Q: Q2) Show that: a) x₁(t).x₂(t) → X₁ (ƒ) * X₂(ƒ) b) if x(t-T12) = -x(t) (half-wave symmetery) .If a…

A: b) If a periodic signal is shifted by half of its time period and take amplitude inverse then it…

Q: A car locking system is to be designed with four inputs (D, B, A, and E) and one output L, with the…

A: The required design can be obtained by using the truth table and k-map.

Q: 3.81 The position and velocity error coefficients for the system of transfer function, 50 G(s) = are…

A: Given the transfer function, Gs=501+0.1s1+2s

Q: Given G = 20a, + 50a, + 40a, at (1, π/2, π/6) the component of G perpendicular to surface = π/2 is…

A: Types of coordinates system Cartesian coordinate system Cylindrical coordinates system Spherical…

Q: Q2) show that: a) ſªx(t)dt ↔ X(f) + X(0)8(ƒ) 2πJf 2 b) if x(t) = x(-t) (even symmetery) then all the…

A: For the above given equations we need to derive them by the help of fourier transform and fourier…

Q: Q2 The following reading were recorded for voltage measurement 10.1. 9.7. 10.2, 9.6 9.7, 10.1, 9.6,…

Q: 6 kohm 18 V Si 4 kohm 2 kohm

Q: A factory has a maximum demand of 500 kW, the load factor being 60 % during working hours. The…

A: The part of Tariff in which the maximum load is charged separately from the main tariff helps to…

Q: For the Circut shown: WL₁=652 V(t): 50+ 40 SinW+ + 20 Sin 2w+[ I Find the active Power Quct Puct)…

Q: is connected. Determine Foil current and output of transfor

A: Transformer is a static device. It works on the principle of electromagnetic induction. Based on…

Q: For static (time-independent) fields, which of the following current densities are possible? (a) J =…

Q: Q5: Solve the DE: y + y + y = 1, y(0) = 1, y(0) = 3 using Laplace Transform.

A: In this question, We need to determine the signal y(t) using the Laplace transform?. Initial…

Q: Calculate the lower and upper cut of frequencies

A: Operational amplifier- An integrated circuit which amplifies weak electric signals into a strong…

Q: Q3) Suppose that x(t) is real-valued signal, then show that: . c) if x(t) = x(-t) (even symmetery)…

A: By using the concept of real valued signal and even symmetry we need to derive the fourier series…

Q: Please help: A certain company contains three balanced three-phase loads. Each of the loads is…

A: Line current: Current is the time rate of the change of the charges. In delta connected load the…

Q: (b) A power transistor working in cl battery. If the maximum collector transferred to a 5 2…

A: Max. collector current change ∆Ic=100 mAMax. collector-emitter voltage change VCE=12 VLoudspeaker…

Q: Prove dx(t)/dt________Laplace_ _sX(s)

A: Laplace transform is used to analyze the continous time domain signal into s domain or frequency…

Q: Q2:- An electrodynamometer type wattmeter has a current coil with resistance 0.202 and a pressure…

A: Given, Current coil resistance, Rc = 0.2 ohm Pressure coil resistance, Rp = 7 kohm Load current,…

Q: Q1: Answer two of the following questions: a)For the circuit shown in fig.(1), v = 120e-sor V and i…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: What is the correct notation for a load factor? a) Ω b) ∞ c) ∑ d) ⅄

Q: Draw a diagram for astable multivibrator using 555 timer. Find the oscillation frequency of the…

Q: 21for the below system, draw Nyquist plot (draw to scale) then find gain margin and phase margin. 1…

A: The nyquist plot is linear plot used to analyse the stability of the given system.

Q: Find Laplace transform of the function shown below:- 07

A: In this question, We need to determine the Laplace transform of the given signals. We know…

Q: Q2: Answer two of the following questions: a) For the circuit shown in fig.(2), v = 10e V and i=…

A: Note : Since all the above mentioned questions are not interlinked to each other hence we need to…

Q: A three phase Y/Y transformer delivers a load of 66 MW at 0.8 p.f. lagging and 138 KV (line to…

Q: Q3. Find the total resistance of the network in Figure below 6Ω RT C U6, Μ 06: οπτι 9 Ω 6Ω 6Ω

A: We need to find out equivalent resistance for given circuit

Q: In the below given figure, two capacitances are in series with a 18V source. The capacitance of the…

A: When two capacitance connected in series then charge flowing through capacitor remain same but…

Q: Given G= 20a, + 50a, + 40a,. at (1, x/2, x/6) the component of G perpendicular to surface-x/2 is (a)…

A: Types of coordinates system to analyze vector quantity Cartesian coordinate system Cylindrical…

Q: The circuit shown in Figure Q3 has a DC source. For time t<0 Vin has been at 01 V DC for a long…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Q4:- find Ic, R₁, VE, VB 018 V 3.6 k 4.730 lc -V-12V 1.2 km

A: given here BJT npn transistor based circuit and asked to find Ic , R1 , VE , VB .

Q: Draw the logic circuit represented by each of the following expre- • AB + AB ● AB(CD + EF)

A: In this question we will draw logic circuit represented by given expressions....

Q: Q1: Answer two of the following questions: a) For the circuit shown in fig.(1), R v = 10e V and i =…

Q: Q5 (a) A fluid level control system includes a tank, a level sensor, a fluid source, and an actuator…

A: A closed loop system is the electrical and mechanical device it is a automatically control the…

Q: 1. A wye-connected load with ZA= 12 /45, ZB= 15 / 30 and Zc= 10 /0 is connected to a four-wire, 208…

Q: (C)-Draw the mechanical characteristic of shunt and series DC motors. dienas SKINVER

A: Graph are provided,x and y axes are labelled with typical notations.

Q: A circuit consisting of capacitor in series with a resistance. of 10 ohms is connected in parallel…

A: By using the concept of resonanceZmax=R i.e. only resistive component must be present

Q: Determine the value of Vx using nodal analysis.

A: The required parameters can be calculated by using the kirchhoff's current law to the nodes we will…

Q: Determine the attenuation of a fifth order Chebyshev filter at w=2w, provided by a Butterworth…

A: Chebyshev filter This kind of filter use for distinct frequencies of one to another band. Their…

Q: Question 3 Figure below shows how a single wire can be used to carry measurement data at the same…

A: Given Figure below shows how a single wire can be used to carry measurement data at the same time.…

Q: Find the total current outward directed from a two meter cube with center at the origin and edges…

A: Gauss divergence theorem is used for converting a complex integral of flux into a triple integral…

Q: Q3. In/a three-phase full-bridge inverter circuit, the de voltageV = 250V, the amplitude modulation…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: What will be the stored energy in the 0.2F capacitor for a voltage of 5V across it?

A: Given, Capacitance, C = 0.2 F Voltage, V = 5 V

Question

4.4 A boost-regulator has an input voltage of 5 V and
the average output voltage of 15 V. The duty cycle
is
(a) 3/2
(b) 2/3
(c) 5/2
(d) 15/2
4.9
(a
(

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Draw and explain in own words the circuit diagram for improved seriest voltage regulator
design a Zener regulator to meet these specifications; load voltage is 6.8V, source voltage is 20V, and load current is 30mA
If the no-load output voltage of a regulator is 24.8V and the full-load output is 23.9V, what is the load regulation expressed as a percentage?
What is the approximate value of the collector voltage in the given figure below for each of these troubles? d) RC open e) Collector-emitter open
Difine the diodd and explain it’s basing conditions
14 - Which of the following is IC / IB (the ratio of collector current to base current) in a transistor?A) Dielectric coefficientB) Conversion rateC) Beta current gainD) Alpha current gainE) The conductivity coefficient
series regulator a. Calculate Rs, R, & RL, b) find the values of output voltage (Vout), Current flowing through Resistor R, Voltage across Rs, Voltage across resistor R, current flowing through the collector (Iz), and Current flowing through zener diode.
One of the following is not a property of a common-emitter amplifier: Select one: a. high voltage gain b. No phase inversion c. high current gain d. Emitter is at ac ground
Sketch and explain the output for the circuit of given parameters. The generator signal is a sine wave with a 10V peak. The diode is germanium and has a forward resistance rf of 25 ohms. (Using Third Diode Approximation)
ma=Acmax-Acmin/Acmax+Acmin for the modulated signal (AM) ,ma = 0.25;Calculate Acmax, Acmin and efficiency value.
1. Collector Current at saturation 29uA 3mA 5.87mA 2.9mA 2. VCE at the cut-off 10V 16V 8V 15V 3. Q-pt=? (16V, 3mA) (8V, 2.9mA) (10V, 29uA) (15V, 3mA)
8.17c Copper extension leads are installed as shown in Figure 8.48b. For an output voltage of 7.947 mV and a reference junction temperature of 0⁰C, what is the temperature of the measuring junction?